An Automated System for Determining the Optimal Conditions of Industrial Waste Fermentative Biodegradation

2018 ◽  
Vol 22 (12) ◽  
pp. 44-47
Author(s):  
D.V. Zubov

The task of automated searching for the optimal conditions of cellulose-containing waste fermentative biodegradation process has been considered. It has been proposed to use the system of lysed zone optical recognition to determine the ferment strength, and a software and hardware complex providing simultaneous comparison of several strains has been developed. The system of selecting the most effective decomposer and biodegradation conditions has been created. The proposed system may be used for optimization of cultivating the wide array of microorganisms, especially in conditions of frequent changing initial substrate sources.

2020 ◽  
Vol 4 (97) ◽  
pp. 41-53
Author(s):  
MICHAIL A. RAZVODOV ◽  
DMITRII N. KOSTYLEV

Fires, accidents and incidents of various types require rapid localization, elimination and therefore full information about emergencies. In these conditions, there is an urgent task to develop and implement an automated system that allows accounting and analyzing fire data. The authors consider a software and hardware complex for automating the process of recording and analysis of fire data on the territory of the Vologda region. Applying the method of functional modeling, weak points of information transmission were identified; the system of operational dispatching control “SODU - Vologda” was developed. The proposed data collection system would improve the organization of activities aimed at involving forces and means in the event of an emergency.


2010 ◽  
Vol 69 (17) ◽  
pp. 1517-1527 ◽  
Author(s):  
Ye. N. Belov ◽  
O. A. Voytovich ◽  
T. A. Makulina ◽  
G. A. Rudnev ◽  
G. I. Khlopov ◽  
...  

Author(s):  
S. V. Grigorieva ◽  
A. V. Olshansky

The article is devoted to the problems of maintenance of overhead power lines in the Far North of Western Siberia. For improvement of quality and reliability of power supply of consumers in the conditions of the Far North of Western Siberia, decrease in operational costs and volumes of the carried-out emergency works the hardware-software complex for expeditious inspection, assessment and forecasting of change of technical condition of constructive part of air lines (VL) of 35-220 kV is developed, the structure of the hardware-software complex of registration of the condition of constructive part of VL of 35-220 kV and structure of the hardware-software complex of storage., processing and analysis of the obtained data on the States of the constructive part of the VL 35-220 kV. 


2020 ◽  
Vol 15 (6) ◽  
pp. 795-801
Author(s):  
N. V. Aksenova ◽  
A. A. Nizov ◽  
O. N. Selyavina ◽  
E. I. Suchkova ◽  
E. V. Filippov

Aim. To study the effectiveness and benefits of blood pressure (BP) remote monitoring in outpatients with hypertension.Material and methods. The study included 100 patients with a verified diagnosis of hypertension, who didn’t achieve target BP pressure levels. The patients measured their BP twice a day over 6 months with facilities with automatic data transmission over GSM-channel to a remote monitoring center. BP parameters were being transmitted online to the remote monitoring center, where they were being processed and transferred to the personal account planner (created by the Web interface based on the software and hardware complex) of the attending physician and operator of the remote monitoring center. It is important that doctor received information only on clinically significant measurement results, based on which he determined the urgency of contact with the patient and the further tactics of his management.Results. No malfunctions in the work of communication facilities, technical failures in the software and hardware complex were registered over the entire period of the study. After 6 months of the monitoring it was possible to achieve target BP levels less than 135/85 mm Hg in 70% of patients. The proportion of patients with a high level of normal BP increased from 10% to 19%, while the proportion of patients with grade 1 and 2 of hypertension decreased significantly (from 33% to 7% and from 54% to 3%, respectively). At the beginning of telemedicine monitoring 3% of patients had stage 3 of hypertension, at the end of the study – 1%.Conclusion. The technology of telemedicine monitoring has shown itself as a simple, affordable and reliable way of management of outpatients with hypertension in conditions of real clinical practice. It was possible to achieve BP levels less than 135/85 mm Hg in 70% of patients by the method of remote outpatient monitoring. BP remote monitoring changed fundamentally the decision-making strategy of the patients management: it was not the patient who independently determined the need for consultation with a medical professional, but the attending physician made a decision on the method and urgency of contact with the patient on the basis of the data of objective monitoring indicators.


