LIGHT-SCATTERING STUDIES OF SODIUM THYMONUCLEATE

1950 ◽  
Vol 28b (3) ◽  
pp. 96-104 ◽  
Author(s):  
D. B. Smith ◽  
H. Sheffer

The scattering of light by aqueous solutions of three different samples of sodium thymonucleate has been investigated. It was found that one sample in water consisted of randomly coiled molecules of molecular weight greater than 24 × 106. A second sample gave a less viscous solution in water and was only partially coiled, the coiling of the molecules being increased by the addition of a small amount of sodium chloride. In dilute salt solution the molecular weights of all three samples were greater than 3.7 × 106. Two samples of nucleate were degraded in solution by irradiation with ultraviolet light in the presence of hydrogen peroxide. In both cases the nucleate was converted into material consisting of rodlike molecules, 2400 Å in length and having a molecular weight of 750,000.

2015 ◽  
Vol 11 (8) ◽  
pp. 3866-3872
Author(s):  
E.A. Masimov ◽  
Etibar Hummat Ismailov ◽  
S.Y. Odzhaqverdiyeva

Dynamic light scattering (DLS) method in combination with the UV/VIS spectrophotometry is used to study the interaction of polyethylene- glycols with a molecular weight  6000 ( PEG6000 ) with sodium salts of citric and succinic acids in aqueous solutions. The values of density, viscosity, refractive and diffusion indexes, the values of the hydrodynamic diameter, wavelength electronic absorption bands for PEG6000 aqueous solutions, their mixtures with succinic and citric acids are determined. It was shown that depending on the composition of the solutions the values of hydrodynamic diameter for aqueous solutions containing 1-5 wt.% PEG6000 and their mixtures with succinic and citric acids (~ 1 wt%) ranges from 3.6 to 5.2 nm. It is assumed that the formation of complexes with the sizes  that are within the above range is due to the features of interaction  and the structure of the complexes formed in solution.


Biochemistry ◽  
1971 ◽  
Vol 10 (17) ◽  
pp. 3222-3229 ◽  
Author(s):  
Chien Ho ◽  
Ingrid B. E. Noren ◽  
Edward F. Casassa

1987 ◽  
Vol 52 (5) ◽  
pp. 1235-1245 ◽  
Author(s):  
Petr Štěpánek ◽  
Zdeněk Tuzar ◽  
Čestmír Koňák

The response of quasielastic light scattering to the polydispersity of scattering objects has been investigated. A new method of the polydispersity index determination has been suggested, suitable for the range 1.02 ⪬ Mw/Mn ⪬ 2.0 and consisting in the measurement of the dependence of the apparent decay time on the correlator sampling time. The polydispersity index can be determined by comparing these dependences with the theoretical ones obtained using correlation curves simulated for various values of the polydispersity index, assuming lognormal and Schulz-Zimm distributions of molecular weights. The test measurements on polystyrene standards having molecular weights in the range 9 103 – 20.6 106 give polydispersity index values Mw/Mn that are in a good agreement with those given by the manufacturer. The polydispersity index for polystyrene having the molecular weight Mw = 20.6 106 thus determined was Mw/Mn = 1.35.


1963 ◽  
Vol 36 (2) ◽  
pp. 488-501
Author(s):  
W. Cooper ◽  
D. E. Eaves ◽  
G. Vaughan

Abstract Linear polybutadienes, prepared with butyl lithium as catalyst, and polybutadienes branched by exposure to γ-radiation have been fractionated and the fractions examined by osmometry and light scattering. Turbidimetric second virial coefficients (A2τ) of mixed polymer fractions are virtually the same as those of the higher molecular weight components of the mixtures for most compositions. This is true both for mixtures of linear with linear and linear with branched polymer. The higher the molecular weight of the fraction, the greater the effect; the addition of 1 per cent microgel to a linear polymer reduced A2τ by a factor of three. The presence of microgel or high molecular weight branched polymer has been shown to be responsible for the very high molecular weights previously reported for polybutadienes from light scattering measurements. It is conveniently removed by shaking the solutions with calcium sulfate. Second virial coefficients obtained either by light scattering or osmometry are, within the limits of experimental error, uninfluenced by branching in the polymer. In general those factors which lead to increased branching also result in increased polydispersity, and it is the latter which results in the decrease in A2τ. The fall of the osmotic second virial coefficient (A2τ) with molecular weight is much smaller than would be calculated theoretically, and the fall in A2τ is greater than would be expected, notwithstanding the fact that for some of the fractions Mw/Mn<1.1. This indicates that A2τ is sensitive to the low molecular weight species present in the fractions, whereas the reverse must apply to A2τ. Natural or synthetic trans-polyisoprene showed analogous behavior to polybutadiene, although, owing to experimental difficulties, sharp branched fractions could not be obtained. The following viscosity-molecular weight relationships were obtained in benzene solution: [η]=1.45×10−4M0.76 for butyl lithium-catalyzed polybutadienes, and [η]=4.37×10−4M0.65 for natural and synthetic trans-polyisoprenes.


