Visible Light Detection of Dopamine Enhanced by Cloud Point Extraction

2019 ◽  
Vol 15 (5) ◽  
pp. 528-534
Author(s):  
Asiye Aslıhan Avan ◽  
Hayati Filik

Background: Monitoring of DA, in the presence of other chemical analogues such as epinephrine, norepinephrine, serotonin, ascorbic acid, uric acid, catechol, phenethylamine, tyramine, and tyrosine, is crucial in the diagnosis and mechanistic understanding of human neuropathology. Therefore, the determination of DA at trace levels has become a very important analytical task, as part of health safety and forensic analysis. Introduction: A cloud point extraction (CPE) process was developed for the isolation and detection of dopamine in food, urine, and pharmaceutical samples. Methods: In this procedure, dopamine was derivatized with o-phthalaldehyde (OPA) and sodium sulphite in aqueous solution. The isoindole derivative was synthesized by the reaction of OPA and sodium sulphite with the amino group of dopamine and the resulted isoindole derivatives were extracted by cloud point extraction. After extraction process, the concentration of enriched analyte was measured by UV-VIS spectrophotometry. The parameters affecting the CPE such as concentration of surfactant and electrolyte, equilibration temperature and time and pH of sample solution were investigated. Results: After optimization of the CPE conditions, the linear range of 8-80 µM (without extraction 100- 1000 µM) was established for dopamine with detection limit at 2.6 µM. Conclusion: The developed extraction procedure was applied to the quantification of dopamine in chocolate, urine, and pharmaceutical samples. The study ensures a promising strategy for the detection of dopamine in the presence of biological constituents, e.g. ascorbic acid, uric acid, and serotonin.

2011 ◽  
Vol 2011 ◽  
pp. 1-8 ◽  
Author(s):  
Mohammad Hosein Soruraddin ◽  
Rouhollah Heydari ◽  
Morteza Puladvand ◽  
Mir Mehdi Zahedi

A simple, rapid, and sensitive spectrophotometric method for the determination of trace amounts of selenium (IV) was described. In this method, all selenium spices reduced to selenium (IV) using 6 M HCl. Cloud point extraction was applied as a preconcentration method for spectrophotometric determination of selenium (IV) in aqueous solution. The proposed method is based on the complexation of Selenium (IV) with dithizone at pH < 1 in micellar medium (Triton X-100). After complexation with dithizone, the analyte was quantitatively extracted to the surfactant-rich phase by centrifugation and diluted to 5 mL with methanol. Since the absorption maxima of the complex (424 nm) and dithizone (434 nm) overlap, hence, the corrected absorbance, Acorr, was used to overcome the problem. With regard to the preconcentration, the tested parameters were the pH of the extraction, the concentration of the surfactant, the concentration of dithizone, and equilibration temperature and time. The detection limit is 4.4 ng mL-1; the relative standard deviation for six replicate measurements is 2.18% for 50 ng mL-1of selenium. The procedure was applied successfully to the determination of selenium in two kinds of pharmaceutical samples.


2009 ◽  
Vol 92 (3) ◽  
pp. 907-913 ◽  
Author(s):  
Mehrorang Ghaedi ◽  
Ardeshir Shokrollahi ◽  
Khodabakhsh Niknam ◽  
Ebrahim Niknam ◽  
Somayyeh Derki ◽  
...  

Abstract A cloud point extraction (CPE) procedure was presented for the preconcentration of silver, zinc, and lead ions in various samples. The complexes of these metal ions with 2-(((1H-benzo[d]imidazol-2-yl)methoxy)methyl)-1H-benzo[d]imidazole (BIMMBI) are quantitatively extracted into the Triton X-114-rich phase after centrifugation. A solution of 1.0 M HNO3 in methanol was added to the surfactant-rich phase as the effective eluant before analysis by flame atomic absorption spectrometry. The influence of effective parameters such as the concentrations of BIMMBI, Triton X-114, and HNO3, pH, bath temperature, centrifuge rate, and time on method sensitivity and efficiency was optimized. Detection limits of 2.8, 1.7, and 1.1 ng/mL for Pb2+, Ag+, and Zn2+, respectively, along with a preconcentration factor of 30 and enrichment factors of 33, 48, and 53 for Pb2+, Ag+, and Zn2+, respectively, were obtained. The present CPE method is suitable for accurate and precise determination of trace amounts of analyte ions in complex matrixes. The proposed CPE procedure was applied to the determination of these ions in biological, natural water, wastewater, soil, and blood samples.


Sign in / Sign up

Export Citation Format

Share Document