2020 ◽  
Vol 5 (5(74)) ◽  
pp. 67-71
Author(s):  
N.V. Suharev

Problem statement: Currently, there is a need in the space industry to actively improve the characteristics of battery batteries, the use of new types of batteries for power supply systems of spacecraft leads to a constant demand to improve the control and verification equipment (CPA). Depending on the improvement of storage batteries (AB) for spacecraft, the requirements for electrical inspections and control and verificationequipment were gradually changed. With the advent of lithium-ion batteries for spacecraft, there was a need to develop and manufacture a charge-discharge hardware and software complex (ZRPAK). The charge-discharge hardware-software complex designed to work as a charger-bit complex to work with AB spacecraft for all ground operation phases, to verify compliance of the electrical characteristics of the AB to the specified requirements, conduct incoming inspection and Autonomous tests of AB on the manufacturer of the spacecraft. The advantages and disadvantages of the previously developed and currently used control and verification equipment are analyzed. The electrical characteristics of the KPA of all generations of development are summarized in the table. Based on the analysis of the development of batteries, trends in the development of control and verification equipment and the fact that all spacecraft of new developments will use only lithium-ion batteries, the requirements for a promising fifth-generation ZRPAK are formulated. The following requirements are applied to the fifth-generation charge-discharge software and hardware complex: increase the charge-discharge voltage to 150 V; increase the charge -discharge current to 150 A; introduce devices for pre-charge-pre-discharge of the battery into the KPA; increase the accuracy of measuring the voltage of each battery; provide remote operation from the control PC; writing cyclograms; logging and subsequent viewing of all test data


Author(s):  
Алексей Горлов ◽  
Aleksey Gorlov ◽  
Михаил Рытов ◽  
Mikhail Rytov ◽  
Дмитрий Лысов ◽  
...  

This article discusses the process of automating the assessment of the effectiveness of software and hardware information protection by creating an automated system. The main functions of the proposed system are: conducting an audit of information security, forming a model of information security threats, forming recommendations for creating a software and hardware system for protecting information, and creating organizational-technical documentation. The developed automated system for evaluating the effectiveness of software and hardware protection of information allows in an automated way to build a model of information security threats, to form organizational and technical documentation governing the protection of confidential information, and also to make recommendations for improving the software and hardware system for protecting information. The use of this system will significantly reduce the time and material costs of auditing information security and developing additional measures to protect information.


2012 ◽  
Vol 455-456 ◽  
pp. 1339-1344 ◽  
Author(s):  
Zhe Qi Li ◽  
Jing Yu Liu

Photodegradation ofp-nitrophenol catalyzed by ZnO/MWCNTs composite in water was investigated. The effects of pH, irradiation time, catalyst loading, initial substrate concentration and MWCNTs content on the degradation were investigated. Experiment results revealed that the optimal conditions were ap-nitrophenol concentration of 60.0 mg/L at pH 5.0 with catalyst loading of 10.0 g/L under solar irradiation for the illumination of 180 min. The highest efficiency on photodegradation ofp-nitrophenol can be achieved with an optimal MWCNTs/ZnO mass ratio of 0.16%. Possible decomposing mechanisms were also discussed. The repeatability of photocatalytic activity was tested. The photocatalyst was used ten cycles with degradation efficiency still higher than 95%. The results of the study showed the feasible and potential use of ZnO/MWCNTs composite in degradation of toxic organic pollutants.


Author(s):  
Y.S. Nurakhov ◽  
A.E. Kami

The article presents the development of an information system for recognizing voice into text for people with hearing impairments, which makes it possible to improve the quality of life and interaction in society with other people. The device, software, functional blocks and subsystems of the information system are described. Examples of possible application and placement of the system in various spheres of public life are given. One of the types of implementation of the voice recognition information system is described. The development and creation of prototypes of a device for people with hearing impairments is considered. In the course of the research, the Google Speech Api technology was selected for speech recognition. In addition, this article presents a software and hardware complex that allows you to translate speech into text and then display it on the screen. Arduino UNO-based devices were chosen to achieve the goal. All information is processed on the smartphone of people with hearing impairments, which is sent to the device via Bluetooth with Arduino.


Sign in / Sign up

Export Citation Format

Share Document