Numerical Analysis of Pressure Fluctuation in Circulating Water Pump Using CFD

2012 ◽  
Author(s):  
Cui Dai ◽  
Fan-Yu Kong ◽  
Liang Dong
Keyword(s):  
Flow Field ◽  
Pressure Fluctuation ◽  
Pressure Fluctuations ◽  
Three Dimensional ◽  
Primary Source ◽  
Domain Analysis ◽  
Frequency Domain Analysis ◽  
Flow State ◽  
Virtual Sensors ◽  
Rotor Stator Interaction

Pressure fluctuations acting on centrifugal pump contain a lot of dynamic information, such as rotor-stator interaction, vortex, backflow, and so on. By CFD method, calculations of three-dimensional unsteady flow in the suction chamber, impeller, annular chamber, inlet and outlet were conducted with sliding mesh technology. For the simulation of inner flow field, a commercial code Fluent had been used to predict the pulsating pressures. The shear stress transport turbulence model (SST k-ω) was confirmed through comparison with the hydraulic performance experiment. The change of static pressure was recorded by means of virtual sensors placed at the impeller-annular chamber interface and the tongue. And the pulsating pressures in the impeller passage were recorded to reflect its flow state. Then, amplitude domain analysis and frequency domain analysis were conducted to process those fluctuating pressure signals obtained under different opening conditions. The results indicate that the effect of rotor-stator interaction and vortexes to pressure fluctuations in flow field is obvious. The pressure fluctuation around impeller-chamber interface and tongue is affected by the interaction between blade and tongue definitely, and the various positions of the blade relative to the tongue lead to different trends of variation of pressure distribution. The primary source of pressure fluctuation in the impeller passage is associated with vortexes.

Pressure and Flow Rate Fluctuations in Single- and Two-Blade Pumps

2020 ◽  
Vol 143 (1) ◽  
Author(s):  
Andreas Pesch ◽  
Steffen Melzer ◽  
Stephan Schepeler ◽  
Tobias Kalkkuhl ◽  
Romuald Skoda
Keyword(s):  
Flow Rate ◽  
Pressure Fluctuation ◽  
Pressure Fluctuations ◽  
Three Dimensional ◽  
Electromagnetic Flowmeter ◽  
Flow Region ◽  
Mean Values ◽  
Wall Pressure Fluctuations ◽  
Simulation Results ◽  
Blade Pump

Abstract A comparative study on the highly unsteady flow field in single- and two-blade pumps is performed. Stationary pump characteristics, as well as pressure and flow rate fluctuations, are presented. Wall pressure fluctuations were measured in the suction and pressure pipe as well as at several locations within the volute casing by piezoresistive transducers. Flow rate fluctuations were evaluated by a recently presented measurement system based on an electromagnetic flowmeter (Melzer et al. 2020, “A System for Time-Fluctuating Flow Rate Measurements in a Single-Blade Pump Circuit,” Flow Meas. Instrum., 71, p. 101675). Measurements were accompanied by three-dimensional (3D) flow simulations with the open-source cfd software foam-extend. A thorough grid study and validation of the simulation were performed. By a complementary analysis of measurement and simulation results, distinctive differences between both pump types were observed, e.g., flow rate and pressure fluctuation magnitudes are significantly higher in the single-blade pump. In relation to the respective mean values, flow rate fluctuation magnitudes are one order lower than pressure fluctuation magnitudes for both pumps. For the two-blade pump, fluctuations attenuate toward overload irrespective of the particular pump circuit, while they rise for the single-blade pump. 3D simulation results yield detailed insight into the spatially and temporally resolved impeller–volute interaction and reveal that the single-blade impeller pushes a high-pressure flow region forward in a way as a positive displacement pump, resulting in an inherently fluctuating velocity and pressure distribution within the volute.

