Estimating Density Reduction and Phonon Localization From Optical Thermal Conductivity Measurements of Porous Silica and Aerogel Thin Films

Author(s):  
Patrick E. Hopkins ◽  
Bryan J. Kaehr ◽  
Darren Dunphy ◽  
C. Jeffrey Brinker

In this work, we measure the thermal conductivity of mesoporous silica and aerogel thin-films using a non-destructive optical technique: time domain thermoreflectance (TDTR). Due to the rough surfaces of the optically transparent silica-based films, we evaporate an Al film on a glass cover slide and fabricate the silica structures directly on the Al film, providing a “probe-through-the-glass” configuration for TDTR measurements. This allows the thermal conductivity of mesoporous silica and aerogel thin films to be measured with traditional TDTR analyses. As the thermoreflectance response is highly dependent on the thermal effusivity of the porous structures, we estimate the density of the films by varying the heat capacity in our analysis. This density determination assumes that the solid matrix in the silica structure has the thermal conductivity as bulk SiO2, which is valid if all the lattice vibrations are localized, consistent with the minimum thermal conductivity concept. We independently determine the density of the porous silica films with nitrogen sorption measurements of thin films using a surface acoustic wave (SAW) technique. The difference between the determined from the SAW technique and that estimated by the TDTR effusivity analysis lends insight into the relative contributions of localized and propagating modes to thermal transport.

2009 ◽  
Vol 106 (3) ◽  
pp. 034910 ◽  
Author(s):  
Thomas Coquil ◽  
Erik K. Richman ◽  
Neal J. Hutchinson ◽  
Sarah H. Tolbert ◽  
Laurent Pilon

2020 ◽  
Vol 11 (9) ◽  
pp. 3731-3737 ◽  
Author(s):  
Yan Yan ◽  
Man Li ◽  
Sophia King ◽  
Tiphaine Galy ◽  
Michal Marszewski ◽  
...  

2009 ◽  
Vol 42 (12) ◽  
pp. 125404 ◽  
Author(s):  
Sangwoo Shin ◽  
Tae-Jung Ha ◽  
Hyung-Ho Park ◽  
Hyung Hee Cho

Author(s):  
Thomas Coquil ◽  
Neal Hutchinson ◽  
Laurent Pilon ◽  
Erik Richman ◽  
Sarah Tolbert

This paper reports the cross-plane thermal conductivity of highly ordered cubic and hexagonal templated mesoporous amorphous silica thin films synthesized by evaporation-induced self-assembly process. Cubic and hexagonal films featured spherical and cylindrical pores and average porosity of 25% and 45%, respectively. The pore diameter ranged from 3 to 18 nm and film thickness from 80 to 540 nm while the average wall thickness varied from 3 to 12 nm. The thermal conductivity was measured at room temperature using the 3ω method. The experimental setup and the associated analysis were validated by comparing the thermal conductivity measurements with data reported in the literature for the silicon substrate and for high quality thermal oxide thin films with thickness ranging from 100 to 500 nm. The cross-plane thermal conductivity of the synthesized mesoporous silica thin films does not show strong dependence on pore size, wall thickness, or film thickness. This is due to the fact that heat is mainly carried by very localized non propagating vibrational modes. The average thermal conductivity for the cubic mesoporous silica films was 0.30 ± 0.02 W/mK, while it was 0.20 ± 0.01 W/mK for the hexagonal films. This corresponds to a reduction of 79% and 86% from bulk fused silica at room temperature.


2019 ◽  
Vol 123 (35) ◽  
pp. 21721-21730 ◽  
Author(s):  
Yan Yan ◽  
Sophia C. King ◽  
Man Li ◽  
Tiphaine Galy ◽  
Michal Marszewski ◽  
...  

2006 ◽  
Vol 961 ◽  
Author(s):  
Jason Manning ◽  
Roger Campbell ◽  
Martin Gerard Bakker ◽  
Xuefa Li ◽  
Dong Ryeol Lee ◽  
...  