1958 ◽  
Vol 36 (1) ◽  
pp. 937-949 ◽  
Author(s):  
K. J. Turner ◽  
W. H. Cook

Ether extraction removes 80% of the floating fraction of egg yolk from its solution in 2.5% sodium chloride. On removal of the ether and dialysis against specific solvents two thirds of the remaining lipoprotein (40% lipid) precipitates, leaving a soluble fraction containing 50% lipid. The soluble and insoluble portions probably represent different levels of degradation rather than different lipoproteins since both materials are apparently derived by ether extraction from a natural entity of much higher lipid content. The soluble fraction is heterogeneous and has mean molecular weights of M w = 5.4 × 105by light-scattering methods, and M n = 3.4 × 105by osmotic pressure. A "light" fraction obtained by centrifuging and representing 38% of the soluble material had M w = 3.4 to 3.5 × 105. Heterogeneity in lipid content appears to be responsible for the low molecular weight (M w = 2.4 × 105) obtained by sedimentation.


1994 ◽  
Vol 16 (9) ◽  
pp. 1515-1522 ◽  
Author(s):  
E. López-Cabarcos ◽  
P. A. Galera-Gómez

2017 ◽  
Vol 68 (10) ◽  
pp. 2385-2388
Author(s):  
Raoul Vasile Lupusoru ◽  
Laurentiu Simion ◽  
Ion Sandu ◽  
Daniela Angelica Pricop ◽  
Aurica Chiriac ◽  
...  

We studied the way in which stability and physicochemical properties of gold (Au) nanoparticles (NP) coated with chitosan are influenced by the molecular weight of chitosan and Au precursor concentration when samples are subjected to aging. Pharmaceutical use of AuNPs coated with chitosan is closely related to stability and physicochemical properties in relation to storage conditions and processing. For this purpose, series of AuNPs of different sizes were prepared by aqueous chemical reduction method using chitosan with various molecular weights as template. The physicochemical properties and stability at room temperature of AuNPs in aqueous solutions of chitosan have been investigated by following the temporal evolution of surface plasmon absorbance, Zeta potential, average dimension, and Au-chitosan interaction, after synthesis and through a period of 24 months. In our experiment, during the observed aging period, the AuNPs coated with chitosan presented a better colloidal stability, while using chitosan with medium molecular weight and medium concentration of Au precursor.


2007 ◽  
Vol 1019 ◽  
Author(s):  
Dania Alyounes ◽  
Christopher Yengo ◽  
Tim Doran ◽  
Qi Lu ◽  
Kenneth Gonsalves

AbstractPluronic® polymers were screened for binding affinity to oligoribonucleotides (ORN) using fluorescence techniques. F127 (Mw 12600 g/mole) proved to have the strongest binding affinity. Urethane linkages were introduced into F127 and two other Pluronics, F38 (Mw 4700 g/mole) and F77 (Mw 6600 g/mole) to prepare polymers that were multiples of their respective initial molecular weights. A series of these polyurethane Pluronics were screened for binding affinity. Fluorescence studies showed a relationship between the molecular weight of the PO units and the binding affinity in the structures of the newly synthesized polyPluronics, especially in the case of F77. Light scattering confirmed the binding affinity between the ORN and F77 polymers. Particle size analysis showed an exponential increase until the critical micelle concentration. Other analogs of these polymers also studied for their binding affinity were poly(ester amines) and PINC.


Sign in / Sign up

Export Citation Format

Share Document