Electrochemical Neutralization of Acidic Industrial Effluents

2021 ◽  
Vol 25 (9) ◽  
pp. 15-17
Author(s):  
O.P. Filippova ◽  
S.Z. Kalayeva ◽  
N.L. Markelova ◽  
E.A. Korolyova

An electrochemical method for neutralizing "acidic" industrial effluents is presented. The dependences of the electrical conductivity of industrial water on the neutralization time on platinum and steel electrodes are compared.

Author(s):  
Md. Rafiqul Islam ◽  
Golam Kibria Muhammad Mustafizur Rahman ◽  
Md. Abu Saleque

A laboratory experiment was conducted in Soil Science Division of Bangladesh Rice Research Institute (BRRI) during 2010-11 aimed to determine the effects of different industrial effluents on some soil chemical properties under long-term industrial wastewater irrigated rice field. Effluents irrigation created some differences in soil pH, electrical conductivity and organic carbon. The pH in all soil depth was higher with wastewater irrigated rice field. Irrigation with wastewater increased in all the effluents irrigated rice fields; the electrical conductivity (EC) was remarkable higher with  all soil depth than the control field. In all the rice fields soil (Control + effluents irrigated fields), the organic carbon content (%) started to decrease sharply with the increase in soil depth. Organic carbon content was slightly higher with wastewater irrigated rice soils. Exchangeable cations (Ca, Mg, K and Na), trace elements (Zn, Fe, Mn and Cu) and heavy metals (Pb, Cd, Cr and Ni) were increased through irrigation with wastewater in rice–rice cropping pattern.


2011 ◽  
Vol 233-235 ◽  
pp. 2760-2764 ◽  
Author(s):  
Inas M. Alnashef

The solubility of different commercially available sodium salts was measured at 120°C for the potential use in the production of sodium metal by electrochemical processes in Ionic liquids (ILs) at relatively moderate temperatures. The results showed that the anion, cation, and substituents on the cation of the IL have a great effect on the solubility of the salts. It was found that the solubility of the salts in some ILs is higher than the value required in the production of sodium metal. An electrochemical method was used to measure the electrical conductivity of the selected ILs. Moreover, the effect of sodium salts on the conductivity of the ILs was studied. The conductivity of IL increased with the dissolution of sodium salts. In general, the conductivity of the studied ILs with/without sodium salts was suitable for the use in the production of metal sodium.


Author(s):  
Yaroslav KOVALYSHYN ◽  
◽  
Ivanna TERENYAK ◽  
Orest PEREVIZNYK ◽  
◽  
...  

Modified thermally exfoliated graphite with p-nitrophenyldiazonium tetrafluoroborate, followed by reduction of nitrophenyl groups to aminophenyl ones. Composites PAN - graphite, PAN - modified graphite at a constant value of potential 1 V were synthesized by electrochemical method. Their conditional density and electrical conductivity were determined. The electrochemical behavior in 1 M HCl solution was investigated and the capacity of synthesized composites was calculated. The conditional density of PAN composites with modified and non modified graphite increases sharply with increasing graphite content from 0 to 5%. At graphite contents higher than 5%, the density of composites varies very slightly. In the range of graphite contents 0% - 20%, the density is the highest for composites with a graphite content of 5% - 10%. In the case of modified graphite, the density of composites is higher than that of composites with non modified graphite. Analysis of the dependence of the specific conductivity on the content of modified graphite indicates that the conductivity of PAN - graphite composites increases the most with increasing graphite content from 1 to 10%. In this interval, the conductivity increases linearly. This indicates the absence of specific interactions between the components in the synthesized composites, as well as the fact that the nature of the distribution of these components does not change with changes in the graphite content. For a composite with modified graphite, there are two maximum capacities of composites with a graphite content of 2 and 10%. For a composite with non modified graphite on the obtained curves there is a maximum capacity of composites with a graphite content of 2%. Modification of the graphite surface leads to increased interaction between the components of the compo¬site, which resulted in the compaction of its structure. As a result, the capacitive characteristics of modified graphite composites, as well as CVA currents and electrical conductivity, were lower compared to composites with non modified graphite.


Author(s):  
Dr. Hemant K. Chitte ◽  

Polymerization of pyrrole using various methods like pyrrole using electrochemical method and UV Photo irradiation has been investigated. Fourier transform infrared spectroscopy (FTIR), Scanning electron microscopy (SEM), X-ray diffraction (XRD) techniques were used to study the internal structure, material morphology, chemical nature of conducting polymers. The temperature dependence of the electrical conductivity of the Polypyrrole, Their behavior resemble the metallic conductors.


2013 ◽  
Vol 6 (1) ◽  
pp. 111-124 ◽  
Author(s):  
N. Amin ◽  
M. Ayaz ◽  
S. Alam ◽  
S. Gul

Industrial effluents mixed water used for irrigation in vegetable growing area was tested for its heavy metal contents using Atomic Absorption Spectrophotometry. Sixteen water samples from different industrial outlets were collected and analyzed for different physical and chemical parameters such as temperature, electrical conductivity, pH, total dissolved solids and heavy metals, in the year 2011. The results showed Cu to be in the range of 0.102-0.260, Co 0.021-0.195, Fe 0.191-0.330, Pb 0.117-0.330, Cr 0.024-0.121, Mn 0.053-0.234, Zn 0.090-0.165 and Ni as 0.019-0.074 ppm. The overall metal concentration in the studied samples was in the order of Fe>Pb>Cu>Mn>Co>Zn>Cr>Ni (p < 0.05). pH was in the range of 3.1-8.7 and electrical conductivity was 325 to 1515 ms/cm. As all values were found to be increasing towards pollution limits, industrial effluents need a continuous monitoring and proper management before their discharge in order to reduce the future hazards in reference to aquatic and human life.  Keywords: Industrial effluents; Irrigation water; Heavy metals; Pollution.  © 2014 JSR Publications. ISSN: 2070-0237 (Print); 2070-0245 (Online). All rights reserved.   doi: http://dx.doi.org/10.3329/jsr.v6i1.16336 J. Sci. Res. 6 (1), 111-124 (2014)          


Sign in / Sign up

Export Citation Format

Share Document