Sensitive Spectrophotometric Method for the Determination of Niguldipine in Pharmaceutical Formulations

2012 ◽  
Vol 2 (9) ◽  
pp. 17-19
Author(s):  
M. Rama Chandraiah ◽  
◽  
Y. V. Rami Reddy
2013 ◽  
Vol 10 (3) ◽  
pp. 965-970
Author(s):  
Baghdad Science Journal

A simple, rapid and sensitive spectrophotometric method has been developed for the determination of captopril in aqueous solution. The method is based on reaction of captopril with 2,3-dichloro 1,4- naphthoquinon(Dichlone) in neutral medium to form a stable yellow colored product which shows maximum absorption at 347 nm with molar absorptivity of 5.6 ×103 L.mole-1. cm-1. The proposed method is applied successfully for determination of captopril in commercial pharmaceutical tablets.


2008 ◽  
Vol 33 (3) ◽  
pp. 7-12 ◽  
Author(s):  
M. A. Gotardo ◽  
L. S. Lima ◽  
R. Sequinel ◽  
J. L. Rufino ◽  
L. Pezza ◽  
...  

A simple, rapid and sensitive spectrophotometric method has been developed for the determination of methyldopa in pharmaceutical formulations. The method is based on the reaction between tetrachloro-p-benzoquinone (p-chloranil) and methyldopa, accelerated by hydrogen peroxide (H2O2), producing a violet-red compound (λmax = 535 nm) at ambient temperature (25.0 ± 0.2 ºC). Experimental design methodologies were used to optimize the measurement conditions. Beer's law is obeyed in a concentration range from 2.10 x 10-4 to 2.48 x 10-3 mol L-1 (r = 0.9997). The limit of detection was 7.55 x 10-6 mol L-1 and the limit of quantification was 2.52 x 10-5 mol L-1. The intraday precision and interday precision were studied for 10 replicate analyses of 1.59 x 10-3 mol L-1 methyldopa solution and the respective coefficients of variation were 0.7 and 1.1 %. The proposed method was successfully applied to the determination of methyldopa in commercial brands of pharmaceuticals. No interferences were observed from the common excipients in the formulations. The results obtained by the proposed method were favorably compared with those given by the Brazilian Pharmacopoeia procedure at 95 % confidence level.


2006 ◽  
Vol 89 (1) ◽  
pp. 46-52 ◽  
Author(s):  
Amr M Badawey ◽  
Samah S Abbas ◽  
Hayam M Loutfy

Abstract A simple and sensitive spectrophotometric method is suggested for analysis of 3 antihistaminic drugs, acrivastine (I), mequitazine (II), and dimethindene maleate (III). The method is based on reaction of the drugs with 7,7,8,8-tetracyanoquinodimethane (TCNQ) in acetonitrile to form highly stable colored products that are measured at 750, 766, and 844 nm for I and II, and 480 and 618 nm for III. Beer's law is obeyed in the ranges of 560 g/mL for I, 550 g/mL for II, and 1070 g/mL for III. The optimum assay conditions and their applicability to the determination of the cited drugs in pharmaceutical formulations are described. The method is statistically analyzed as compared with the European Pharmacopoeia (2001) method for the analysis of dimethindene maleate and reference methods for acrivastine and mequitazine drugs revealing good accuracy and precision.


2009 ◽  
Vol 6 (s1) ◽  
pp. S397-S405 ◽  
Author(s):  
R. Singh Gujral ◽  
S. Manirul Haque ◽  
P. Shanker

A simple and sensitive spectrophotometric method has been proposed for the determination of flucloxacillin sodium. The determination method is based on charge transfer complexation reaction of the drug with iodine in methanol-dichloromethane medium. The absorbance was measured at 362 nm against the reagent blank. Under optimized experimental conditions, Beer's law is obeyed in the concentration ranges 1-9 μg/mL for flucloxacillin. The method was validated for specificity, linearity, precision, accuracy. The degree of linearity of the calibration curves, the percent recoveries, limit of detection and quantitation for the spectrophotometric method were determined. No interferences could be observed from the additives commonly present in the pharmaceutical formulations. The method was successfully applied forin vitrodetermination of human urine samples with low RSD value. This is simple, specific, accurate and sensitive spectrophotometric method.


2009 ◽  
Vol 6 (1) ◽  
pp. 89-92 ◽  
Author(s):  
Alka Gupta ◽  
P. Mishra ◽  
K. Shah

A new, simple and sensitive spectrophotometric method in ultraviolet region has been developed for the determination of rosuvastatin calcium in bulk and in pharmaceutical formulations. Rosuvastatin exhibits absorption maxima at 244 nm with apparent molar absorptivity of 7.2345 ×104L/mol.cm in methanol. Beer’s law was found to be obeyed in the concentration range of 2-18 µg/mL. The method is accurate, precise and economical. This method is extended to pharmaceutical preparations. In this method, there is no interference from any common pharmaceutical additives and diluents. Results of the analysis were validated statistically and by recovery studies


2010 ◽  
Vol 7 (3) ◽  
pp. 785-788 ◽  
Author(s):  
Mohammad Yunoos ◽  
D. Gowri Sankar ◽  
B. Pragati Kumar ◽  
Shahul Hameed ◽  
Azmath Hussain

A new, simple and sensitive spectrophotometric method in ultraviolet region has been developed for the determination of duloxetine hydrochloride in bulk and in pharmaceutical formulations. Duloxetine hydrochloride exhibits absorption maxima at 288 nm with apparent molar absorptivity of 0.97x104L/mol.cm in 0.1 N HCL. Beer's law was found to be obeyed in the concentration range of 5-30 μg/mL. The method is accurate, precise and economical. The proposed method has been applied successfully for the analysis of the drug in pure and in its capsule dosage forms. In this method, there is no interference from any common pharmaceutical additives and diluents. Results of the analysis were validated statistically and by recovery studies.


Author(s):  
Mouhammed Khateeb ◽  
Basheer Elias ◽  
Fatema Al Rahal

A simple and sensitive kinetic spectrophotometric method has been developed for the determination of folic acid (FA) in bulk and pharmaceutical Formulations. The method is based on the oxidation of FA by Fe (III) in sulfuric acid medium. Fe (III) subsequently reduces to Fe (II) which is coupled with potassium ferricyanide to form Prussian blue. The reaction is followed spectrophotometrically by measuring the increase in absorbance at λmax 725 nm. The rate data and fixed time methods were adopted for constructing the calibration curves. The linearity range was found to be 1–20 μg mL-1 for each method. The correlation coefficient was 0.9978 and 0.9993, and LOD was found to be 0.91 and 0.09 μg mL-1 for rate data and fixed time methods, respectively. The proposed method has been successfully applied to the determination of FA in formulations with no interference from the excipients. Statical comparison of the results shows that there is no significant difference between the proposed and pharmacopoeial methods


Sign in / Sign up

Export Citation Format

Share Document