Comparison of the Performance of Copper Oxide Nanofluid with Water in Electronic Cooling

Nanofluids ◽  
2012 ◽  
pp. 21-41
Author(s):  
Praveen K. Namburu ◽  
K. Debendra Das ◽  
S. Ravikanth Vajjha
Keyword(s):  
Copper Oxide ◽  
Electronic Cooling

Comparison of the Performance of Copper Oxide Nanofluid with Water in Electronic Cooling

2012 ◽  
Vol 9 (5) ◽  
pp. 104342 ◽  
Author(s):  
Praveen K. Namburu ◽  
K. Debendra Das ◽  
S. Ravikanth Vajjha
Keyword(s):  
Copper Oxide ◽  
Electronic Cooling

Surface reconstructions of (001) cleaved GdBa2Cu3O7-δ

1992 ◽  
Vol 50 (1) ◽  
pp. 106-107
Author(s):  
H.W. Zandbergen ◽  
M.R. McCartney
Keyword(s):  
Electron Microscopy ◽  
Copper Oxide ◽  
Grain Boundaries ◽  
Atomic Structure ◽  
Oxygen Deficiency ◽  
Surface Layers ◽  
Layer Sequence ◽  
Surface Reconstructions ◽  
Good Agreement

Very few electron microscopy papers have been published on the atomic structure of the copper oxide based superconductor surfaces. Zandbergen et al. have reported that the surface of YBa2Cu3O7-δ was such that the terminating layer sequence is bulk-Y-CuO2-BaO-CuO-BaO, whereas the interruption at the grain boundaries is bulk-Y-CuO2-BaO-CuO. Bursill et al. reported that HREM images of the termination at the surface are in good agreement with calculated images with the same layer sequence as observed by Zandbergen et al. but with some oxygen deficiency in the two surface layers. In both studies only one or a few surfaces were studied.

EXPERIMENTAL INVESTIGATION OF GAS THROTTLING IN MICROCHANNELS FOR ELECTRONIC COOLING

2018 ◽  
Author(s):  
Jianhua Weng ◽  
Hang Zhang ◽  
Geng Hui ◽  
Xiaoyu Cui ◽  
Tongyun Zhang ◽  
...  
Keyword(s):  
Experimental Investigation ◽  
Electronic Cooling

ANTIBIOTIC PROFILE AND ANTIBACTERIAL ACTIVITY OF COPPER OXIDE NANOPARTICLES AGAINST Pseudomonas fluorescens ISOLATED FROM WOUND INFECTION

2019 ◽  
Vol 9 (o3) ◽  
Author(s):  
Haider Qassim Raheem ◽  
Takwa S. Al-meamar ◽  
Anas M. Almamoori
Keyword(s):  
Antibacterial Activity ◽  
Copper Oxide ◽  
Pseudomonas Fluorescens ◽  
Wide Spectrum ◽  
Copper Oxide Nanoparticles ◽  
Morphological Properties ◽  
Clinical Samples ◽  
Oxide Nanoparticles ◽  
Cuo Nps ◽  
Disk Diffusion Assay

Fifty specimens were collected from wound patients who visited Al-Hilla Teaching Hospital. The samples were grown on Blood and MacConkey agar for 24-48 hr at 37oC. The bacterial isolates which achieved as a pure and predominant growth from clinical samples as Pseudomonas fluorescens, were identified using morphological properties and Vitek2 system. The anti-bacterial activity of copper oxide nanoparticles (CuO NPs) against was tested by (disk diffusion assay) using dilutions of (400, 200, 100, 50, 25, and 12.5‎µ‎g/ml). The (MIC and MBC) of each isolate was determined. CuO NPs shows wide spectrum antibacterial activity against tested bacteria with rise zone of inhibition diameter that is proportionate with the increase in nanoparticle concentration. The MIC of CuO NPs extended from 100-200‎µ‎g/ml and the MBC ranged from 200-400‎µ‎g/ml. The antibiotic profile was determined by Viteck 2 compact system (Biomérieux). CuO NPs‎ found highly effective and safe in P. fluorescens wounds infections comparing with used antibiotics.

Green synthesis of copper oxide nanoparticles using aloe vera extract

2020 ◽  
Vol 3 (3) ◽  
Author(s):  
Hemalatha D ◽  
Saraswath S
Keyword(s):  
Copper Oxide ◽  
Biomedical Application ◽  
Aloe Vera ◽  
Copper Oxide Nanoparticles ◽  
Klebsiella Pneumonia ◽  
Oxide Nanoparticles ◽  
Cupric Sulfate ◽  
X Ray Diffraction ◽  
Fouriertransform Infrared Spectroscopy ◽  
Effective Use

In material science, green method for synthesis of nanomaterials is feasible, cheaper and eco-friendly protocol. To accomplish this phenomenon, present study was aimed to synthesize Copper oxide nanoparticles using leaf extract of Aloevera with two different precursors CuCl2.2H2O (Cupric chloride) and CuSo4.5H2O (Cupric sulfate). The extraction of Aloevera is employed as reducing and stabilizing agent for this synthesis.Copper oxide Nanoparticles is effective use of biomedical application due to their antibacterial function. The synthesized Copper oxide nanoparticles were characterized by X-Ray Diffraction Spectroscopy (XRD), Energy Dispersive Spectroscopy (EDX), FourierTransform Infrared Spectroscopy (FT- IR) and Scanning Electron Microscope(SEM). XRD studies reveal the crystallographic nature of Copper oxide nanoparticles. Furthermore the Copper oxide nanoparticles have good Antibacterial activity against both gram negative (E.Coli, Klebsiella pneumonia) and gram positive (Bacillus cereus, Staphylococcus aureus)bacteria.

A REVIEW ON POLYMER HEAT SINKS FOR ELECTRONIC COOLING APPLICATIONS

2018 ◽  
Author(s):  
Daniel Borba Marchetto ◽  
Debora Carneiro Moreira ◽  
Gherhardt Ribatski
Keyword(s):  
Electronic Cooling ◽  
Heat Sinks
Sign in / Sign up

Export Citation Format

Share Document