Abstract 1122‐000015: Differences of Morphological and Hemodynamic Rupture Risk Factors in Cerebral Aneurysms Between Pre‐ and Post‐Rupture

Author(s):  
Yuma Yamanaka ◽  
Hiroyuki Takao ◽  
Soichiro Fujimura ◽  
Yuya Uchiyama ◽  
Shota Sunami ◽  
...  

Introduction : Morphological and hemodynamic characteristics have been reported to be involved in the rupture of cerebral aneurysms. Therefore, geometrical measurements of cerebral aneurysms and blood flow analysis using computational fluid dynamics (CFD) have been conducted. Some previous studies investigated the rupture risk factors from cerebral arterial geometries that were taken before the rupture (pre‐rupture), and the others used geometries taken after the rupture (post‐rupture). However, aneurysm rupture may alter arterial geometries and CFD simulation results. The aim of this study is to evaluate the morphological and hemodynamic alternations due to cerebral aneurysm rupture. Methods : We identified 21 cerebral aneurysms (ICA: 9, MCA: 3, ACA: 4, BA: 3, VA: 2) which had ruptured during the follow‐up terms. Each case had at longest two‐years term between the rupture date and the latest angiographic date before the aneurysm rupture (pre‐rupture). The post‐rupture arterial geometries were acquired preoperatively for subarachnoid hemorrhage. We used the arterial geometries reconstructed from computed tomography angiography or digital subtraction angiography images for conducting morphological measurements and CFD simulations. We performed transient blood flow simulations for two heart pulse cycles in the CFD simulations. We obtained five morphological parameters and 24 hemodynamic parameters considered as the rupture risk factors. Finally, we conducted Wilcoxon’s signed‐rank sum test between the parameters obtained from pre‐ and post‐rupture aneurysms to specify altered parameters due to the aneurysm rupture. We also calculated the change rate (CR) based on the value in pre‐rupture for parameters that had a statistical significance to investigate the alternation in detail. Results : The aneurysmal volume ( V ), height ( H ), aspect ratio ( AR ), and spatial averaged, maximum, and minimum wall shear stress of the aneurysm dome normalized by the spatially averaged wall shear stress of the parent vessel ( NWSSave , NWSSmax , and NWSSmin ) were significantly altered between pre‐ and post‐rupture. In particular, the morphological parameters increased after the rupture (average CR of V , H , and AR were 25.8 %, 13.4 %, and 15.9 %, respectively). These results indicate that the aneurysm shapes tended to increase lengthwise after the rupture. On the other hand, the NWSS tended to decrease (average CR of NWSSave , NWSSmax , and NWSSmin  were ‐21.0 %, ‐13.7 %, and ‐22.7 %, respectively). These results imply that the aneurysm rupture altered the aneurysm to a more complicated shape, and thereby the blood flow became stagnated that introduced lower WSS . In contrast, there were some cases in which NWSS increased, and these cases had vasospasm at their parent arteries caused by the rupture (i.e., 5 of 21 cases had vasospasm, and the average CR of NWSSave was 14.1 %). The parent vessel proximal to the aneurysm was shrunk due to the vasospasm, resulting in increased flow velocity and thus increased NWSS . Conclusions : The cerebral aneurysm rupture deformed the aneurysms into longitudinal and led to increased volumes. The NWSSs in CFD simulations using post‐rupture geometries tended to decrease in comparison with pre‐rupture. When studying rupture factors of cerebral aneurysms using geometrical measurements and CFD simulations, special attention should be paid to the clinical image and rupture characteristics standardization criteria.

2018 ◽  
Vol 18 (05) ◽  
pp. 1850055
Author(s):  
ALFREDO ARANDA ◽  
ALVARO VALENCIA

CFD simulations were performed for 60 human cerebral aneurysms (30 previously ruptured and 30 previously unruptured) to study the behavior of the time-averaged wall shear stress (TAWSS) with respect to the aspect ratio (AR), implementing a set of low, normal, and high-pressure differences between the inlet and the outlets of each artery. It is well known that there exists a direct relationship between TAWSS and the rupture. In this investigation, we presented an important result because the condition of the pressure among the branches and the AR may be measured in any patient, then a slope may be associated, and finally a TAWSS may be estimated. We found that when the pressure difference increased, the absolute slopes between TAWSS and AR increased as well. Also, the magnitude of the slope in the previously unruptured aneurysms was 4.7 times the slope in the previously ruptured aneurysms. On the other hand, TAWSS was higher in the previously unruptured aneurysm than previously ruptured aneurysms due to the unruptured aneurysms that have a smaller surface area. Furthermore, we analyzed the relationship between TAWSS and other geometric parameters of the aneurysm, such as bottleneck and non-sphericity index; however, no correlation was found for either cases.


