Low-frequency acoustic scattering by a cube: Experimental measurements and theoretical predictions

1997 ◽  
Vol 101 (5) ◽  
pp. 2571-2582 ◽  
Author(s):  
Paul A. Chinnery ◽  
Victor F. Humphrey ◽  
Jingdong Zhang
Keyword(s):  
Acoustic Scattering ◽  
Low Frequency ◽  
Experimental Measurements ◽  
Theoretical Predictions

scholarly journals Optical Analysis of Ball Bearing Starvation

1971 ◽  
Vol 93 (3) ◽  
pp. 349-361 ◽  
Author(s):  
L. D. Wedeven ◽  
D. Evans ◽  
A. Cameron
Keyword(s):  
Film Thickness ◽  
Ball Bearing ◽  
Point Contact ◽  
Experimental Measurements ◽  
Line Contact ◽  
Optical Analysis ◽  
Grease Lubrication ◽  
Theoretical Predictions ◽  
Pressure Stress ◽  
Starvation Conditions

Elastohydrodynamic oil film measurements for rolling point contact under starvation conditions are obtained using optical interferometry. The experimental measurements present a reasonably clear picture of the starvation phenomenon and are shown to agree with theoretical predictions. Starvation inhibits the generation of pressure and, therefore, reduces film thickness. It also causes the overall pressure, stress, and elastic deformation to become more Hertzian. Additional experiments using interferometry illustrate: the cavitation pattern, lubricant entrapment, grease lubrication, ball spin, and edge effects in line contact.

scholarly journals Water Level Sensing in a Steel Vessel Using A0 and Quasi-Scholte Waves

2017 ◽  
Vol 2017 ◽  
pp. 1-11 ◽  
Author(s):  
Peng Guo ◽  
Bo Deng ◽  
Xiang Lan ◽  
Kaili Zhang ◽  
Hongyuan Li ◽  
...  
Keyword(s):  
Water Level ◽  
Guided Waves ◽  
Mode Conversion ◽  
Experimental Studies ◽  
Low Frequency ◽  
Steel Vessel ◽  
Theoretical Predictions ◽  
Travelling Time ◽  
The Comparative Study ◽  
Group Velocities

This paper presents a water level sensing method using guided waves of A0 and quasi-Scholte modes. Theoretical, numerical, and experimental studies are performed to investigate the properties of both the A0 and quasi-Scholte modes. The comparative study of dispersion curves reveals that the plate with one side in water supports a quasi-Scholte mode besides Lamb modes. In addition, group velocities of A0 and quasi-Scholte modes are different. It is also found that the low-frequency A0 mode propagating in a free plate can convert to the quasi-Scholte mode when the plate has one side in water. Based on the velocity difference and mode conversion, a water level sensing method is developed. For the proof of concept, a laboratory experiment using a pitch-catch configuration with two piezoelectric transducers is designed for sensing water level in a steel vessel. The experimental results show that the travelling time between the two transducers linearly increases with the increase of water level and agree well with the theoretical predictions.

Vibration Characteristics of Metamaterial Beams With Periodic Local Resonances

2014 ◽  
Vol 136 (6) ◽  
Author(s):  
M. Nouh ◽  
O. Aldraihem ◽  
A. Baz
Keyword(s):  
Band Gap ◽  
Low Frequency ◽  
Element Model ◽  
Small Mass ◽  
Vibration Characteristics ◽  
Structural Vibrations ◽  
Low Frequencies ◽  
Theoretical Predictions ◽  
Gap Characteristics ◽  
Unique Band

