Predictions of the time course of force and power output by dogfish white muscle fibres during brief tetani.

1998 ◽  
Vol 201 (1) ◽  
pp. 103-114 ◽  
Author(s):  
N A Curtin ◽  
A R Gardner-Medwin ◽  
R C Woledge
Keyword(s):  
Power Output ◽  
Constant Velocity ◽  
Time Course ◽  
White Muscle ◽  
Muscle Fibres ◽  
After Effects ◽  
In Series ◽  
Principal Factors ◽  
Strain Relationship ◽  
Relationship Of

The aim of this study was to identify the principal factors that determine the time course of force and power output by muscle during patterns of stimulation and movement similar to those during fish swimming. Fully activated, white muscle fibres isolated from dogfish Scyliorhinus canicula were used to characterize the force-velocity relationship of the contractile component (CC) and the stress-strain relationship of the passive, elastic component (SEC) in series with the CC. A simple model of the time course of crossbridge activation during brief contractions was devised. Using the mechanical properties of the CC and SEC and the activation time course, force and power were predicted for brief contractions with constant-velocity movement and also for brief contractions starting at various times during sinusoidal movement. The predicted force and power were compared with observations for these patterns of stimulation and movement. The predictions matched the observations well for the period during stimulation. Matching of force was much less good for some specific conditions during relaxation, the period during which force persists after the end of stimulation. If either the slow rise of activation or the SEC was omitted from the calculation, the predictions were poor, even during stimulation. Additional factors which may influence force are discussed. These include the after-effects of shortening and stretch, the variation of force during constant-velocity stretch and non-uniform behaviour within the muscle.

scholarly journals Power output and force-velocity relationship of red and white muscle fibres from the Pacific blue marlin (Makaira nigricans)

1984 ◽  
Vol 111 (1) ◽  
pp. 171-177 ◽  
Author(s):  
I. A. Johnston ◽  
J. Salamonski
Keyword(s):  
Power Output ◽  
White Muscle ◽  
Force Production ◽  
Muscle Fibres ◽  
Blue Marlin ◽  
Makaira Nigricans ◽  
The Pacific ◽  
Velocity Relationship ◽  
Force Velocity ◽  
Relationship Of

Single white fibres and small bundles (two to three) of red fibres were isolated from the trunk muscle of Pacific Blue Marlin (50–121 kg body weight). Fibres were chemically skinned with 1% Brij. Maximum Ca2+-activated force production (Po) was 57 kN m-2 for red fibres and 176 kN m-2 for white fibres at 25 degrees C. The force-velocity (P-V) characteristics of these fibres were determined at 15 and 25 degrees C. Points below 0.6 Po on the P-V curve could be fitted to a linear form of Hill's equation. The degree of curvature of the P-V curve was similar at 15 and 25 degrees C (Hill's constant a/Po = 0.24 and 0.12 for red and white fibres respectively). Extrapolated maximum contraction velocities (Vmax) were 2.5 muscle lengths s-1 (Lo S-1) (red fibres) and 5.3 Lo S-1 (white fibres) at 25 degrees C. Q10(15–25 degrees C) values for Vmax were 1.4 and 1.3 for red and white fibres respectively. Maximum power output had a similar low temperature dependence and amounted to 13 W kg-1 for red and 57 W kg-1 for white muscle at 25 degrees C. The results are briefly discussed in relation to the locomotion and ecology of marlin.

Elastic energy storage and release in white muscle from dogfish scyliorhinus canicula

1999 ◽  
Vol 202 (2) ◽  
pp. 135-142 ◽  
Author(s):  
F. Lou ◽  
N.A. Curtin ◽  
R.C. Woledge
Keyword(s):  
Energy Cost ◽  
White Muscle ◽  
Isometric Force ◽  
Muscle Length ◽  
Maximum Velocity ◽  
Muscle Fibres ◽  
External Work ◽  
Scyliorhinus Canicula ◽  
Velocity Of Shortening ◽  
In Series