ABSTRACTThe development of periodic nanostructures fabricated by self-assembly of surfactants and block co-polymers has opened up the possibility of generating periodic magnetic nanostructures of types not accessible by self-assembly of nano-particles. The fabrication of mesoporous silica thin films around self-assembled block co-polymers is well established. Common structures for such films are SBA-15 which consists of hexagonal arrays of cylindrical pores and SBA-16 which has face centered arrays of spherical voids. These pores are connected by 1-2 nm thick flaws in the continuous silica phase producing an effectively continuous porous phase. After removal of the block co-polymer template, electrodeposition into the mesoporous silica thin films produces arrays of 5-10 nm diameter nano-wires and nano-particles. We have demonstrated that such materials can be fabricated on a wide range of metal substrates. Characterization by Scanning Electron Microscopies shows that the mesoporous silica is well ordered over micron scale areas. Grazing Incidence Small Angle X-ray Scattering (GISAXS) studies shows diffraction spots, consistent with the entire film being well ordered. GISAXS also shows that the mesoporous silica films survive removal of the template and electrodeposition of nickel and cobalt into the mesoporous silica films. Such films are of interest for their magnetic properties, as the nanophase and scale can be independently varied. Further, the presence of nanowires inside an insulator suggests that these films might also be of interest as the current confining element for Confined Current Path-Current Perpendicular to Plane GMR sensors.


Author(s):  
Kamal M. Katika ◽  
Laurent Pilon

This study is concerned with the prediction of the effective thermal conductivity of nanocomposite thin films consisting of nanoparticles randomly distributed in a solid matrix. Crystalline sodium chloride with embedded monodisperse silver nanoparticles is investigated as a case study for thin films where phonons are the main heat carriers. To the best of our knowledge, the equation for phonon radiative transfer is solved for the first time with an exact scattering transport cross-section of the nanoparticles as a function of frequency which was obtained from the literature. The one-dimensional equation for phonon radiative transfer based on the isotropic scaling approximation is solved on a spectral basis using the discrete ordinates method to predict the temperature profile and the heat flux across the nanocomposite thin films. The thermal conductivity is retrieved at temperatures where the effects of Umklapp and Normal processes can be neglected and scattering by the particles on phonon transport dominates. The method of solution and closure laws were validated with experimental data of thermal conductivity for bulk samples at 2.53, 5.94, and 10.56 K. The effects of the film thickness (1 μm to 2.5 cm), nanoparticle diameter (5 nm to 100 nm) and volume fraction (0.0001 to 0.2) on the thermal conductivity of the nanocomposite thin film are investigated. The results indicate that the thermal conductivity decreases with decreasing particle radius as well as with increasing particle concentration. Finally, a dimensionless analysis revealed a power law relationship between the dimensionless thermal conductivity and a dimensionless length of the order of the acoustic thickness of the medium. These results can be used to design nanocomposite thin films for various low temperature thermal applications by choosing optimal nanoparticle radius and volume fraction, and film thickness.


2001 ◽  
Vol 707 ◽  
Author(s):  
Sophie Besson ◽  
Thierry Gacoin ◽  
Catherine Jacquiod ◽  
Christian Ricolleau ◽  
Jean-Pierre Boilot

ABSTRACTCdS nanoparticles were grown inside a 3D hexagonal porous silica film. The film pore size and organization allowed the perfect control of particle repartition and size (3.5 nm), leading to a 3D nanocrystal array inside the silica matrix. The method was extended to another silica porous structure with larger pores, which allowed to obtain larger particles (5.8 nm). This process was then successfully generalized to other metal sulfides.


2012 ◽  
Vol 37 (9) ◽  
pp. 1406 ◽  
Author(s):  
Fangting Chi ◽  
Lianghong Yan ◽  
Hongwei Yan ◽  
Bo Jiang ◽  
Haibing Lv ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document