scholarly journals A highly sensitive wide-range weak current detection circuit for implantable glucose monitoring

2016 ◽  
Vol 13 (8) ◽  
pp. 20150616-20150616 ◽  
Author(s):  
Xi Tan ◽  
Sizheng Chen ◽  
Xiao Yan ◽  
Yibo Fan ◽  
Hao Min ◽  
...  
2013 ◽  
Vol 313-314 ◽  
pp. 304-307
Author(s):  
Sheng Qian Ma ◽  
Man Hong Fan

The existing micro current detecting apparatus is of large size and is manual controlled. When the detected currents sensitivity is higher, however, stability will be worse. In order to solve this problem, an adaptive detection system is proposed in this paper. The system designed a micro current signal detection circuit based on OK6410 embedded with development board. The Weak current signal is collected with the high precision ADC. Automatic adjustment circuit gain is from 1 to 10000. Spectrometer wavelength size is changed in real-time. Current resolution can reach nA. The experimental results show that this system can collect the micro current effectively. The main characteristics of the system are simple circuit structure, small volume, high degree of automation, and strong reliability, and it greatly improves the anti-interference performance of the circuit. The system can not only be applied in electrochemical current detection, but also be widely used in weak signal detection.


2011 ◽  
Vol 403-408 ◽  
pp. 2569-2572
Author(s):  
Xia Sun ◽  
Xiang You Wang ◽  
Shu Yuan Du ◽  
Ying Zhu

In this paper, a weak current detection circuit is designed for developing organophosphorous pesticides rapid detection portable instrument. The detection principle is based on the electrochemical characteristic of enzyme catalyzing substrate of acetylcholinesterase biosensor for detecting pesticide residues. Based on the behavior of cyclic voltammograms (CV) of the acetylcholinesterase biosensor, the data acquisition and processing circuit of the weak current signals generated by the biosensor is designed, which including the I/V conversion, differential amplification , low-pass filter, A/D conversion etc. Eventually, the 0~5V voltage signal are obtained and they are proportional to the weak current from the enzyme biosensor. The designed detection circuit has a good consistence compared with electrochemical analysis instrument, which can establish a good base for developing organophosphorous pesticides rapid detection portable instrument.


2011 ◽  
Vol 25 (8) ◽  
pp. 711-715 ◽  
Author(s):  
Shujiang Yan ◽  
Fei Tang ◽  
Xiaohao Wang ◽  
Fan Wang ◽  
Tao Yang

Synthesis ◽  
2021 ◽  
Author(s):  
Alexandre Desaintjean ◽  
Fanny Danton ◽  
Paul Knochel

A wide range of polyfunctionalized di(hetero)aryl- and dialkenyl-magnesium reagents were prepared in toluene within 10 to 120 min between −78 °C and 25 °C via an I/Mg- or Br/Mg-exchange reaction using reagents of the general formula R2Mg (R = sBu, Mes). Highly sensitive functional groups, such as a triazene or a nitro group, were tolerated in these exchange reactions, enabling the synthesis of various functionalized (hetero)arenes and alkenes derivatives after quenching with several electrophiles including allyl bromides, acyl chlorides, aldehydes, ketones, and aryl iodides.


Micromachines ◽  
2021 ◽  
Vol 12 (3) ◽  
pp. 279
Author(s):  
Kentaro Noda ◽  
Jian Sun ◽  
Isao Shimoyama

A tensor sensor can be used to measure deformations in an object that are not visible to the naked eye by detecting the stress change inside the object. Such sensors have a wide range of application. For example, a tensor sensor can be used to predict fatigue in building materials by detecting the stress change inside the materials, thereby preventing accidents. In this case, a sensor of small size that can measure all nine components of the tensor is required. In this study, a tensor sensor consisting of highly sensitive piezoresistive beams and a cantilever to measure all of the tensor components was developed using MEMS processes. The designed sensor had dimensions of 2.0 mm by 2.0 mm by 0.3 mm (length by width by thickness). The sensor chip was embedded in a 15 mm3 cubic polydimethylsiloxane (PDMS) (polydimethylsiloxane) elastic body and then calibrated to verify the sensor response to the stress tensor. We demonstrated that 6-axis normal and shear Cauchy stresses with 5 kPa in magnitudes can be measured by using the fabricated sensor.


2018 ◽  
Vol 64 (4) ◽  
pp. 656-679 ◽  
Author(s):  
Jeffrey D Freeman ◽  
Lori M Rosman ◽  
Jeremy D Ratcliff ◽  
Paul T Strickland ◽  
David R Graham ◽  
...  

Abstract BACKGROUND Advancements in the quality and availability of highly sensitive analytical instrumentation and methodologies have led to increased interest in the use of microsamples. Among microsamples, dried blood spots (DBS) are the most well-known. Although there have been a variety of review papers published on DBS, there has been no attempt at describing the full range of analytes measurable in DBS, or any systematic approach published for characterizing the strengths and weaknesses associated with adoption of DBS analyses. CONTENT A scoping review of reviews methodology was used for characterizing the state of the science in DBS. We identified 2018 analytes measured in DBS and found every common analytic method applied to traditional liquid samples had been applied to DBS samples. Analytes covered a broad range of biomarkers that included genes, transcripts, proteins, and metabolites. Strengths of DBS enable its application in most clinical and laboratory settings, and the removal of phlebotomy and the need for refrigeration have expanded biosampling to hard-to-reach and vulnerable populations. Weaknesses may limit adoption in the near term because DBS is a nontraditional sample often requiring conversion of measurements to plasma or serum values. Opportunities presented by novel methodologies may obviate many of the current limitations, but threats around the ethical use of residual samples must be considered by potential adopters. SUMMARY DBS provide a wide range of potential applications that extend beyond the reach of traditional samples. Current limitations are serious but not intractable. Technological advancements will likely continue to minimize constraints around DBS adoption.


Nanomaterials ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 768
Author(s):  
Hyung-Mo Kim ◽  
Chiwoo Oh ◽  
Jaehyun An ◽  
Seungki Baek ◽  
Sungje Bock ◽  
...  

Exosomes are attracting attention as new biomarkers for monitoring the diagnosis and prognosis of certain diseases. Colorimetric-based lateral-flow assays have been previously used to detect exosomes, but these have the disadvantage of a high limit of detection. Here, we introduce a new technique to improve exosome detection. In our approach, highly bright multi-quantum dots embedded in silica-encapsulated nanoparticles (M–QD–SNs), which have uniform size and are brighter than single quantum dots, were applied to the lateral flow immunoassay method to sensitively detect exosomes. Anti-CD63 antibodies were introduced on the surface of the M–QD–SNs, and a lateral flow immunoassay with the M–QD–SNs was conducted to detect human foreskin fibroblast (HFF) exosomes. Exosome samples included a wide range of concentrations from 100 to 1000 exosomes/µL, and the detection limit of our newly designed system was 117.94 exosome/μL, which was 11 times lower than the previously reported limits. Additionally, exosomes were selectively detected relative to the negative controls, liposomes, and newborn calf serum, confirming that this method prevented non-specific binding. Thus, our study demonstrates that highly sensitive and quantitative exosome detection can be conducted quickly and accurately by using lateral immunochromatographic analysis with M–QD–SNs.


Author(s):  
Navaneeth Punnakkal ◽  
Jeethu Raveendran ◽  
Suneesh Punathil Vasu ◽  
Bipin G Nair ◽  
T G Satheesh Babu

Sign in / Sign up

Export Citation Format

Share Document