A prospective, split-mouth, clinical study of orthodontic titanium miniscrews with machined and acid-etched surfaces
ABSTRACT Objectives: To determine whether the success rate and primary stability of surface-treated miniscrews differ from those of nontreated miniscrews. Materials and Methods: Patients who required one or more miniscrews for the same reason in each quadrant were recruited into a single-blinded, split-mouth, randomized, controlled trial with a 1:1 allocation ratio. Self-drilling miniscrews with two surface types were used: those with no surface treatment, and those with an acid-etched surface treatment. The cumulative success rate and primary stability of each type of miniscrew were examined, and factors potentially affecting the success and failure of miniscrews were investigated. Results: Forty patients were included in the study, with a total of 98 orthodontic miniscrews. The overall success rate was 88.8%, and the respective success rates for acid-etched and machined surface miniscrews were 91.8% and 85.7%. The respective mean insertion torques were 13.62 ± 5.95 N·cm and 13.38 ± 4 N·cm, and periotest values measured immediately after insertion were −0.50 ± 2.77 for acid-etched miniscrews and −0.28 ± 3.36 for machined surface miniscrews. There was no significant difference in the mean insertion torques and periotest values according to surface treatment and jaw. Conclusions: Neither the success rate nor the primary stability of acid-etched surface miniscrews and machined surface miniscrews differed significantly. There is a high possibility that miniscrews will fall out in patients who have an open bite or those who require total distalization.