Rapid Preparation of CuInS2Bulk Polycrystals by Two-Step Microwave Heating Process Using a Domestic Microwave Oven

2005 ◽  
Vol 44 (No. 27) ◽  
pp. L866-L868 ◽  
Author(s):  
Masami Susaki
2008 ◽  
Vol 55 (2) ◽  
pp. 85-89 ◽  
Author(s):  
Yusuke Okano ◽  
Toshiki Nakamura ◽  
Yoshitaka Inou ◽  
Tomohiro Ando ◽  
Kentaro Ohhashi

1997 ◽  
Vol 36 (Part 2, No. 10A) ◽  
pp. L1291-L1293 ◽  
Author(s):  
Masatsune Kato ◽  
Kenji Sakakibara ◽  
Yoji Koike

2018 ◽  
Vol 39 (4) ◽  
pp. 37
Author(s):  
Ulisses Magalhães Nascimento ◽  
Antonio Carlos Sales Vasconcelos ◽  
Eduardo Bessa Azevedo ◽  
Fernando Carvalho Silva

Reactions under microwave heating present reduced reaction times and larger yields. Therefore, this work is aimed at adapting a domestic microwave oven and optimizing the transesterification reaction used in biodiesel production with microwave heating, using babaçu coconut oil as raw material. It was used a central composite design for varying irradiation time, KOH concentration, and oil:methanol ratio. Statistical analyses were performed in orderto assess the significance of the model used. The optimized experimental conditions were: oil:methanol ratio, 8.59; KOH concentration, 2.19 %; and irradiation time, 70 seconds, givingan yield of approximately 100% regarding esters formation.


1999 ◽  
Vol 38 (Part 1, No. 10) ◽  
pp. 5867-5868 ◽  
Author(s):  
Masatsune Kato ◽  
Kenji Sakakibara ◽  
Yoji Koike

1998 ◽  
Vol 76 (5) ◽  
pp. 525-532 ◽  
Author(s):  
R N Gedye ◽  
J B Wei

Several different reactions have been studied to determine whether they occur more rapidly than conventionally heated reactions at atmospheric pressure. Small rate enhancements have been observed for some reactions carried out under microwave reflux in a modified domestic microwave oven. The Knoevenagel reaction of acetophenone with ethyl cyanoacetate was shown to have a rate enhancement of 2.5 times. However this reaction showed no rate increase over conventional heating, at the same temperature, in a variable-frequency microwave oven. It is therefore probable that the small rate enhancements observed in these experiments, using microwave heating, were due to hot spots or superheating of the solvent rather than to nonthermal effects.Key words: microwave, nonthermal effects, superheating, hot spots.


2017 ◽  
Vol 66 (6) ◽  
pp. 408-412
Author(s):  
Toshiki NAKAMURA ◽  
Yoshitaka INOU ◽  
Norio MUTO ◽  
Kentaro OHHASHI ◽  
Atsushi NAKAHIRA

2013 ◽  
Vol 58 (3) ◽  
pp. 919-922 ◽  
Author(s):  
K. Granat ◽  
B. Opyd ◽  
D. Nowak ◽  
M. Stachowicz ◽  
G. Jaworski

Abstract The paper describes preliminary examinations on establishing usefulness criteria of foundry tooling materials in the microwave heating technology. Presented are measurement results of permittivity and loss tangent that determine behaviour of the materials in electromagnetic field. The measurements were carried-out in a waveguide resonant cavity that permits precise determination the above-mentioned parameters by perturbation technique. Examined were five different materials designed for use in foundry tooling. Determined was the loss factor that permits evaluating usefulness of materials in microwave heating technology. It was demonstrated that the selected plastics meet the basic criterion that is transparency for electromagnetic radiation.


2018 ◽  
Vol 15 (1) ◽  
pp. 47-55
Author(s):  
Xuebing Li ◽  
Haifen Yang ◽  
Ning Wang ◽  
Tijian Sun ◽  
Wei Bian ◽  
...  

Background: Morin has many pharmacological functions including antioxidant, anticancer, anti-inflammatory, and antibacterial effects. It is commonly used in the treatment of antiviral infection, gastropathy, coronary heart disease and hepatitis B in clinic. However, researches have shown that morin is likely to show prooxidative effects on the cells when the amount of treatment is at high dose, leading to the decrease of intracellular ATP levels and the increase of necrosis process. Therefore, it is necessary to determine the concentration of morin in biologic samples. Method: Novel water-soluble and green nitrogen and sulfur co-doped carbon dots (NSCDs) were prepared by a microwave heating process with citric acid and L-cysteine. The fluorescence spectra were collected at an excitation wavelength of 350 nm when solutions of NSCDs were mixed with various concentrations of morin. Results: The as-prepared NSCDs were characterized by transmission electron microscopy, X-ray diffraction and X-ray photoelectron spectroscopy. The fluorescence intensity of NSCDs decreased significantly with the increase of morin concentration. The fluorescence intensity of NSCDs displayed a linear response to morin in the concentration 0.10-30 μM with a low detection limit of 56 nM. The proposed fluorescent probe was applied to analysis of morin in human body fluids with recoveries of 98.0-102%. Conclusion: NSCDs were prepared by a microwave heating process. The present analytical method is sensitive to morin. The quenching process between NSCDs and morin is attributed to the static quenching. In addition, the cellular toxicity on HeLa cells indicated that the as-prepared NSCDs fluorescent probe does not show obvious cytotoxicity in cell imaging. Our proposed method possibly opens up a rapid and nontoxic way for preparing heteroatom doped carbon dots with a broad application prospect.


Sign in / Sign up

Export Citation Format

Share Document