Ten years of industrial and municipal membrane bioreactor (MBR) systems – lessons from the field

2014 ◽  
Vol 70 (2) ◽  
pp. 279-288 ◽  
Author(s):  
Asun Larrea ◽  
Andre Rambor ◽  
Malcolm Fabiyi
Keyword(s):  
Wastewater Treatment ◽  
Industrial Wastewater ◽  
Municipal Wastewater ◽  
Membrane Bioreactors ◽  
Operating Conditions ◽  
Industrial Plant ◽  
Municipal Wastewater Treatment ◽  
Design Data ◽  
Wide Range ◽  
Process Controls

The use of membrane bioreactors (MBRs) in activated sludge wastewater treatment has grown significantly in the last decade. While there is growing awareness and knowledge about the application of MBR technology in municipal wastewater treatment, not much information is available on the application of MBRs in industrial wastewater treatment. A comparative study of design data, operating conditions and the major challenges associated with MBR operations in 24 MBR plants treating both municipal and industrial wastewater, built by and/or operated by Praxair, Inc., is presented. Of the 24 MBR systems described, 12 of the plants used high purity oxygen (HPO). By enabling a wide range of food/microorganism ratios and loading conditions in the same system, HPO MBR systems can extend the options available to industrial plant operators to meet the challenges of wide fluctuations in organic loading and footprint limitations. While fouling in industrial MBR systems can be an issue, adequate flux and permeability values can be reliably maintained by the use of good maintenance strategies and effective process controls (pretreatment, cleaning and membrane autopsies).

Membrane Bioreactors for Municipal Wastewater Treatment

2015 ◽  
Vol 4 (0) ◽  
pp. 9781780402925-9781780402925
Author(s):  
H. van der Roest ◽  
D. Lawrence ◽  
A. van Bentem
Keyword(s):  
Wastewater Treatment ◽  
Municipal Wastewater ◽  
Membrane Bioreactors ◽  
Municipal Wastewater Treatment

Nanofiltration of endocrine disrupting compounds

2003 ◽  
Vol 3 (5-6) ◽  
pp. 321-327 ◽  
Author(s):  
M. Gallenkemper ◽  
T. Wintgens ◽  
T. Melin
Keyword(s):  
Wastewater Treatment ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Endocrine Disrupting Compounds ◽  
Municipal Wastewater Treatment ◽  
Water And Wastewater Treatment ◽  
Wide Range ◽  
Endocrine Disrupting ◽  
Municipal Wastewater Treatment Plants ◽  
Set Up

Endocrine disrupting compounds can affect the hormone system in organisms. A wide range of endocrine disrupters were found in sewage and effluents of municipal wastewater treatment plants. Toxicological evaluations indicate that conventional wastewater treatment plants are not able to remove these substances sufficiently before disposing effluent into the environment. Membrane technology, which is proving to be an effective barrier to these substances, is the subject of this research. Nanofiltration provides high quality permeates in water and wastewater treatment. Eleven different nanofiltration membranes were tested in the laboratory set-up. The observed retention for nonylphenol (NP) and bisphenol A (BPA) ranged between 70% and 100%. The contact angle is an indicator for the hydrophobicity of a membrane, whose influence on the permeability and retention of NP was evident. The retention of BPA was found to be inversely proportional to the membrane permeability.

A practitioner’s perspective on the application and research needs of membrane bioreactors for municipal wastewater treatment

2012 ◽  
Vol 122 ◽  
pp. 2-10 ◽  
Author(s):  
Jeremy T. Kraemer ◽  
Adrienne L. Menniti ◽  
Zeynep K. Erdal ◽  
Timothy A. Constantine ◽  
Bruce R. Johnson ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Municipal Wastewater ◽  
Membrane Bioreactors ◽  
Research Needs ◽  
Municipal Wastewater Treatment

scholarly journals Long-Term Investigation into the Membrane Fouling Behavior in Anaerobic Membrane Bioreactors for Municipal Wastewater Treatment Operated at Two Different Temperatures