Three-Dimensional Time-Resolved Flow Field in the First and Last Turbine Stage of a Heavy Duty Gas Turbine: Part II — Interpretation of Blade Pressure Fluctuations

2000 ◽  
Author(s):  
Martin von Hoyningen-Huene ◽  
Wolfram Frank ◽  
Alexander R. Jung
Keyword(s):  
Flow Field ◽  
Gas Turbine ◽  
Gas Turbines ◽  
Pressure Fluctuations ◽  
Three Dimensional ◽  
Potential Interaction ◽  
Heavy Duty ◽  
Turbine Stage ◽  
Count Ratio ◽  
Heavy Duty Gas Turbine

Unsteady stator-rotor interaction in gas turbines has been investigated experimentally and numerically for some years now. Most investigations determine the pressure fluctuations in the flow field as well as on the blades. So far, little attention has been paid to a detailed analysis of the blade pressure fluctuations. For further progress in turbine design, however, it is mandatory to better understand the underlying mechanisms. Therefore, computed space–time maps of static pressure are presented on both the stator vanes and the rotor blades for two test cases, viz the first and the last turbine stage of a modern heavy duty gas turbine. These pressure fluctuation charts are used to explain the interaction of potential interaction, wake-blade interaction, deterministic pressure fluctuations, and acoustic waveswith the instantaneous surface pressure on vanes and blades. Part I of this two-part paper refers to the same computations, focusing on the unsteady secondary now field in these stages. The investigations have been performed with the flow solver ITSM3D which allows for efficient simulations that simulate the real blade count ratio. Accounting for the true blade count ratio is essential to obtain the correct frequencies and amplitudes of the fluctuations.

Three-Dimensional Separated Flow Field in the Endwall Region of an Annular Compressor Cascade in the Presence of Rotor-Stator Interaction: Part I — Quasi-Steady Flow Field and Comparison With Steady-State Data

1989 ◽  
Author(s):  
H. D. Schulz ◽  
H. E. Gallus ◽  
B. Lakshminarayana
Keyword(s):  
Flow Field ◽  
Separation Bubble ◽  
Three Dimensional ◽  
Separated Flow ◽  
Major Influence ◽  
Compressor Cascade ◽  
Three Dimensional Flow ◽  
Dimensional Flow ◽  
Corner Flow ◽  
Rotor Stator Interaction

An experimental study of three-dimensional flow field in an annular compressor cascade with an upstream rotor has been carried out at four different incidences to the stator blade. Blade boundary layers and the three-dimensional flow field at the exit are surveyed using a hot wire sensor and a five hole probe, respectively. The data on the blade boundary layer, passage flow and separated corner flow is presented. The upstream rotor wake has a major influence on the transition, laminar separation bubble, extent of wall/corner flow separation, aerodynamic losses, secondary flow and three-dimensional flow inside the passage. Detailed interpretation of the effects of upstream wakes on the entire passage flow is presented and compared with the data in the absence of a rotor.

Investigation of Fan Rotor Interaction With Pressure Disturbance Produced by Downstream Pylon

2013 ◽  
Author(s):  
Tomonori Enoki ◽  
Hidekazu Kodama ◽  
Shinya Kusuda
Keyword(s):  
Flow Field ◽  
Three Dimensional ◽  
Numerical Results ◽  
Rotor Blades ◽  
Flow Structures ◽  
Coupled Analysis ◽  
Unsteady Forces ◽  
Rotor Stator Interaction ◽  
The Impact ◽  
Potential Pressure

This paper presents an investigation of fan rotor interaction with potential pressure disturbances produced by a downstream pylon. Three-dimensional unsteady viscous analyses are performed for two fan rotor-stator-pylon configurations with different axial gaps between the stator and the pylon, and compared with the experimental results. To clarify the impact of the rotor-pylon interaction on the potential pressure flow field, a numerical analysis for the configuration in which a fan rotor is removed is also performed and compared with the numerical results with fan rotor. Actuator disk analyses are also performed to interpret the flow structures observed in the experiments and the numerical results. It is found that a fan rotor-stator interaction also exists in the fan flow field, and this may impact on the upstream propagating potential flow that dominates the unsteady forces acting on the rotor blades. A coupled analysis between fan rotor and stator is essential to accurately predict the unsteady blade force.

scholarly journals Analysis of Unsteady Pressure Fluctuation in a Semi-Open Cutting Pump

Energies ◽  
2020 ◽  
Vol 13 (14) ◽  
pp. 3657
Author(s):  
Weidong Cao ◽  
Jiayu Mao ◽  
Wei Li
Keyword(s):  
Flow Rate ◽  
Pressure Fluctuation ◽  
Pressure Fluctuations ◽  
Three Dimensional ◽  
Flow Characteristics ◽  
Internal Flow ◽  
Lower Plate ◽  
Pressure Distributions ◽  
Axial Forces ◽  
Blade Frequency