2018 ◽  
Vol 128 (3) ◽  
pp. 723-730 ◽  
Author(s):  
Sherif Rashad ◽  
Shin-ichiro Sugiyama ◽  
Kuniyasu Niizuma ◽  
Kenichi Sato ◽  
Hidenori Endo ◽  
...  

OBJECTIVERisk factors for aneurysm rupture have been extensively studied, with several factors showing significant correlations with rupture status. Several studies have shown that aneurysm shape and hemodynamics change after rupture. In the present study the authors investigated a static factor, the bifurcation angle, which does not change after rupture, to understand its effect on aneurysm rupture risk and hemodynamics.METHODSA hospital database was retrospectively reviewed to identify patients with cerebral aneurysms treated surgically or endovascularly in the period between 2008 and 2015. After acquiring 3D rotational angiographic data, 3D stereolithography models were created and computational fluid dynamic analysis was performed using commercially available software. Patient data (age and sex), morphometric factors (aneurysm volume and maximum height, aspect ratio, bifurcation angle, bottleneck ratio, and neck/parent artery ratio), and hemodynamic factors (inflow coefficient and wall shear stress) were statistically compared between ruptured and unruptured groups.RESULTSSeventy-one basilar tip aneurysms were included in this study, 22 ruptured and 49 unruptured. Univariate analysis showed aspect ratio, bifurcation angle, bottleneck ratio, and inflow coefficient were significantly correlated with a ruptured status. Logistic regression analysis showed that aspect ratio and bifurcation angle were significant predictors of a ruptured status. Bifurcation angle was inversely correlated with inflow coefficient (p < 0.0005), which in turn correlated directly with mean (p = 0.028) and maximum (p = 0.014) wall shear stress (WSS) using Pearson's correlation coefficient, whereas aspect ratio was inversely correlated with mean (0.012) and minimum (p = 0.018) WSS.CONCLUSIONSBifurcation angle and aspect ratio are independent predictors for aneurysm rupture. Bifurcation angle, which does not change after rupture, is correlated with hemodynamic factors including inflow coefficient and WSS, as well as rupture status. Aneurysms with the hands-up bifurcation configuration are more prone to rupture than aneurysms with other bifurcation configurations.


2020 ◽  
Vol 132 (4) ◽  
pp. 1116-1122 ◽  
Author(s):  
Tomoaki Suzuki ◽  
Christopher J. Stapleton ◽  
Matthew J. Koch ◽  
Kazutoshi Tanaka ◽  
Soichiro Fujimura ◽  
...  

OBJECTIVEDegenerative cerebral aneurysm walls are associated with aneurysm rupture and subarachnoid hemorrhage. Thin-walled regions (TWRs) represent fragile areas that may eventually lead to aneurysm rupture. Previous computational fluid dynamics (CFD) studies reported the correlation of maximum pressure (Pmax) areas and TWRs; however, the correlation with aneurysm rupture has not been established. This study aims to investigate this hemodynamic correlation.METHODSThe aneurysmal wall surface at the Pmax areas was intraoperatively evaluated using a fluid flow formula under pulsatile blood flow conditions in 23 patients with 23 saccular middle cerebral artery (MCA) bifurcation aneurysms (16 unruptured and 7 ruptured). The pressure difference (Pd) at the Pmax areas was calculated by subtracting the average pressure (Pave) from the Pmax and normalized by dividing this by the dynamic pressure at the aneurysm inlet side. The wall shear stress (WSS) was also calculated at the Pmax areas, aneurysm dome, and parent artery. These hemodynamic parameters were used to validate the correlation with TWRs in unruptured MCA aneurysms. The characteristic hemodynamic parameters at the rupture points in ruptured MCA aneurysms were then determined.RESULTSIn 13 of 16 unruptured aneurysms (81.2%), Pmax areas were identified that corresponded to TWRs. In 5 of the 7 ruptured cerebral aneurysms, the Pmax areas coincided with the rupture point. At these areas, the Pd values were not higher than those of the TWRs in unruptured cerebral aneurysms; however, minimum WSS, time-averaged WSS, and normalized WSS at the rupture point were significantly lower than those of the TWRs in unruptured aneurysms (p < 0.01).CONCLUSIONSAt the Pmax area of TWRs, decreased WSS appears to be the crucial hemodynamic parameter that indicates the risk of aneurysm rupture.


