Real-Time 3D Ultra Deep Directional Electromagnetic LWD Inversions: An Innovative Approach for Geosteering and Geomapping Water Slumping Movement Around Sub-Seismic Fault, Onshore Abu Dhabi

An Ultra-Deep Directional Electromagnetic LWD Resistivity (UDDE) tool was deployed in a mature Lower Cretaceous carbonate reservoir to map injection water movement. These thick carbonate reservoirs experience injection water preferentially travelling laterally at the top of the reservoir. The water held above oil by negative capillary forces slumps quickly, leading to increasing water cut, eventually killing the natural lift horizontal producing well. Real time 3D and 1D inversions provided important accurate mapping of the non-uniform water fronts and reservoir boundaries, providing insights into reservoir architecture and water movement. The candidate well is located in an area of significant uncertainty regarding fluid distribution and structural elements like sub-seismic faults etc. Pre-well 1D inversion results indicated that the water slumping front away from wellbore can be mapped within a vertical radius of 60-100 ft TVD. However, 1D inversion is not accurate where steeply dipping or discontinuous formations exist due to the presence of faults and is expected to impact well placement, mapping water fronts / formation boundaries and long-term oil recovery. Therefore in the real time, full 3D and 1D inversions of the Ultra-Deep EM data were run to provide high quality reservoir imaging in this complex geometrical setting and deliver improved reservoir fluid distribution and structure mapping. The pre-well inversion modeling optimized the frequency and transmitter-receiver spacing of the UDDE tool. The bottom hole assembly (BHA) configuration also included conventional LWD tools such as Neutron-Density, propagation Resistivity and Gamma Ray. Multiple 3D inversion datasets were processed in real-time using different depths of inversion ranging from 50 ft up to 120 ft depth. The 3D inversion results during the real-time drilling operation detected the non-uniform waterfront boundaries and water slumping up to 80 ft TVD above the wellbore using a slimhole (4¾″) tool. An interpreted sub-seismic down-thrown fault was mapped which controlled the non-uniform slumping fluid distribution, causing the water front to approach closest to the wellbore in this location. This suggests that the fault zone is open and provides a degree of increased permeability around the plane of the fault. The real-time 3D inversion, 1D shallow and 1D deep inversion results showed comparable structural imaging despite being inverted independently of each other. These results permitted updates to the static / dynamic reservoir models and an optimization of the completion design, to delay the water influx and thereby sustain oil production for a longer period of time. Field wide implementation of the UDDE tool and its advanced technology with improved 1D and 3D inversion results will enhance the quality of realtime geosteering, mapping and updating of reservoir models which have challenging water slumping fronts and structural variations. This will enable improvment in well locations, their spacing and finally allowing the proactive design of smart completions for enhanced oil production and improved recovery factors.