Membranes ◽  
2020 ◽  
Vol 10 (9) ◽  
pp. 231
Author(s):  
Yi Ding ◽  
Zhansheng Guo ◽  
Zhenlin Liang ◽  
Xuguang Hou ◽  
Zhipeng Li ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Activated Sludge ◽  
Membrane Fouling ◽  
Municipal Wastewater ◽  
Membrane Bioreactors ◽  
Municipal Wastewater Treatment ◽  
Sludge Flocs ◽  
Microbial Product ◽  
Anaerobic Membrane Bioreactors ◽  
Sludge Particle

In this study, the characteristics of activated sludge flocs were investigated and their effects on the evolution of membrane fouling were considered in the anaerobic membrane bioreactors (AnMBR), which were operated at 25 and 35 °C for municipal wastewater treatment. It was found that the membrane fouling rate of the AnMBR at 25 °C was more severe than that at 35 °C. The membrane fouling trends were not consistent with the change in the concentration of soluble microbial product (SMP). The larger amount of SMP in the AnMBR at 35 °C did not induce more severe membrane fouling than that in the AnMBR at 25 °C. However, the polysaccharide and protein concentration of extracellular polymeric substance (EPS) was higher in the AnMBR at 25 °C in comparison with that in the AnMBR at 35 °C, and the protein/polysaccharide ratio of the EPS in the AnMBR at 25 °C was higher in contrast to that in the AnMBR at 35 °C. Meanwhile, the fouling tendencies measured for the AnMBRs could be related to the characteristics of loosely bound EPS and tightly bound EPS. The analysis of the activated sludge flocs characteristics indicated that a smaller sludge particle size and more fine flocs were observed at the AnMBR with 25 °C. Therefore, the membrane fouling potential in the AnMBR could be explained by the characteristics of activated sludge flocs.

Applications and limitations of ADM 1 in municipal wastewater solids treatment

2006 ◽  
Vol 54 (4) ◽  
pp. 77-82 ◽  
Author(s):  
B.R. Johnson ◽  
Y. Shang
Keyword(s):  
Wastewater Treatment ◽  
Municipal Wastewater ◽  
Metal Phosphate ◽  
Municipal Wastewater Treatment ◽  
Digested Sludge ◽  
Chemical Equilibria ◽  
Actual Operating ◽  
Wide Range ◽  
Treatment Facilities ◽  
Inorganic Reactions

The ADM 1 model has been implemented in a steady-state whole wastewater plant simulator. The ADM 1 model has been in use with good success for approximately 2 years on a wide range of wastewater treatment facilities. However, a number of modifications were necessary to allow it to be used in the context of municipal wastewater treatment. It was found that the model's use was greatly simplified if used in conjunction with a larger plant simulator to assist in the feed fractionation. It was also found that a better fit to actual operating data was achieved if some of the slowly biodegradable particulate fraction was partitioned into ADM particulate fractions other than the composite fraction. Another significant limitation of the model is in the absence of phosphorus modeling. The ADM model needs to have phosphorus handling for all the relevant fractions, and needs to include the handling of inorganic reactions such as struvite precipitation and metal phosphate/metal hydroxide precipitation. Activity effects on chemical equilibria are significant when considering phosphorus. Also of importance in wastewater treatment is the fate of sulfur compounds. This includes the generation of H2S in the digester gas and the fate of the sulfur species in the digested sludge (as a predictor of odour-generating potential).

Critical flux in submerged membrane bioreactors for municipal wastewater treatment

Desalination ◽  
2009 ◽  
Vol 245 (1-3) ◽  
pp. 748-753 ◽  
Author(s):  
A. Bottino ◽  
G. Capannelli ◽  
A. Comite ◽  
R. Mangano
Keyword(s):  
Wastewater Treatment ◽  
Municipal Wastewater ◽  
Membrane Bioreactors ◽  
Municipal Wastewater Treatment ◽  
Critical Flux
Sign in / Sign up

Export Citation Format

Share Document