Effect of moisture on asphalt mastic tensile properties at ambient temperature

2014 ◽  
pp. 379-388
Keyword(s):  
Ambient Temperature ◽  
Tensile Properties ◽  
Asphalt Mastic ◽  
Effect Of Moisture

Effects of Neutron Irradiation on Tensile Properties of V-Ti-Cr-Si Type Alloys with Pre-Existing Helium

1998 ◽  
Vol 540 ◽  
Author(s):  
M. Satou ◽  
T. Chuto ◽  
H. Koide ◽  
A. Hasegawa ◽  
K. Abe
Keyword(s):  
Low Temperature ◽  
Ambient Temperature ◽  
Tensile Properties ◽  
Yield Stress ◽  
Neutron Irradiation ◽  
Uniform Elongation ◽  
Temperature Range ◽  
Temperature Irradiation ◽  
Helium Implantation ◽  
Lower Temperature

AbstractHelium effect on loss of uniform elongation after low-temperature neutron irradiation of the V-Ti-Cr-Si-Al-Y alloy was studied. Helium implantation to about 30 atomic ppm was carried out before neutron irradiation to 50 dpa at 406°C. The yield stress of the irradiated specimen with helium pre-implantation was slightly smaller than that of irradiated specimens without helium. The uniform elongation and the increase in yield stress of the irradiated specimens were not affected by helium pre-implantation at ambient temperature. It might be possible that the helium effect appears after lower temperature irradiation such as 300°C or lower, which corresponds to the temperature range where the loss of uniform elongation of the alloy is particularly pronounced.

Effect of Sand Moisture Content on Diesel Oil Volatilization

2011 ◽  
Vol 282-283 ◽  
pp. 47-50
Author(s):  
Xue Dong Feng ◽  
Yan Fei Ma
Keyword(s):  
Weight Loss ◽  
Moisture Content ◽  
Ambient Temperature ◽  
Water Content ◽  
Diesel Oil ◽  
Linear Rate ◽  
Moisture Contents ◽  
Sand Surface ◽  
Effect Of Moisture

Volatilization of diesel oil in sand columns was conducted at the ambient temperature of 20 °C by spilling oil on the sand surface. The weight loss of oil was determined by pre and post weight of the sand columns and desiccant was measured on an electronic balance. The aim of this paper was to investigate the effect of moisture content on the volatilization of diesel oil in sand. The results show that the diesel oil and water in sand both volatilize at a linear rate with respect to time. The largest volatilization mass of diesel oil and water reach when the moisture contents are 8% and 20% respectively. Appropriate water content can help to pull the oil contaminants to the surface of the sand.

Effects of Different Sr Additions on As Cast Microstructure and Tensile Properties of AS31 Alloy

2014 ◽  
Vol 788 ◽  
pp. 110-114 ◽  
Author(s):  
Ji Xue Zhou ◽  
Dong Qing Zhao ◽  
Jin Wei Wang ◽  
Shou Qiu Tang ◽  
Wei Hong Li
Keyword(s):  
Grain Size ◽  
Tensile Strength ◽  
Elevated Temperature ◽  
Magnesium Alloy ◽  
Ambient Temperature ◽  
Tensile Properties ◽  
Mass Fraction ◽  
Chinese Script ◽  
Polyhedral Shape ◽  
Cast Microstructure

Effects of different Sr additions (0.1%-1%Sr, mass fraction) on as-cast microstructure and tensile properties both at ambient temperature and elevated temperature of AS31 magnesium alloy were studied. The experimental results show that the addition of Sr could refine the grain size obviously and modify the eutectic Mg2Si from Chinese script shape to polyhedral shape or fine fibers shape. The addition of Sr to AS31 alloy improved the tensile strength at ambient temperature, and the ultimate strength at 150°C first decrease and then increase with the Sr addition increase from 0.1% to 1%Sr.

Sign in / Sign up

Export Citation Format

Share Document