In order to understand the pressure fluctuation characteristics of a semi-open cutting pump, the three-dimensional unsteady flow fields were calculated. External and internal flow characteristics of four schemes with different relative angles between the rotary cutter and the impeller were studied. The pressure fluctuations in the lower plate, the upper plate, the clearance between the rotary cutter and the fixed cutter, the first section in volute and nearby parts of the tongue were all analyzed, which are all the places that pressure distributions are greatly affected by the static and dynamic interaction, and at the same time, the force on the impeller was also analyzed. The results show that the fluctuations at different positions change periodically; the main frequency is blade frequency. The amplitude of pressure fluctuation decreases from near the rotating part to far away, from near the tongue to far from the tongue. Due to the influence of both impeller and rotary cutter, the pressure fluctuation on the lower plate is the largest. The pressure fluctuation is affected by flow rate, the larger the flow rate, the greater the pressure fluctuation. The radial and axial forces of the impeller change periodically with time, and the number of wave peaks and wave valleys is the same as the number of blades.

scholarly journals Numerical Investigation of Periodically Unsteady Pressure Field in a High Power Centrifugal Diffuser Pump

2014 ◽  
Vol 6 ◽  
pp. 159380 ◽  
Author(s):  
Ji Pei ◽  
Wenjie Wang ◽  
Shouqi Yuan ◽  
Jieyun Mao
Keyword(s):  
Pressure Fluctuation ◽  
Pressure Fluctuations ◽  
Heat Removal ◽  
Centrifugal Pumps ◽  
Unsteady Pressure ◽  
Fluctuation Intensity ◽  
Rotor Stator Interaction ◽  
Operational Flow ◽  
Downstream Flow ◽  
Pressure Characteristics

Pressure fluctuations are the main factors that can give rise to reliability problems in centrifugal pumps. The periodically unsteady pressure characteristics caused by rotor-stator interaction have been investigated by CFD calculation in a residual heat removal pump. Side chamber flow effect is also considered for the simulation to accurately predict the flow in whole flow passage. The pressure fluctuation results in time and frequency domains were considered for several typical monitoring points in impeller and diffuser channels. In addition, the pressure fluctuation intensity coefficient (PFIC) based on standard deviation was defined on each grid node for entire space and impeller revolution period. The results show that strong pressure fluctuation intensity can be found in the gap between impeller and diffuser. As a source, the fluctuation can spread to the upstream and downstream flow channels as well as the side chamber channels. Meanwhile, strong pressure fluctuation intensity can be found in the discharge tube of the circular casing. In addition, the obvious influence of operational flow rate on the PFIC distribution can be found. The analysis indicates that the pressure fluctuations in the aspects of both frequency and intensity can be used to comprehensively evaluate the unsteady pressure characteristics in centrifugal pumps.

scholarly journals Numerical Investigation of Pressure Fluctuation Characteristics in a Centrifugal Pump with Variable Axial Clearance

2016 ◽  
Vol 2016 ◽  
pp. 1-11 ◽  
Author(s):  
Lei Cao ◽  
Zhengwei Wang ◽  
Yexiang Xiao ◽  
Yongyao Luo
Keyword(s):  
Centrifugal Pump ◽  
Pressure Fluctuation ◽  
Pressure Fluctuations ◽  
Maximum Pressure ◽  
Centrifugal Pumps ◽  
Pressure Surface ◽  
Clearance Flow ◽  
Rotor Stator Interaction ◽  
Entire Flow ◽  
Axial Clearance

Clearance flows in the sidewall gaps of centrifugal pumps are unsteady as well as main flows in the volute casing and impeller, which may cause vibration and noise, and the corresponding pressure fluctuations are related to the axial clearance size. In this paper, unsteady numerical simulations were conducted to predict the unsteady flows within the entire flow passage of a centrifugal pump operating in the design condition. Pressure fluctuation characteristics in the volute casing, impeller, and sidewall gaps were investigated with three axial clearance sizes. Results show that an axial clearance variation affects the pressure fluctuation characteristics in each flow domain by different degree. The greatest pressure fluctuation occurs at the blade pressure surface and is almost not influenced by the axial clearance variation which has a certainly effect on the pressure fluctuation characteristics around the tongue. The maximum pressure fluctuation amplitude in the sidewall gaps is larger than that in the volute casing, and different spectrum characteristics show up in the three models due to the interaction between the clearance flow and the main flow as well as the rotor-stator interaction. Therefore, clearance flow should be taken into consideration in the hydraulic design of centrifugal pumps.

Sign in / Sign up

Export Citation Format

Share Document