scholarly journals Fischer-344Tp53-knockout rats exhibit a high rate of bone and brain neoplasia with frequent metastasis

2016 ◽  
Vol 9 (10) ◽  
pp. 1139-1146 ◽  
Author(s):  
Sarah A. Hansen ◽  
Marcia L. Hart ◽  
Susheel Busi ◽  
Taybor Parker ◽  
Angela Goerndt ◽  
...  
Keyword(s):  
Author(s):  
L. E. Murr ◽  
G. Wong

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.


Author(s):  
A. Elgsaeter ◽  
T. Espevik ◽  
G. Kopstad

The importance of a high rate of temperature decrease (“rapid freezing”) when freezing specimens for freeze-etching has long been recognized1. The two basic methods for achieving rapid freezing are: 1) dropping the specimen onto a metal surface at low temperature, 2) bringing the specimen instantaneously into thermal contact with a liquid at low temperature and subsequently maintaining a high relative velocity between the liquid and the specimen. Over the last couple of years the first method has received strong renewed interest, particularily as the result of a series of important studies by Heuser and coworkers 2,3. In this paper we will compare these two freezing methods theoretically and experimentally.


2001 ◽  
Author(s):  
Z. Steel ◽  
J. Jones ◽  
S Adcock ◽  
R Clancy ◽  
L. Bridgford-West ◽  
...  

1989 ◽  
Vol 136 (5) ◽  
pp. 405 ◽  
Author(s):  
J. Sun ◽  
I.S. Reed ◽  
H.E. Huey ◽  
T.K. Truong

2003 ◽  
Vol 42 (02) ◽  
pp. 71-77 ◽  
Author(s):  
I. Schreivogel ◽  
C. Angerstein ◽  
U. Siefker ◽  
K. Lehmann ◽  
G. Altenvoerde ◽  
...  

SummaryAim: Formal and clinical comparison of a new 3rd-gene-ration-Tg-IRMA (3-G-IRMA; Dynotest®Tg-plus) with a conventional Tg-IRMA (3-G-IRMA; SELco®Tg-assay) for patients with differentiated thyroid carcinoma. In addition we evaluated, if thyroglobulin (Tg) levels above a specific threshold concentration indicate the need for further investigations for residual disease. Patients, methods: Tg concentration of 105 sera of 93 consecutive patients with a differentiated thyroid cancer was determined with both assays and compared at different cut-off values (Dynotest®Tg-plus: 0.2, 1, 2 ng/ml; SELco®Tg-assay: 0.5, 1, 2 ng/ml) with the clinical results in respect to the corresponding TSH concentration. Results: Tg concentration did not show any significant difference (SELco®Tg-assay 0.5 ng/ml, Dynotest® Tg-plus 0.2 ng/ml). The Tg-values of both assays correlated with 97%. However, correlation of recovery in both assays was small (40%). The sensitivities and specificities of both assays at different cut-offs and TSH values did not reveal significant differences. In patients with TSH concentration >30 µU/ml the functional assay sensitivity was superior to arbitrary cut-offs in the decision to start further evaluations. Conclusions: In our study neither formal nor clinical significant differences between two Tg-assays were found. In a hypothyroid patient (TSH >30 µU/ml, Tg concentration exceeding the functional assay sensitivity) further investigations for residual disease are warranted. Higher thresholds are of limited value, due to a inacceptable high rate of false negative results.


Sign in / Sign up

Export Citation Format

Share Document