Statistical Considerations on Pressure Pulses from a Cavitating Venturi

1986 ◽  
Vol 200 (6) ◽  
pp. 381-387
Author(s):  
S Li ◽  
Y Zhang ◽  
F G Hammitt
Keyword(s):  
Closed Loop ◽  
Pressure Fluctuations ◽  
Low Frequency ◽  
Resonant Interaction ◽  
Statistical Characteristics ◽  
Pressure Pulsations ◽  
Cavitation Inception ◽  
Flow Noise ◽  
Pressure Pulses ◽  
Liquid Portion

Pressure pulses emitted from cavitating venturi flows are measured and investigated statistically. The results show that according to the degree of cavitation, the overall pressure pulsations consist of different combinations of three components, that is basic flow noise, cavitation pulses and low-frequency pressure fluctuations, due primarily to overall loop characteristics. The statistical characteristics are presented and compared. It is believed that the low-frequency fluctuations result from a resonant interaction between the cavitation ‘cloud’ and the liquid portion of the closed loop. They occur near cavitation inception, reach a maximum at a particular cavitation number, σres, then gradually disappear for increased σ. Their frequency is basically constant for all σ. An empirical-theoretical model of this behaviour is presented.

scholarly journals Damping Pressure Pulsations in a Wave-Powered Desalination System

2014 ◽  
Vol 136 (2) ◽  
Author(s):  
Brandon J. Hopkins ◽  
Nikhil Padhye ◽  
Alison Greenlee ◽  
James Torres ◽  
Levon Thomas ◽  
...  
Keyword(s):  
Constant Pressure ◽  
Low Cost ◽  
Pressure Fluctuations ◽  
Cost Effective ◽  
Coastal Communities ◽  
Pressure Pulsations ◽  
Pressure Flow ◽  
Reliable Source ◽  
Effective Option ◽  
Elastic Pipes

Wave-driven reverse osmosis desalination systems can be a cost-effective option for providing a safe and reliable source of drinking water for large coastal communities. Such systems usually require the stabilization of pulsating pressures for desalination purposes. The key challenge is to convert a fluctuating pressure flow into a constant pressure flow. To address this task, stub-filters, accumulators, and radially elastic-pipes are considered for smoothing the pressure fluctuations in the flow. An analytical model for fluidic capacitance of accumulators and elastic pipes are derived and verified. Commercially available accumulators in combination with essentially rigid (and low cost) piping are found to be a cost-effective solution for this application, and a model for selecting accumulators with the required fluidic-capacitance for the intended system is thus presented.

Aeroacoustic analysis of slat tones

2021 ◽  
Vol 263 (1) ◽  
pp. 5650-5663
Author(s):  
Hasan Kamliya Jawahar ◽  
Syamir Alihan Showkat Ali ◽  
Mahdi Azarpeyvand
Keyword(s):  
Wavelet Transform ◽  
Surface Pressure ◽  
Wavelet Coefficient ◽  
Pressure Fluctuations ◽  
Low Frequency ◽  
Stream Velocity ◽  
High Lift ◽  
Unsteady Surface Pressure ◽  
Slat Noise ◽  
Generation Mechanisms

Experimental measurements were carried out to assess the aeroacoustic characteristics of a 30P30N high-lift device, with particular attention to slat tonal noise. Three different types of slat modifications, namely slat cove filler, serrated slat cusp, and slat finlets have been experimentally examined. The results are presented for an angle of attack of α = 18 at a free-stream velocity of U = 30 m/s, which corresponds to a chord-based Reynolds number of Re = 7 x 10. The unsteady surface pressure near the slat region and far-field noise were made simultaneously to gain a deeper understanding of the slat noise generation mechanisms. The nature of the low-frequency broadband hump and the slat tones were investigated using higher-order statistical approaches for the baseline 30P30N and modified slat configurations. Continuous wavelet transform of the unsteady surface pressure fluctuations along with secondary wavelet transform of the broadband hump and tones were carried out to analyze the intermittent events induced by the tone generating resonant mechanisms. Stochastic analysis of the wavelet coefficient modulus of the surface pressure fluctuations was also carried out to demonstrate the inherent differences of different tonal frequencies. An understanding into the nature of the noise generated from the slat will help design the new generation of quite high-lift devices.

Comparison of Mixture and Multifluid Models for In-Nozzle Cavitation Prediction

2014 ◽  
Vol 136 (6) ◽  
Author(s):  
Michele Battistoni ◽  
Sibendu Som ◽  
Douglas E. Longman
Keyword(s):  
Mixture Model ◽  
Bubble Dynamics ◽  
National Laboratory ◽  
Pressure Fluctuations ◽  
Argonne National Laboratory ◽  
Numerical Approach ◽  
Fuel Injectors ◽  
Cavitation Inception ◽  
Noncondensable Gases ◽  
Large Pressure

Fuel injectors often feature cavitation because of large pressure gradients, which in some regions lead to extremely low pressures. The main objective of this work is to compare the prediction capabilities of two multiphase flow approaches for modeling cavitation in small nozzles, like those used in high-pressure diesel or gasoline fuel injectors. Numerical results are assessed against quantitative high resolution experimental data collected at Argonne National Laboratory using synchrotron X-ray radiography of a model nozzle. One numerical approach uses a homogeneous mixture model with the volume of fluid (VOF) method, in which phase change is modeled via the homogeneous relaxation model (HRM). The second approach is based on the multifluid nonhomogeneous model and uses the Rayleigh bubble-dynamics model to account for cavitation. Both models include three components, i.e., liquid, vapor, and air, and the flow is compressible. Quantitatively, the amount of void predicted by the multifluid model is in good agreement with measurements, while the mixture model overpredicts the values. Qualitatively, void regions look similar and compare well with the experimental measurements. Grid converged results have been achieved for the prediction of mass flow rate while grid-convergence for void fraction is still an open point. Simulation results indicate that most of the vapor is produced at the nozzle entrance. In addition, downstream along the centerline, void due to expansion of noncondensable gases has been identified. The paper also includes a discussion about the effect of turbulent pressure fluctuations on cavitation inception.