Neurosurgery ◽  
2010 ◽  
Vol 67 (6) ◽  
pp. 1692-1702 ◽  
Author(s):  
Clemens M Schirmer ◽  
Adel M Malek

Abstract BACKGROUND: Although coiling of intracranial aneurysms is thought to rely on obstruction of blood flow into the aneurysm and induction of intra-aneurysmal thrombosis, little data exist regarding the effect of coil deployment on hemodynamics. OBJECTIVE: To evaluate the effects of simulated coiling of a model aneurysm on flow and wall shear stress in the dome and neck regions using computational fluid dynamic analysis. METHODS: A spherical sidewall aneurysm on a curved parent vessel underwent simulated embolization with 1 or more computer-designed helical coils. The coils' axes had parallel, orthogonal, or transverse orientation with respect to blood flow. Pulsatile laminar flow computational fluid dynamic analysis was performed on high-resolution conformal meshes of the aneurysm-coil complex using realistic non-Newtonian blood viscosity. RESULTS: Intra-aneurysmal flow and energy flux into the dome were significantly reduced by coil insertion, with little effect on pressure distribution. Coiling increased viscosity in the distal dome with progressive spread toward the neck with greater coil packing. Coiling also decreased wall shear stress and its gradient both in the inflow zone and the downstream parent vessel. These alterations were dependent on coil orientation, with effectiveness rank order of parallel &gt; transverse &gt; orthogonal. CONCLUSION: We successfully modeled the hemodynamic effects of aneurysm coil embolization and uncovered a framing coil orientation dependence of dome and parent vessel hemodynamics. In addition to suggesting a pathophysiological link among coil configuration, protection from rupture, and aneurysm regrowth, these results pave the way for the analysis of aneurysm-coil complex interactions on a patient lesion-specific basis.


2014 ◽  
Vol 6 ◽  
pp. 908357 ◽  
Author(s):  
Jianjun Li ◽  
Shengzhang Wang ◽  
Gang Lu ◽  
Xiaolong Zhang

It is a general agreement that hemodynamics plays very important role in the initiation, growth, and rupture of cerebral aneurysms and hemodynamics in the anterior communicating artery aneurysms is considered the most complex in all cerebral aneurysms and it is difficult to find some reasonable relationship between the hemodynamics parameters and the rupture risk. In this paper, the 3D geometries of four anterior communicating artery aneurysms were generated from the CTA data and the computational models with bilateral feeding arteries for the four aneurysms were constructed. The blood flow was simulated by computational fluid dynamics software and the hemodynamics parameters such as velocity, wall shear stress, and oscillatory shear index were calculated. The following results were observed: one of the four models only needs the left feeding artery; the max normalized wall shear stress locates at the aneurysmal neck of the largest aneurysm; the max oscillatory shear index locates at the aneurysmal sac of the largest aneurysm. The conclusion was drawn that the anterior communicating artery aneurysm has higher rupture risk from the hemodynamics viewpoint if the max wall shear stress locates at the neck and the max oscillatory shear index locates at the dome.


2020 ◽  
Vol 59 (SK) ◽  
pp. SKKE16 ◽  
Author(s):  
Ryo Nagaoka ◽  
Kazuma Ishikawa ◽  
Michiya Mozumi ◽  
Magnus Cinthio ◽  
Hideyuki Hasegawa

Sign in / Sign up

Export Citation Format

Share Document