Vibration characteristics of metamaterial beams manufactured of assemblies of periodic cells with built-in local resonances are presented. Each cell consists of a base structure provided with cavities filled by a viscoelastic membrane that supports a small mass to form a source of local resonance. This class of metamaterial structures exhibits unique band gap behavior extending to very low-frequency ranges. A finite element model (FEM) is developed to predict the modal, frequency response, and band gap characteristics of different configurations of the metamaterial beams. The model is exercised to demonstrate the band gap and mechanical filtering capabilities of this class of metamaterial beams. The predictions of the FEM are validated experimentally when the beams are subjected to excitations ranging between 10 and 5000 Hz. It is observed that there is excellent agreement between the theoretical predictions and the experimental results for plain beams, beams with cavities, and beams with cavities provided with local resonant sources. The obtained results emphasize the potential of the metamaterial beams for providing significant vibration attenuation and exhibiting band gaps extending to low frequencies. Such characteristics indicate that metamaterial beams are more effective in attenuating and filtering low-frequency structural vibrations than plain periodic beams of similar size and weight.

Predicting Thermal Mixing and Fatigue Inside Control Rod Guide Tubes

2013 ◽  
Author(s):  
Eric Lillberg
Keyword(s):  
Thermal Fatigue ◽  
Turbulent Mixing ◽  
Low Frequency ◽  
Experimental Measurements ◽  
Guide Tube ◽  
Control Rod ◽  
Thermal Mixing ◽  
Purge Flow ◽  
Control Rods ◽  
Good Agreement

The cracked control rods shafts found in two Swedish NPPs were subjected to thermal fatigue due to mixing of cold purge flow with hot bypass water in the upper part of the top tube on which the control rod guide tubes rests. The interaction between the jets formed at the bypass water inlets is the main source of oscillation resulting in low frequency downward motion of hot bypass water into the cold purge flow. This ultimately causes thermal fatigue in the control rod shaft in the region below the four lower bypass water inlets. The transient analyses shown in this report were done to further investigate this oscillating phenomenon and compare to experimental measurements of water temperatures inside the control rod guide tube. The simulated results show good agreement with experimental data regarding all important variables for the estimation of thermal fatigue such as peak-to-peak temperature range, frequency of oscillation and duration of the temperature peaks. The results presented in this report show that CFD using LES methodology and the open source toolbox OpenFOAM is a viable tool for predicting complex turbulent mixing flows and thermal loads.

scholarly journals Signal-to-noise ratio in the membrane potential of the owl's auditory coincidence detectors

2012 ◽  
Vol 108 (10) ◽  
pp. 2837-2845 ◽  
Author(s):  
Go Ashida ◽  
Kazuo Funabiki ◽  
Paula T. Kuokkanen ◽  
Richard Kempter ◽  
Catherine E. Carr
Keyword(s):  
Neural Circuit ◽  
Signal To Noise Ratio ◽  
Phase Locking ◽  
Low Frequency ◽  
Membrane Potentials ◽  
Signal To Noise ◽  
Theoretical Predictions ◽  
Noise Ratio ◽  
Band Limited

Owls use interaural time differences (ITDs) to locate a sound source. They compute ITD in a specialized neural circuit that consists of axonal delay lines from the cochlear nucleus magnocellularis (NM) and coincidence detectors in the nucleus laminaris (NL). Recent physiological recordings have shown that tonal stimuli induce oscillatory membrane potentials in NL neurons (Funabiki K, Ashida G, Konishi M. J Neurosci 31: 15245–15256, 2011). The amplitude of these oscillations varies with ITD and is strongly correlated to the firing rate. The oscillation, termed the sound analog potential, has the same frequency as the stimulus tone and is presumed to originate from phase-locked synaptic inputs from NM fibers. To investigate how these oscillatory membrane potentials are generated, we applied recently developed signal-to-noise ratio (SNR) analysis techniques (Kuokkanen PT, Wagner H, Ashida G, Carr CE, Kempter R. J Neurophysiol 104: 2274–2290, 2010) to the intracellular waveforms obtained in vivo. Our theoretical prediction of the band-limited SNRs agreed with experimental data for mid- to high-frequency (>2 kHz) NL neurons. For low-frequency (≤2 kHz) NL neurons, however, measured SNRs were lower than theoretical predictions. These results suggest that the number of independent NM fibers converging onto each NL neuron and/or the population-averaged degree of phase-locking of the NM fibers could be significantly smaller in the low-frequency NL region than estimated for higher best-frequency NL.