The production of work by the contractile component (CC) and the storage and release of work in the elastic structures that act in series (the series elastic component, SEC) with the contractile component were measured using white muscle fibres from the dogfish Scyliorhinus canicula. Heat production was also measured because the sum of work and heat is equivalent to the energy cost of the contraction (ATP used). These energy fluxes were evaluated in contractions with constant-velocity shortening either during stimulation or during relaxation. The muscle preparation was tetanized for 0.6 s and shortened by 1 mm (approximately 15 % of L0) at 3.5 or 7.0 mm s-1 (approximately 15 or 30 % of V0), where L0 is the muscle length at which isometric force is greatest and V0 is the maximum velocity of shortening. In separate experiments, the stiffness of the SEC was characterized from measurements of force responses to step changes in the length of contracting muscle. Using the values of SEC stiffness, we evaluated separately the work and heat associated with the CC and with the SEC. The major findings were (1) that work stored in the SEC could be completely recovered as external work when shortening occurred during relaxation (none of the stored work being degraded into heat) and (2) that, when shortening occurred progressively later during the contraction, the total energy cost of the contraction declined towards that of an isometric contraction.

scholarly journals Temperature and the Force-Velocity Relationship of Live Muscle Fibres from the Teleost Myoxocephalus Scorpius

1989 ◽  
Vol 144 (1) ◽  
pp. 437-448 ◽  
Author(s):  
KAREN S. LANGFELD ◽  
JOHN D. ALTRINGHAM ◽  
IAN A. JOHNSTON
Keyword(s):  
Power Output ◽  
Muscle Power ◽  
Muscle Fibres ◽  
Velocity Relationship ◽  
Force Velocity ◽  
Myoxocephalus Scorpius ◽  
Relationship Of ◽  
Myotomal Muscle ◽  
Best Fit ◽  
Tetanic Tension

Small bundles of fast fibres were isolated from the myotomal muscle of the teleost Myoxocephalus scorpius. The temperature-dependence of isometric contractile properties and the force-velocity (P-V) relationship were studied. Fibres were found to deteriorate above 18°C, and the force plateau during tetanic stimulation was not maintained above 15°C. Twitch and tetanic tension (P0) showed optima at around 8°C. Force-velocity curves were fitted using either Hill's hyperbolic equation or a hyperbolic-linear equation (hyp-lin). The best fit to the data was provided by the hyp-lin equation, which gave consistently higher values for unloaded contraction velocity (Vmax): 4.3, 8.1 and 9.5 muscle lengths s−1 at 1, 8 and 12°C, respectively. The P-V relationship was found to become progressively more curved at higher temperatures. Muscle power output calculated from the hyp-lin equation was 123 W kg−1 at 1°C and 256 W kg−1 at 8°C. Curves normalized for P0 and Vmax at each temperature show that the change in curvature is sufficient to increase the relative power output of the muscle by around 15% on decreasing the temperature from 8 to 1°C.

Semi-inverse method for predicting stress–strain relationship from cone indentations

2003 ◽  
Vol 18 (9) ◽  
pp. 2068-2078 ◽  
Author(s):  
A. DiCarlo ◽  
H. T. Y. Yang ◽  
S. Chandrasekar
Keyword(s):  
A Priori ◽  
Model Material ◽  
Material Behavior ◽  
The Finite Element Method ◽  
Stress Strain ◽  
Indentation Tests ◽  
Strain Relationship ◽  
Initial Force ◽  
Relationship Of ◽  
Force Displacement

A method for determining the stress–strain relationship of a material from hardness values H obtained from cone indentation tests with various apical angles is presented. The materials studied were assumed to exhibit power-law hardening. As a result, the properties of importance are the Young's modulus E, yield strength Y, and the work-hardening exponent n. Previous work [W.C. Oliver and G.M. Pharr, J. Mater. Res. 7, 1564 (1992)] showed that E can be determined from initial force–displacement data collected while unloading the indenter from the material. Consequently, the properties that need to be determined are Y and n. Dimensional analysis was used to generalize H/E so that it was a function of Y/E and n [Y-T. Cheng and C-M. Cheng, J. Appl. Phys. 84, 1284 (1999); Philos. Mag. Lett. 77, 39 (1998)]. A parametric study of Y/E and n was conducted using the finite element method to model material behavior. Regression analysis was used to correlate the H/E findings from the simulations to Y/E and n. With the a priori knowledge of E, this correlation was used to estimate Y and n.

