Light-Induced Change of Si-H Bond Absorption in Hydrogenated Amorphous Silicon

1998 ◽  
Vol 507 ◽  
Author(s):  
Guozhen Yue ◽  
Liangfan Chen ◽  
Qi Wang ◽  
Eugene Iwaniczko ◽  
Guanglin Kong ◽  
...  
Keyword(s):  
Glow Discharge ◽  
Amorphous Silicon ◽  
Hydrogen Content ◽  
Hydrogenated Amorphous Silicon ◽  
Wave Number ◽  
Ir Absorption ◽  
Hot Wire ◽  
Induced Changes ◽  
Hydrogenated Amorphous

ABSTRACTDevice-quality a-Si:H films were prepared by glow discharge CVD with pure or H-diluted silane as well as by hot-wire CVD. The hydrogen content was varied from ∼2 to 15 at. %. The Si-H bond absorption and its light-soaking-induced changes were studied by IR and differential IR absorption spectroscopes. The results indicate that the more stable sample exhibits an increase of the absorption at wave number ∼2000 cm−1, and the less stable one exhibits a decrease at ∼2040 cm−1and an increase at ∼1880 cm−1.

Correlation of light‐induced changes with hydrogen content in hydrogenated amorphous silicon films

1991 ◽  
Vol 58 (23) ◽  
pp. 2669-2671 ◽  
Author(s):  
W. A. Nevin ◽  
H. Yamagishi ◽  
M. Yamaguchi ◽  
Y. Tawada
Keyword(s):  
Amorphous Silicon ◽  
Hydrogen Content ◽  
Hydrogenated Amorphous Silicon ◽  
Silicon Films ◽  
Induced Changes ◽  
Hydrogenated Amorphous

Low Hydrogen Content, High Quality Hydrogenated Amorphous Silicon Grown by Hot-Wire CVD

1999 ◽  
Vol 557 ◽  
Author(s):  
Brent P. Nelson ◽  
Richard S. Crandall ◽  
Eugene Iwaniczko ◽  
A. H. Mahan ◽  
Qi Wang ◽  
...  
Keyword(s):  
Substrate Temperature ◽  
Amorphous Silicon ◽  
Hydrogen Content ◽  
Defect Density ◽  
Flow Direction ◽  
Scale Up ◽  
Hydrogenated Amorphous Silicon ◽  
Hot Wire ◽  
High Quality ◽  
Hydrogenated Amorphous

AbstractWe grow hydrogenated amorphous silicon (a-Si:H) by Hot-Wire Chemical Vapor Deposition (HWCVD). Our early work with this technique has shown that we can grow a-Si:H that is different from typical a-Si:H materials. Specifically, we demonstrated the ability to grow a-Si:H of exceptional quality with very low hydrogen (H) contents (0.01 to 4 at. %). The deposition chambers in which this early work was done have two limitations: they hold only small-area substrates and they are incompatible with a load-lock. In our efforts to scale up to larger area chambers—that have load-lock compatibility—we encountered difficulty in growing high-quality films that also have a low H content. Substrate temperature has a direct effect on the H content of HWCVD grown a-Si:H. We found that making dramatic changes to the other deposition process parameters—at fixed substrate temperature and filament-to-substrate spacing—did not have much effect on the H content of the resulting films in our new chambers. However, these changes did have profound effects on film quality. We can grow high-quality a-Si:H in the new larger area chambers at 4 at. % H. For example, the lowest known stabilized defect density of a-Si:H is approximately 2 × 1016 cm-3, which we have grown in our new chamber at 18 Å/s. Making changes to our original chamber—making it more like our new reactor—did not increase the hydrogen content at a fixed substrate temperature and filament-to-substrate spacing. We continued to grow high quality films with low H content in spite of these changes. An interesting, and very useful, result of these experiments is that the orientation of the filament with respect to silane flow direction had no influence on film quality or the H content of the films. The condition of the filament is much more important to growing quality films than the geometry of the chamber due to tungsten-silicide formation on the filament.

Mechanical Spectroscopy Study on the Light Soaking Effect on Hydrogenated Amorphous Silicon

2012 ◽  
Vol 184 ◽  
pp. 416-421 ◽  
Author(s):  
H. Mizubayashi ◽  
I. Sakata ◽  
H. Tanimoto
Keyword(s):  
Internal Friction ◽  
Temperature Dependence ◽  
Amorphous Silicon ◽  
Hydrogenated Amorphous Silicon ◽  
Wide Distribution ◽  
Activation Energies ◽  
Mechanical Spectroscopy ◽  
Induced Changes ◽  
Mild Temperature ◽  
Hydrogenated Amorphous

For hydrogenated amorphous silicon (a-Si:H) films deposited at temperatures between 423 K and 623 K (a-Si:H423Kand so on), the light-induced changes in the internal friction between 80 K and 400 K were studied. The internal friction is associated with H2motion in microvoid networks, and shows the mild temperature dependence between about 80 K and 300 K (Q-180-300K) and the almost linear increase above 300 K (Q-1>300K). BothQ-180-300KandQ-1>300Kdecrease with increasing the deposition temperature, and show the mild temperature dependence ina-Si:H623K. The white light soaking with 100 mW/cm2(WLS100and so on) below 300 K caused a change inQ-180-300Kand no changes inQ-1>300K, respectively, and the light-induced changes inQ-180-300Krecovered after annealing at 423 K. The wide distribution of activation energies for H2motions between microvoids indicate that most of neighboring microvoids are connected through windows, i.e., the microvoid networks are existing ina-Si:H, and the spatially loose or solid structures are responsible for the low or high activation energies for the H2motion between microvoids, respectively. Furthermore, the light-induced hydrogen evolution (LIHE) was observed for WLS200to WLS400in a vacuum between 400 and 500 K, resulting in the disappearance of the internal friction due to the H2motion in the microvoid network.

Optical switching in hydrogenated amorphous silicon–sulfur alloy prepared by glow discharge

2004 ◽  
Vol 345-346 ◽  
pp. 302-305 ◽  
Author(s):  
S. Al-Dallal ◽  
F.Z. Henari ◽  
S.M. Al-Alawi ◽  
S.R. Arekat ◽  
H. Manaa
Keyword(s):  
Glow Discharge ◽  
Amorphous Silicon ◽  
Optical Switching ◽  
Hydrogenated Amorphous Silicon ◽  
Hydrogenated Amorphous
Sign in / Sign up

Export Citation Format

Share Document