The effects of carbon dioxide in exhaust gas recirculation on diesel engine emissions

Author(s):  
N Ladommatos ◽  
S M Adelhalim ◽  
H Zhao ◽  
Z Hu

The investigation was conducted on a high-speed direct injection diesel engine and was concerned with the effects of exhaust gas recirculation (EGR) on diesel engine combustion and emissions. In particular, the effects of carbon dioxide (CO2), a principal constituent of EGR, on combustion and emissions were analysed and quantified experimentally. The use of CO2 to displace oxygen (O2) in the inlet air resulted in: reduction in the O2 supplied to the engine (dilution effect), increased inlet charge thermal capacity (thermal effect), and, potentially, participation of the CO2 in the combustion process (chemical effect). In a separate series of tests the temperature of the engine inlet charge was raised gradually in order to simulate the effect of mixing hot EGR with engine inlet air. Finally, tests were carried out during which the CO2 added to the engine air flow increased the charge mass flowrate to the engine, rather than displacing some of the O2 in the inlet air. It was found that when CO2 displaced O2 in the inlet charge, both the chemical and thermal effects on exhaust emissions were small. However, the dilution effect was substantial, and resulted in very large reductions in exhaust oxides of nitrogen (NO x) at the expense of higher particulate and unburned hydrocarbon (uHC) emissions. Higher inlet charge temperature increased exhaust NO x and particulate emissions, but reduced uHC emissions. Finally, when CO2 was additional to the inlet air charge (rather than displacing O2), large reductions in NOx were recorded with little increase in particulate emissions.

2000 ◽  
Vol 1 (1) ◽  
pp. 107-126 ◽  
Author(s):  
N Ladommatos ◽  
S Abdelhalim ◽  
H Zhao

An investigation was conducted with the aim of identifying and quantifying the effects of exhaust gas recirculation (EGR) on diesel engine combustion and exhaust emissions. Five effects of EGR were identified and investigated experimentally: the reduction in oxygen supply to the engine, participation in the combustion process of carbon dioxide and water vapour present in the EGR, increase in the specific heat capacity of the engine inlet charge, increased inlet charge temperature and reduction in the inlet charge mass flowrate arising from the use of hot EGR. The experimental methodology developed allowed each one of these effects to be investigated and quantified separately. The investigation was carried out on a high-speed, direct injection diesel engine, running at an intermediate speed and load. A limited number of tests were also conducted in an optically accessible diesel engine, which established the effects of EGR on local flame temperature. Finally, tests were conducted with simulated EGR being used additionally to the engine air supply. This contrasts with the conventional use of EGR, whereby EGR replaces some of the air supplied to the engine. It was found that the first effect of EGR (reduction in the oxygen flowrate to the engine) was substantial and resulted in very large reductions in exhaust NOx at the expense of higher particulate emissions. The second and third effects (participation of carbon dioxide and water vapour in the combustion process and increase in the charge specific heat capacity) were almost insignificant. The fourth effect (higher inlet charge temperature) increased both exhaust NOx and particulate emissions. The fifth effect (reduction in the inlet charge due to thermal throttling) reduced NOx but raised particulate emission. Finally, when EGR was used additionally to the inlet air charge (rather than displacing air), substantial reductions in NOx were recorded with little increase in particulate emission.


Author(s):  
Fengjun Yan ◽  
Junmin Wang

Fueling control in Diesel engines is not only of significance to the combustion process in one particular cycle, but also influences the subsequent dynamics of air-path loop and combustion events, particularly when exhaust gas recirculation (EGR) is employed. To better reveal such inherently interactive relations, this paper presents a physics-based, control-oriented model describing the dynamics of the intake conditions with fuel injection profile being its input for Diesel engines equipped with EGR and turbocharging systems. The effectiveness of this model is validated by comparing the predictive results with those produced by a high-fidelity 1-D computational GT-Power engine model.


2019 ◽  
Vol 22 (1) ◽  
pp. 284-294 ◽  
Author(s):  
FCP Leach ◽  
MH Davy ◽  
MS Peckham

As the control of real driving emissions continues to increase in importance, the importance of understanding emission formation mechanisms during engine transients similarly increases. Knowledge of the NO2/NOx ratio emitted from a diesel engine is necessary, particularly for ensuring optimum performance of NOx aftertreatment systems. In this work, cycle-to-cycle NO and NOx emissions have been measured using a Cambustion CLD500, and the cyclic NO2/NOx ratio calculated as a high-speed light-duty diesel engine undergoes transient steps in load, while all other engine parameters are held constant across a wide range of operating conditions with and without exhaust gas recirculation. The results show that changes in NO and NOx, and hence NO2/NOx ratio, are instantaneous upon a step change in engine load. NO2/NOx ratios have been observed in line with previously reported results, although at the lightest engine loads and at high levels of exhaust gas recirculation, higher levels of NO2 than have been previously reported in the literature are observed.


Author(s):  
H Zhao ◽  
J Hu ◽  
N Ladommatos

This paper reports the results of the effects of CO2 in exhaust gas recirculation (EGR) on diesel combustion and emissions. The experiments were carried out on a specially designed single-cylinder diesel engine. In-cylinder measurements were obtained from the optically accessible swirl chamber using high-speed shadowgraphy, the two-colour method and laser extinction. Furthermore, in-cylinder pressure measurements from the combustion chambers were used to derive the heat release rates during combustion. Two experiments were carried out on the effects of CO2 on diesel combustion and pollutant formation. In the first series of experiments, CO2 was used to replace some of the oxygen in the intake mixture, which simulated the dilution effect of conventional EGR. This so-called replacement EGR method was characterized by the typical NOx and smoke trade-off, where NOx reduction was accomplished at the expense of exhaust smoke. In the second series of tests, CO2 was added to the intake charge so that the oxygen concentration in the combustion chamber was not affected. In this additional EGR method, CO2 was found to suppress both NOx and smoke emissions. The mechanisms of these two different EGR modes on diesel combustion and emissions were examined using the above in-cylinder measurement techniques and exhaust emission analysis.


2019 ◽  
Vol 6 (6) ◽  
pp. 181907 ◽  
Author(s):  
Xiang-huan Zu ◽  
Chuan-lei Yang ◽  
He-Chun Wang ◽  
Yin-yan Wang

In order to study the exhaust gas recirculation (EGR) performance of marine diesel engines, a venturi high-pressure EGR device was established to overcome the exhaust gas reflow problem based on a certain type of turbocharged diesel engine. The EGR performance test is accomplished and an optimal EGR decision-making optimization method based on grey correlation coefficient modified is proposed. The results show that the venturi tube EGR can basically meet the injection requirements of high-pressure exhaust gas and achieve good results. Through the venturi tube EGR, the NO X emissions reduce significantly with the maximum drop of 30.6%. The explosive pressure in cylinder reduces with the EGR rate increases and the cylinder pressure curve shows a single peak at low-speed conditions and double peaks at high-speed condition. However, the fuel consumption rate, NO X and smoke have been negatively affected. Due to small samples, the traditional evaluation method is difficult to determine the optimal EGR rate reasonably, while the proposed method can effectively solve this problem. It can weaken the shortcomings of subjective judgement and greatly improve the rationality of decision-making results.


Sign in / Sign up

Export Citation Format

Share Document