A NOTE ON THE DETECTION OF UNDERSEA CRAFT BY MEANS OF LOW FREQUENCY RADIATION FROM AIRCRAFT

1945 ◽  
Vol 23a (6) ◽  
pp. 77-85
Author(s):  
D. W. R. McKinley
Keyword(s):  
Field Strength ◽  
General Expression ◽  
Low Frequency ◽  
Factors Affecting ◽  
Shore Station ◽  
Chief Factors ◽  
Frequency Radiation

A semiquantitative examination is made of the chief factors affecting both the transmission of low frequency radiation from an aircraft to a submarine and the return of this energy to the aircraft by scattering. A general expression is derived for the returning field strength and graphs are shown for a representative set of conditions. It is indicated that, even under the most favourable conditions, the amount of energy returned is below the level of detectability, if the submarine is submerged more than 10 ft. However, it is also pointed out that communication between a shore station and an undersea craft should be feasible under certain conditions.

THE ENERGY EFFICIENCY TECHNIQUE OF THERMAL PROCESSING OF GRAIN

2019 ◽  
pp. 176-182
Author(s):  
А. Zykov ◽  
S. Orlova ◽  
L. Ovsiannykova
Keyword(s):  
Energy Efficiency ◽  
Thermal Processing ◽  
Microwave Field ◽  
Low Frequency ◽  
Heat Pipes ◽  
Biologically Active ◽  
Microwave Drying ◽  
Post Harvest ◽  
Combined Action ◽  
Frequency Radiation

The methods of energy efficiency increasing of pre- and post-harvest thermal processing of grain are considered. The effective ways to deliver energy to the grain using heat pipes and microwave field are given. The effect of combined action of microwave and low-frequency radiation on the grain germination is shown. Currently, the intensification of technological processes under the influence of microwave radiation is used in many industrial processes. Microwave equipment is becoming a necessary technological component of large profitable industries. The process of drying is no exception. In recent years, new versions of dryers have been proposed that use combined methods of energy supply, including microwave energy. Microwave dryers for foodstuffs, grains and oilseeds, including those for seed stock, have been created and are beginning to be used, along with drying and disinfection, disinfection of drying products from harmful bacteria, fungi, and mildew. For the implementation of microwave drying of particular importance is the choice of regime parameters of drying, given the fact that the grain is a biologically active object. Microwave drying allows you to provide a powerful flow of energy to the object of drying and to obtain a significant intensification of moisture evaporation. But at the same time there is also an intense heating of the product, which can degrade its quality. The possibility of supplying energy throughout the cross section of the product allows for the evaporation of moisture from the inner layers of the product, which is especially important at the end of drying, when the zone of evaporation of moisture is significantly deeper. Therefore, the highest drying efficiency can be obtained in combined processes that take advantage of various drying methods, such as convective, as well as the use of microwave and low-frequency magnetic fields. The paper presents effective ways to supply energy to the grain using heat pipes and a microwave field. The effect of the combined action of microwave and low-frequency radiation on grain similarity is shown. Ways to improve the energy efficiency of the processes of preseeding and post-harvest heat treatment of grain are considered.

scholarly journals Variation of Low-Frequency Time-Code Signal Field Strength during the Annular Solar Eclipse on 21 June 2020: Observation and Analysis

Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1216
Author(s):  
Xin Wang ◽  
Bo Li ◽  
Fan Zhao ◽  
Xinyu Luo ◽  
Luxi Huang ◽  
...  
Keyword(s):  
Field Strength ◽  
Solar Eclipse ◽  
Low Frequency ◽  
Signal Propagation ◽  
Normal Operation ◽  
Time Code ◽  
Long Distance ◽  
Time Service ◽  
Annular Solar Eclipse ◽  
Signal Field

Due to the occlusion of the moon, an annular solar eclipse will have an effect on the ionosphere above the earth. The change of the ionosphere, for the low-frequency time-code signal that relies on it as a reflection medium for long-distance propagation, the signal field strength, and other parameters will also produce corresponding changes, which will affect the normal operation of the low-frequency time-code time service system. This paper selects the solar eclipse that occurred in China on 21 June 2020, and uses the existing measurement equipment to carry out experimental research on the low-frequency time-code signal. We measured and analyzed the signal field strength from 20 June 2020 to 23 June 2020, and combined solar activity data, ionospheric data, and geomagnetic data, and attempted to explore the reasons and rules of the change of signal parameters. The results showed that the field strength of the low-frequency time-code signal changed dramatically within a short time period, the max growth value can reach up to 17 dBμV/m and the variation trend yielded ‘three mutations’. This change in signal field strength is probably due to the occurrence of a solar eclipse that has an effect on the ionosphere. When the signal propagation conditions change, the signal strength will also change accordingly.

