scholarly journals Measurement-based harmonic current modeling of mobile storage for power quality study in the distribution system

2017 ◽  
Vol 66 (4) ◽  
pp. 801-814 ◽  
Author(s):  
Christoph Wenge ◽  
Hui Guo ◽  
Christian Roehrig
Keyword(s):  
Power System ◽  
Power Quality ◽  
Power Distribution ◽  
Distribution System ◽  
Measurement Data ◽  
Load Flow ◽  
Harmonic Current ◽  
Current Harmonics ◽  
Power Distribution System ◽  
The Impact

Abstract Electric vehicles (EVs) can be utilized as mobile storages in a power system. The use of battery chargers can cause current harmonics in the supplied AC system. In order to analyze the impact of different EVs with regardto their number and their emission of current harmonics, a generic harmonic current model of EV types was built and implemented in the power system simulation tool PSS®NETOMAC. Based on the measurement data for different types of EVs three standardized harmonic EV models were developed and parametrized. Further, the identified harmonic models are used by the computation of load flow in a modeled, German power distribution system. As a benchmark, a case scenario was studied regarding a high market penetration of EVs in the year 2030 for Germany. The impact of the EV charging on the power distribution system was analyzed and evaluated with valid power quality standards.

Impact of Distributed Generation on the Fault Current in Power Distribution System

2017 ◽  
Vol 6 (2) ◽  
pp. 357
Author(s):  
Zuhaila Mat Yasin ◽  
Izni Nadhirah Sam’ón ◽  
Norziana Aminudin ◽  
Nur Ashida Salim ◽  
Hasmaini Mohamad
Keyword(s):  
Power System ◽  
Distributed Generation ◽  
Power Distribution ◽  
Distribution System ◽  
Test System ◽  
Optimal Location ◽  
Fault Current ◽  
Double Line ◽  
Power Distribution System ◽  
The Impact

<p>Monitoring fault current is very important in power system protection. Therefore, the impact of installing Distributed Generation (DG) on the fault current is investigated in this paper. Three types of fault currents which are single line-to-ground, double line-to-ground and three phase fault are analyzed at various fault locations. The optimal location of DG was identified heuristically using power system simulation program for planning, design and analysis of distribution system (PSS/Adept). The simulation was conducted by observing the power losses of the test system by installing DG at each load buses. Bus with minimum power loss was chosen as the optimal location of DG. In order to study the impact of DG to the fault current, various locations and sizes of DG were also selected. The simulations were conducted on IEEE 33-bus distribution test system and IEEE 69-bus distribution test system. The results showed that the impact of DG to the fault current is significant especially when fault occurs at busses near to DG location.</p>

scholarly journals Optimal Battery Energy Storage System Based on VAR Control Strategies Using Particle Swarm Optimization for Power Distribution System

Symmetry ◽  
2021 ◽  
Vol 13 (9) ◽  
pp. 1692
Author(s):  
Prakasit Prabpal ◽  
Yuttana Kongjeen ◽  
Krischonme Bhumkittipich
Keyword(s):  
Power System ◽  
Power Distribution ◽  
Distribution System ◽  
Storage System ◽  
Energy Storage System ◽  
Battery Energy Storage System ◽  
Power Distribution System ◽  
Load Demand ◽  
Battery Energy ◽  
The Impact

We designed a battery energy storage system (BESS) based on the symmetrical concept where the required control is by the symmetrical technique known as volt/var control. The integration of BESS into the conventional distribution has significantly impacted energy consumption over the past year. Load demand probability was used to investigate optimal sizing and location of BESS in an electrical power system. The open electric power distribution system simulator (OpenDSS) was interfaced with MATLAB m-file scripts and presented by using time series analysis with load demand. The optimal BESS solution was adapted by using a genetic algorithm (GA) optimization technique and particle swarm optimization (PSO). The simulation results showed that the BESS was directly connected to the power grid with GA and PSO, and it was observed that BESS sizing also varied for these two values of 1539 kW and 1000 kW, respectively. The merit of those values is the power figure of the system, which is necessary for installation. Therefore, optimal sizing and location of the BESS are helpful to reduce the impact from the load demand to the total system loss and levelling of the energy demand from the power system network. The integration of the BESS can be applied to improve grid stability and store surplus energy very well. The grid increased the stability of the power system and reduced the impact from the large scale of BESS penetration.

Performance Evaluation and Impact Analysis of Distributed Generation on Radial Power Distribution System

2015 ◽  
Vol 799-800 ◽  
pp. 1222-1226
Author(s):  
Arthit Thaniyaphol ◽  
Itthisek Nilkhamhang
Keyword(s):  
Smart Grid ◽  
Power System ◽  
Power Distribution ◽  
Distribution System ◽  
Renewable Energy Sources ◽  
Electrical Network ◽  
Total Power ◽  
Main Task ◽  
Power Distribution System ◽  
The Impact

This research focuses on evaluating and analyzing the behavior of smart grid power distribution system with multiple, interconnected distributed generations (DGs). This topic is especially relevant to Thailand, which employs a radial distribution topology and has insufficient use of energy storage system (ESS). Integration of DGs with distribution power systems is a necessity to achieve reliable and efficient performance. The characteristics of each category of DGs must be studied to improve the power system. The main task of the interconnected system is to control and maintain voltage of the power system in an acceptable range for high reliability, efficiency and quality. The proposed study consists of two critical objectives. Firstly, we will investigate the principle operation of DGs that uses renewable energy sources interconnected with the smart grid. The second and final goal is to evaluate and analyze the impact of DGs on the power distribution system. Power injection from DGs can reduce total power loss and improve system performance. In addition, the presence of DGs can increase the voltage level and robustness of the system more than traditional electrical network. However, high penetration of DGs may have an effect on voltage changes at the bus.