scholarly journals Nonlinear interaction between acoustic gravity waves

1996 ◽  
Vol 14 (3) ◽  
pp. 304-308 ◽  
Author(s):  
P. Axelsson ◽  
J. Larsson ◽  
L. Stenflo
Keyword(s):  
Gravity Waves ◽  
Nonlinear Interaction ◽  
Low Frequency ◽  
Resonant Interaction ◽  
Coupling Coefficients ◽  
Symmetric Form ◽  
Frequency Limit ◽  
Acoustic Gravity Waves

Abstract. The resonant interaction between three acoustic gravity waves is considered. We improve on the results of previous authors and write the new coupling coefficients in a symmetric form. Particular attention is paid to the low-frequency limit.

Nycthemeral Rhythm of the Frequency and Biomechanical Energy of High Frequency Intraocular Pressure Fluctuations

2013 ◽  
Author(s):  
Vincent Libertiaux ◽  
William P. Seigfreid ◽  
Massimo A. Fazio ◽  
Juan F. Reynaud ◽  
Claude F. Burgoyne ◽  
...  
Keyword(s):  
Intraocular Pressure ◽  
High Frequency ◽  
Pressure Fluctuations ◽  
Low Frequency ◽  
Pulse Amplitude ◽  
Mean Value ◽  
Multiple Time Scales ◽  
Dynamic Contour Tonometry ◽  
Multiple Time ◽  
Ocular Pulse

The optic nerve head (ONH) is the site of insult in glaucoma, the second leading cause of blindness worldwide. Intraocular pressure (IOP) is commonly regarded as a major factor in the onset and progression of the disease1 and lowering IOP is the only clinical treatment that has been shown to retard the onset and progression of glaucoma2. However, many patients continue to progress even at an epidemiologically-determined normal level of IOP3. This suggests that in addition to the mean value of IOP, IOP fluctuations could be a factor in glaucomatous pathophysiology. The importance of low frequency fluctuations of clinically-measured mean IOP remains controversial. These studies all rely on snapshot measurements of mean IOP at each time point, and those measurements are taken at relatively infrequent intervals (hourly at the most frequent, but usually monthly or longer). Recently however, there has been some interest in ocular pulse amplitude, or the fluctuation in IOP associated with the cardiac cycle, which can be measured by Dynamic Contour Tonometry (DCT). DCT provides continuous measurement of IOP, but only for a period of tens of seconds in which a patient can tolerate corneal contact without blinking or eye movement, which ironically are two of the most common sources of large high frequency IOP fluctuations according to our telemetric data collected from monkeys4 and previous human studies. In a recent report, continuous IOP telemetry was used in three nonhuman primates to characterize IOP dynamics at multiple time scales for multiple 24-hour periods5.

Monitoring the parameters of a reactor by low-frequency pressure pulsations

1981 ◽  
Vol 51 (2) ◽  
pp. 512-516
Author(s):  
V. I. Vlasov ◽  
S. A. Mokrushin ◽  
V. P. Radchenko ◽  
V. V. Selin ◽  
A. A. Artamonov ◽  
...  
Keyword(s):  
Low Frequency ◽  
Pressure Pulsations

scholarly journals Effect of Closed-Loop Vibration Stimulation on Heart Rhythm during Naps

Sensors ◽  
2019 ◽  
Vol 19 (19) ◽  
pp. 4136 ◽  
Author(s):  
Sang Ho Choi ◽  
Heenam Yoon ◽  
Hyung Won Jin ◽  
Hyun Bin Kwon ◽  
Seong Min Oh ◽  
...  
Keyword(s):  
High Frequency ◽  
Closed Loop ◽  
Low Frequency ◽  
Heart Rhythm ◽  
Quality Of Sleep ◽  
Stimulation Condition ◽  
Term Basis ◽  
Stimulation System

Sleep plays a primary function for health and sustains physical and cognitive performance. Although various stimulation systems for enhancing sleep have been developed, they are difficult to use on a long-term basis. This paper proposes a novel stimulation system and confirms its feasibility for sleep. Specifically, in this study, a closed-loop vibration stimulation system that detects the heart rate (HR) and applies −n% stimulus beats per minute (BPM) computed on the basis of the previous 5 min of HR data was developed. Ten subjects participated in the evaluation experiment, in which they took a nap for approximately 90 min. The experiment comprised one baseline and three stimulation conditions. HR variability analysis showed that the normalized low frequency (LF) and LF/high frequency (HF) parameters significantly decreased compared to the baseline condition, while the normalized HF parameter significantly increased under the −3% stimulation condition. In addition, the HR density around the stimulus BPM significantly increased under the −3% stimulation condition. The results confirm that the proposed stimulation system could influence heart rhythm and stabilize the autonomic nervous system. This study thus provides a new stimulation approach to enhance the quality of sleep and has the potential for enhancing health levels through sleep manipulation.

Sign in / Sign up

Export Citation Format

Share Document