Study on Stress-Strain Relationship of Loess

2004 ◽  
Vol 274-276 ◽  
pp. 241-246 ◽  
Author(s):  
Bo Han ◽  
Hong Jian Liao ◽  
Wuchuan Pu ◽  
Zheng Hua Xiao
Keyword(s):  
Stress Strain ◽  
Strain Relationship ◽  
Relationship Of

Nonlinear Oscillations of a Composite Laminated Plate with Parametrically and Externally Excitations

2013 ◽  
Vol 699 ◽  
pp. 641-644
Author(s):  
Xiao Li Bian ◽  
Shuang Bao Li
Keyword(s):  
Thin Plate ◽  
Nonlinear Oscillations ◽  
Plate Theory ◽  
Laminated Plate ◽  
Rectangular Thin Plate ◽  
Third Order ◽  
Composite Laminated Plate ◽  
Strain Relationship ◽  
Relationship Of ◽  
Equations Of Motions

Nonlinear oscillations of a simply-supported symmetric cross-ply composite laminated rectangular thin plate are investigated in this paper. The rectangular thin plate is subjected to the transversal and in-plane excitations. Based on the Reddy’s third-order shear deformation plate theory and the stress-strain relationship of the composite laminated plate, a two-degree-of-freedom non-autonomous nonlinear system governing equations of motions for the composite laminated rectangular thin plate is derived by using the Galerkin’s method. Numerical simulations illustrate that there exist complex nonlinear oscillations for composite laminated rectangular thin plate.

EFFICIENCY OF ENERGY CONVERSION DURING SINUSOIDAL MOVEMENT OF WHITE MUSCLE FIBRES FROM THE DOGFISH SCYLIORHINUS CANICULA

1993 ◽  
Vol 183 (1) ◽  
pp. 137-147 ◽  
Author(s):  
N. A. Curtin ◽  
R. C. Woledge
Keyword(s):  
Power Output ◽  
High Efficiency ◽  
Fibre Length ◽  
Dry Mass ◽  
Energy Output ◽  
Maximum Efficiency ◽  
Muscle Fibres ◽  
Work Output ◽  
Sinusoidal Movement ◽  
Myotomal Muscle

Net work output and heat production of white myotomal muscle fibres from the dogfish were measured during complete cycles of sinusoidal movement at 12°C. The peak-to-peak movement was about 9 % of the muscle fibre length; three stimuli at 32 ms intervals were given in each mechanical cycle. The frequency of movement and the timing of the stimulation were varied for each preparation to find the optimal conditions for power output and those optimal for efficiency (the ratio of net work output to total energy output as heat+work). To achieve either maximum power or maximum efficiency, the tetanus must start while the muscle fibres are being stretched, before the beginning of the shortening part of the mechanical cycle. The highest power output, averaged over one cycle, was 0.23+/−0.014 W g-1 dry mass (+/−s.e.m., N=9, 46.9+/−2.8 mW g-1 wet mass) and was produced during movement at 3.5 Hz. The highest efficiency, 0.41+/−0.02 (+/−s.e.m., N=13), occurred during movements at 2.0-2.5 Hz. This value is higher than the efficiency previously measured during isovelocity shortening of these fibres. The implications of the high efficiency for crossbridge models of muscle contraction are discussed.

The resting membrane potential of white muscle from brown trout (Salmo trutta) exposed to copper in soft, acidic water

2000 ◽  
Vol 203 (14) ◽  
pp. 2229-2236 ◽  
Author(s):  
M.W. Beaumont ◽  
E.W. Taylor ◽  
P.J. Butler
Keyword(s):  
Membrane Potential ◽  
Brown Trout ◽  
Salmo Trutta ◽  
White Muscle ◽  
Low Ph ◽  
Ammonium Ion ◽  
Muscle Membrane ◽  
Resting Membrane Potential ◽  
Muscle Fibres ◽  
Brown Trout Salmo Trutta

Previously, the distribution of ammonia between the intracellular and extracellular compartments has been used to predict a significant depolarisation of the resting membrane potential (E(M)) of white muscle from brown trout (Salmo trutta) exposed to a sub-lethal combination of copper and low pH. However, this prediction is based upon two assumptions (i) a relatively high membrane permeability for the ammonium ion with respect to that for ammonia gas and (ii) that this is unaltered by exposure to copper and low pH. Since there is conflicting evidence in the literature of the validity of these assumptions, in the present study E(M) was directly measured in white muscle fibres of trout exposed to copper and low pH (E(M)=−52.2+/−4.9 mV) and compared with that of unexposed, control animals (E(M)=−86.5+/−2.9 mV) (means +/− s.e.m., N=6). In confirming the predicted depolarisation, these data support the hypothesis of electrophysiological impairment as a factor in the reduction in the swimming performance of trout exposed to these pollutants. In addition, the results of this study support the role of a significant permeability of the muscle membrane to NH(4)(+) in determining the distribution of ammonia in fish.

Sign in / Sign up

Export Citation Format

Share Document