Domesday Woodland in Southwest England

Antiquity ◽  
1936 ◽  
Vol 10 (39) ◽  
pp. 306-324 ◽  
Author(s):  
F. W. Morgan
Keyword(s):  
Eleventh Century ◽  
Historical Geography ◽  
Fundamental Importance ◽  
Factors Affecting ◽  
Present Essay ◽  
Gradual Disappearance ◽  
Valuable Element ◽  
Domesday Book ◽  
Chief Factors ◽  
Surface Geology

The distribution of woodland and the stages of its gradual disappearance were of fundamental importance in the early historical geography of England. Wood was a valuable element in medieval economy and one of the chief factors affecting the nature of settlement, The evidence concerning the extent of the woodland in early England is of two kinds : (1) the surface geology, which provides a basis for the reconstruction of the original extent ; (2) the statistics of the Domesday Book: these refer to the eleventh century, but they may have some retrospective value. The present essay is an attempt to examine the Domesday evidence for the south and south-western counties of Berkshire, Hampshire, Wiltshire, Dorset, Somerset, Devon and Cornwall.

Donor-acceptor complexes formed by perfluoro-organo bromides and iodides with nitrogenous and other bases. II. Band shapes and widths in the absorption spectrum of gaseous CF3I-N(CH3)3

1971 ◽  
Vol 24 (12) ◽  
pp. 2493 ◽  
Author(s):  
A Mishra ◽  
ADE Pullin
Keyword(s):  
Vibrational Mode ◽  
Low Frequency ◽  
Molecular Complexes ◽  
Wave Number ◽  
Centrifugal Distortion ◽  
Band Shape ◽  
Gaseous Mixtures ◽  
Factors Affecting ◽  
Donor Acceptor ◽  
Vibration Rotation

The absorption band centred at c. 77 cm-1 in gaseous mixtures of CF3I and N(CH3)3 previously reported and attributed to the N-I stretching mode of the complex CF3I-N(CH3)3 has been carefully re-examined. This band is of interest as an example of a low frequency ?dissociative type? vibrational mode of a weak molecular complex. The band is asymmetric and apparently structureless with a half intensity width at room temperature of 28-30 cm-1. The width of the band may be accounted for as arising from transitions vi + vi+1 where vi is the vibrational quantum number of the N-I stretching mode with vi up to c. 10 making appreciable contribution to the intensity on the low wave-number side. Centrifugal distortion in the complex is considered. Centrifugal stretching and consequent weakening of the bond may shift the band envelope 2-3 cm-1 to lower wave numbers. Assessment of these and other factors affecting the band shape suggest that the fundamental frequency is probably c. 90 cm-1. The band shape of the vibrational mode of the complex at c. 272 cm-1 is briefly discussed. Many of the considerations presented in this paper should apply to vibration-rotation band shapes in other weak molecular complexes. Some general consequences of anharmonicity for the interpretation of the spectra of weak molecular complexes are discussed.

scholarly journals Tailoring Adsorption Induced Switchability of a Pillared Layer MOF by Crystal Size Engineering

2020 ◽  
Author(s):  
Leila Abylgazina ◽  
Irena Senkovska ◽  
Sebastian Ehrling ◽  
Volodymyr Bon ◽  
Petko Petkov ◽  
...  
Keyword(s):  
Particle Size ◽  
Low Frequency ◽  
Polar Molecules ◽  
Adsorption Enthalpy ◽  
Factors Affecting ◽  
University Of Technology ◽  
Order Of Magnitude ◽  
Crystal Structural ◽  
Critical Particle Size ◽  
Characteristic Adsorption

The pillared layer framework DUT-8(Zn) (Zn<sub>2</sub>(2,6-ndc)<sub>2</sub>(dabco), 2,6-ndc = 2,6-naphthalenedicarboxylate, dabco = 1,4-diazabicyclo-[2.2.2]-octane, DUT = Dresden University of Technology) is a prototypical switchable MOF, showing characteristic adsorption and desorption induced open phase (<i>op</i>) to closed phase (<i>cp</i>) transformation associated with huge changes in cell volume. We demonstrate switchability strongly depends on a framework-specific critical particle size (d<i><sub>crit</sub></i>). The solvent removal process (pore desolvation stress contracting the framework) significantly controls the <i>cp</i>/<i>op</i> ratio after desolvation and, subsequently, the adsorption induced switchability characteristics of the system. After desolvation, the dense <i>cp</i> phase of DUT-8(Zn) shows no adsorption-induced reopening and therefore is non-porous for N<sub>2</sub> at 77 K and CO<sub>2</sub> at 195 K. However, polar molecules with a higher adsorption enthalpy, such as the polar molecules such as chloromethane at 249 K and dichloromethane (DCM) at 298 K can reopen the macro-sized crystals upon adsorption. For macro-sized particles, the outer surface energy is negligible and only the type of metal (Zn, Co, Ni) controls the DCM-induced gate opening pressure. The framework stiffness increases from Zn to Ni as confirmed by DFT calculations, X-ray crystal structural analyses, and low frequency Raman spectroscopy. The partial disintegration of the Zn based node hinges produces an overall increased stabilization of<i> cp </i>vs. <i>op</i> phase shifts the critical particle size at which switchability starts to become suppressed to even lower values (d<i><sub>crit</sub></i> < 200 nm) as compared to the Ni-based system (<i>d<sub>crit</sub></i> ≈ 500 nm). Hence, the three factors affecting switchability (energetics of the empty host, (<i>E<sub>op</sub>-E<sub>cp</sub></i>) (I), particle size (II), and desolvation stress (III)) appear to be of the same order of magnitude and should be considered collectively, not individually.

Sign in / Sign up

Export Citation Format

Share Document