scholarly journals The Effect of Attenuation from Fish on Passive Detection of Sound Sources in Ocean Waveguide Environments

2021 ◽  
Vol 13 (21) ◽  
pp. 4369
Author(s):  
Daniel Duane ◽  
Chenyang Zhu ◽  
Felix Piavsky ◽  
Olav Rune Godø ◽  
Nicholas C. Makris
Keyword(s):  
Remote Sensing ◽  
Propagation Path ◽  
Experimental Measurements ◽  
Sound Sources ◽  
Detection Range ◽  
Acoustic Waveguide ◽  
Passive Sensing ◽  
Surface Vessels ◽  
Theoretical Predictions ◽  
Radiated Sound

Attenuation from fish can reduce the intensity of acoustic signals and significantly decrease detection range for long-range passive sensing of manmade vehicles, geophysical phenomena, and vocalizing marine life. The effect of attenuation from herring shoals on the Passive Ocean Acoustic Waveguide Remote Sensing (POAWRS) of surface vessels is investigated here, where concurrent wide-area active Ocean Acoustic Waveguide Remote Sensing (OAWRS) is used to confirm that herring shoals occluding the propagation path are responsible for measured reductions in ship radiated sound and corresponding detection losses. Reductions in the intensity of ship-radiated sound are predicted using a formulation for acoustic attenuation through inhomogeneities in an ocean waveguide that has been previously shown to be consistent with experimental measurements of attenuation from fish in active OAWRS transmissions. The predictions of the waveguide attenuation formulation are in agreement with measured reductions from attenuation, where the position, size, and population density of the fish groups are characterized using OAWRS imagery as well as in situ echosounder measurements of the specific shoals occluding the propagation path. Experimental measurements of attenuation presented here confirm previous theoretical predictions that common heuristic formulations employing free space scattering assumptions can be in significant error. Waveguide scattering and propagation theory is found to be necessary for accurate predictions.

scholarly journals Bioinspired aerofoil adaptations: the next steps for theoretical models

2019 ◽  
Vol 377 (2159) ◽  
pp. 20190070 ◽  
Author(s):  
Lorna J. Ayton
Keyword(s):  
Experimental Data ◽  
Theoretical Models ◽  
Theoretical Modelling ◽  
Experimental Measurements ◽  
Far Field ◽  
Acoustic Analogy ◽  
Trailing Edge ◽  
Trailing Edge Noise ◽  
Theoretical Predictions ◽  
Field Noise

The extended introduction in this paper reviews the theoretical modelling of leading- and trailing-edge noise, various bioinspired aerofoil adaptations to both the leading and trailing edges of blades, and how these adaptations aid in the reduction of aerofoil–turbulence interaction noise. Attention is given to the agreement between current theoretical predictions and experimental measurements, in particular, for turbulent interactions at the trailing edge of an aerofoil. Where there is a poor agreement between theoretical models and experimental data the features neglected from the theoretical models are discussed. Notably, it is known that theoretical predictions for porous trailing-edge adaptations do not agree well with experimental measurements. Previous works propose the reason for this: theoretical models do not account for surface roughness due to the porous material and thus omit a key noise source. The remainder of this paper, therefore, presents an analytical model, based upon the acoustic analogy, to predict the far-field noise due to a rough surface at the trailing edge of an aerofoil. Unlike previous roughness noise models which focus on roughness over an infinite wall, the model presented here includes diffraction by a sharp edge. The new results are seen to be in better agreement with experimental data than previous models which neglect diffraction by an edge. This new model could then be used to improve theoretical predictions for far-field noise generated by turbulent interactions with a (rough) porous trailing edge. This article is part of the theme issue ‘Frontiers of aeroacoustics research: theory, computation and experiment’.

Sign in / Sign up

Export Citation Format

Share Document