Prevention of InP/InGaAs/InP Double Heterojunction Bipolar Transistors from Current Gain Reduction during Passivation

2004 ◽  
Vol 833 ◽  
Author(s):  
Byoung-Gue Min ◽  
Jong-Min Lee ◽  
Seong-Il Kim ◽  
Chul-Won Ju ◽  
Kyung-Ho Lee
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Silicon Oxide ◽  
Surface Recombination ◽  
Surface States ◽  
Bipolar Transistors ◽  
Base Layer ◽  
Current Gain ◽  
Device Structure ◽  
Double Heterojunction ◽  
Gain Reduction

ABSTRACTA significant degradation of current gain of InP/InGaAs/InP double heterojunction bipolar transistors was observed after passivation. The amount of degradation depended on the degree of surface exposure of the p-type InGaAs base layer according to the epi-structure and device structure. The deposition conditions such as deposition temperature, kinds of materials (silicon oxide, silicon nitride and aluminum oxide) and film thickness were not major variables to affect the device performance. The gain reduction was prevented by the BOE treatment before the passivation. A possible explanation of this behavior is that unstable non-stoichiometric surface states produced by excess In, Ga, or As after mesa etching are eliminated by BOE treatment and reduce the surface recombination sites.

High-Power Characteristics of GaN/InGaN Double Heterojunction Bipolar Transistors with a Regrown p-InGaN Base Layer

2003 ◽  
Vol 798 ◽  
Author(s):  
Toshiki Makimoto ◽  
Yoshiharu Yamauchi ◽  
Kazuhide Kumakura
Keyword(s):  
High Power ◽  
Heterojunction Bipolar Transistors ◽  
Bipolar Transistors ◽  
Base Layer ◽  
Collector Current ◽  
Power Characteristics ◽  
Low Leakage ◽  
Low Leakage Current ◽  
Double Heterojunction ◽  
Extrinsic Base

ABSTRACTWe have investigated high-power characteristics of GaN/InGaN double heterojunction bipolar transistors on SiC substrates grown by metalorganic vapor phase epitaxy. The p-InGaN extrinsic base layers were regrown to improve ohmic characteristics of the base. Base-collector diodes showed low leakage current at their reverse bias voltages due to a wide bandgap of a GaN collector, resulting in a high-voltage transistor operation. A 90 μm × 50 μm device operated up to a collector-emitter voltage of 28 V and a collector current of 0.37 A in its common-emitter current-voltage characteristics at room temperature, which corresponds to a DC power of 10.4 W. A collector current density and a power density are as high as 8.2 kA/cm2 and 230 kW/cm2, respectively. These results show that nitride HBTs are promising for high-power electronic devices.

scholarly journals Investigation of the static current gain for InP/InGaAs single heterojunction bipolar transistor

2019 ◽  
Vol 13 (3) ◽  
pp. 1345
Author(s):  
Jihane Ouchrif ◽  
Abdennaceur Baghdad ◽  
Aicha Sshel ◽  
Abdelmajid Badri ◽  
Abdelhakim Ballouk
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Communication Systems ◽  
Bipolar Transistors ◽  
Bipolar Transistor ◽  
Heterojunction Bipolar Transistor ◽  
Current Gain ◽  
Technological Parameters ◽  
Device Structure ◽  
Optimal Values ◽  
Output Characteristics

<p>Heterojunction Bipolar Transistors are being used increasingly in communication systems due to their electrical performances. They are considered as excellent electronic devices. This paper presents an investigation of the static current gain β based on two technological parameters related to the device geometry for InP/InGaAs Single Heterojunction Bipolar Transistor (SHBT). These parameters are the base width  and the emitter length . We used Silvaco’s TCAD tools to design the device structure, and to extract the static current gain β from I-V output characteristics figures. According to this investigation, we determined the optimal values of the examined parameters which allow obtaining the highest static current gain β.</p>

scholarly journals A GaN/4H-SiC heterojunction bipolar transistor with operation up to 300°C

1999 ◽  
Vol 4 (1) ◽  
Author(s):  
John T Torvik ◽  
M. Leksono ◽  
J. I. Pankove ◽  
B. Van Zeghbroeck
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Room Temperature ◽  
Chemical Vapor ◽  
Bipolar Transistors ◽  
Heterojunction Bipolar Transistor ◽  
Current Gain ◽  
Device Structure ◽  
Fabrication And Characterization ◽  
Dc Current

We report on the fabrication and characterization of GaN/4H-SiC n-p-n heterojunction bipolar transistors (HBTs). The device structure consists of an n-SiC collector, p-SiC base, and selectively grown n-GaN emitter. The HBTs were grown using metalorganic chemical vapor deposition on SiC substrates. Selective GaN growth through a SiO2 mask was used to avoid damage that would be caused by reactive ion etching. In this report, we demonstrate common base transistor operation with a modest dc current gain of 15 at room temperature and 3 at 300°C.

High-Current-Gain Direct-Growth GaN/InGaN Double Heterojunction Bipolar Transistors

2010 ◽  
Vol 57 (11) ◽  
pp. 2964-2969 ◽  
Author(s):  
Yi-Che Lee ◽  
Yun Zhang ◽  
Hee-Jin Kim ◽  
Suk Choi ◽  
Zachary Lochner ◽  
...  
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Bipolar Transistors ◽  
Current Gain ◽  
High Current ◽  
Double Heterojunction ◽  
Direct Growth

Shallow and Low-Resistive Ohmic Contacts to p-In0.53Ga0. 47As Based on Pd/Au and Pd/Sb Metallizations

1996 ◽  
Vol 427 ◽  
Author(s):  
P. Ressel ◽  
L. C. Wang ◽  
M. H. Park ◽  
P. W. Leech ◽  
G. K. Reeves ◽  
...  
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Ohmic Contacts ◽  
Bipolar Transistors ◽  
Base Layer ◽  
Current Gain ◽  
Depth Of Penetration ◽  
Annealing Conditions ◽  
Small Base ◽  
20 Nm ◽  
Contact Resistivities

AbstractInP/In0.53Ga0.47As heterojunction bipolar transistors with high current gain for optoelectronic applications place stringent requirements on the ohmic contact to the base layer of moderately doped (p < 1×1019 cm−3) In0.53Ga0.47As. Contact resistivity should be <l×10−6 Ωcm2 and low depth of penetration is necessary considering the small base thickness of approximately 100 nm. The authors have recently presented data on Pd/Zn/Au/LaB6/Au contacts on p-In0.53Ga0.47As (doped to 4×1018 cm−3) with low contact resistivities of l×10−6 Ωcm2. In this paper, details are given on the optimization of the contact composition and annealing conditions of the metallization that resulted in shallow and low-resistive contacts. Alternatively, it is shown that Au-free Pd/Zn/Sb/Pd contacts on p-In0.53Ga0.47As have exhibited even lower resistivities, i.e. 3-6×10−7 Ωcm2. Backside SIMS measurements revealed a depth of penetration as low as 20 nm for this contact scheme. Aging tests at temperatures of 300 - 400 °C have demonstrated that the electrical characteristics of both types of metallization were sufficiently stable to withstand the typical processing steps for device passivation.

Sign in / Sign up

Export Citation Format

Share Document