scholarly journals Analysis on the Effect of Capacitor Banks Operation towards Total Harmonic Distortions (THD) in Distribution Network Test System

2018 ◽  
Vol 1 (2) ◽  
Author(s):  
Dalila M.S. ◽  
Zaris I.M.Y. ◽  
Nasarudin A. ◽  
Faridah H.
Keyword(s):  
Power Distribution ◽  
Distribution System ◽  
Distribution Network ◽  
Harmonic Distortion ◽  
Test System ◽  
Free Access ◽  
Initial Value ◽  
Power Distribution System ◽  
Source Codes ◽  
The Impact

This paper purposely to examine and analyse the impact of the distribution capacitors banks operation to the transition of total harmonic distortion (THD) level in distribution network system. The main advantage of this work is the simplicity algorithm of the method and the system being analysed using free access open software which is known as electric power distribution system simulator (OpenDSS). In this paper, the harmonic current spectrum which is collected from the commercial site was injected to a node point on IEEE13 bus in order to provide the initial measurement of THD for the network. The proper sizing of the capacitors banks has been set and being deactivated and activated throughout the network to see the transistion in the THD level in the system. The results were achieved by simulation of the data on the configured IEEE13 bus. The simulation work was done by using the combination of C++ source codes, OpenDSS and Microsoft Excel software. From the output results, the THD current has increased up to two times from the initial value in certain phases and for the THD voltage, the THD has increased up to three times from its initial value in all phases.

Design of Z-Source Inverter-Based Dynamic Voltage Restorer Circuitry with R-SOGI Control Scheme for Enrichment of Power Quality

2021 ◽  
pp. 2150195
Author(s):  
A. Sathik Basha ◽  
M. Ramasamy
Keyword(s):  
Power Quality ◽  
Power Distribution ◽  
Distribution System ◽  
Voltage Sag ◽  
Nonlinear Loads ◽  
Dynamic Voltage Restorer ◽  
Power Distribution System ◽  
Voltage Restorer ◽  
Control Scheme ◽  
Dynamic Voltage

Increased utilization of nonlinear loads in the power distribution system with profound integration of renewable energy requires improved power quality control. This paper proposes a Reformed Second Order Generalized Integrated (R-SOGI) control scheme for enhancing the output of the Dynamic Voltage Restorer (DVR) for the objective of achieving the desired sinusoidal voltage wave shape at the common point of services and harmonic reduction. The DVR incorporates a Solar Photovoltaic (SPV) system using the Z-source Inverter (ZSI), providing the necessary active power to mitigate the voltage sag/swell and power demand. ZSI offers step-down as well as step-up abilities, it makes the converters to operate in the conditions of shoot-through. Therefore, the application of ZSI-based DVR topology seems very promising. The compensating reference voltage is generated by the R-SOGI algorithm, which offers superior output under conditions for grid voltage irregularities, including voltage sag/swell and unbalanced and distorted utility grid voltages. In comparison to DVR based on the VSI voltage inverter (VSI), the response from ZSI-DVR to a reduction of voltage distortions and harmonics is investigated. An experimental SPV ZSI-DVR prototype is developed in the laboratory to check the effectiveness of the controller and is tested under balanced and unbalanced supply and dynamic load conditions.

Optimal Power Distribution System Planning and Analysis Using Q-GIS and Soft Computing

2020 ◽  
Vol 12 (1) ◽  
pp. 70-83
Author(s):  
Shabbiruddin ◽  
Sandeep Chakravorty ◽  
Karma Sonam Sherpa ◽  
Amitava Ray
Keyword(s):  
Power Systems ◽  
Power Distribution ◽  
Distribution System ◽  
Flow Analysis ◽  
Integrated Approach ◽  
Load Flow ◽  
Strategic Decisions ◽  
Power Distribution System ◽  
Load Flow Analysis ◽  
Private And Public

The selection of power sub-station location and distribution line routing in power systems is one of the important strategic decisions for both private and public sectors. In general, contradictory factors such as availability, and cost, affects the appropriate selection which adheres to vague and inexact data. The work presented in this research deals with the development of models and techniques for planning and operation of power distribution system. The work comprises a wider framework from the siting of a sub-station to load flow analysis. Work done also shows the application of quantum- geographic information system (Q-GIS) in finding load point coordinates and existing sub-station locations. The proposed integrated approach provides realistic and reliable results, and facilitates decision makers to handle multiple contradictory decision perspectives. To accredit the proposed model, it is implemented for power distribution planning in Bihar which consists of 9 divisions. A Cubic Spline Function-based load flow analysis method is developed to validate the proposal.

scholarly journals Flexibility Enhancement in an Islanded Distribution Power System by Online Demand-Side Management

2019 ◽  
Vol 217 ◽  
pp. 01020 ◽  
Author(s):  
Margarita Chulyukova ◽  
Nikolai Voropai
Keyword(s):  
Power System ◽  
Power Distribution ◽  
Distribution System ◽  
Distribution Systems ◽  
Load Shedding ◽  
Load Management ◽  
Daily Maximum ◽  
Power Distribution Systems ◽  
Power Distribution System ◽  
Islanded Operation

The paper considers the possibilities of increasing the flexibility of power distribution systems by real-time load management. The principles of the implementation of special automatic systems for this purpose are proposed. These systems enable some loads of specific consumers of the power distribution system switched to islanded operation to “shift” from the daily maximum to the minimum, which makes some generators available to connect certain essential consumers disconnected earlier by under-frequency load shedding system to the power system. The approach under consideration is illustrated by a power system with distributed generation.

Sign in / Sign up

Export Citation Format

Share Document