scholarly journals Geochemical signature of aquitard pore water and its paleo-environment implications in Caofeidian Harbor, China

2013 ◽  
Vol 47 (1) ◽  
pp. 37-50 ◽  
Author(s):  
JING LI ◽  
XING LIANG ◽  
MENGGUI JIN ◽  
XUMEI MAO
Keyword(s):  
Pore Water ◽  
Geochemical Signature

Geochemical signature of pore water from core samples and its implications on the origin of saline pore water in Cangzhou, North China Plain

2015 ◽  
Vol 157 ◽  
pp. 143-152 ◽  
Author(s):  
Hiu Tung Kwong ◽  
Jimmy Jiu Jiao ◽  
Kun Liu ◽  
Haipeng Guo ◽  
Shouye Yang
Keyword(s):  
Pore Water ◽  
North China Plain ◽  
North China ◽  
Core Samples ◽  
Geochemical Signature

TIME TO THE END OF PRIMARY CONSOLIDATION (EOP) OF SOFT CLAYEY SOILS: CONCERNING THE EFFECT OF ATTERBERG’S LIMIT AND CYCLIC LOADING HISTORY

2019 ◽  
Vol 128 (2B) ◽  
pp. 29-41
Author(s):  
Trần Thanh Nhàn
Keyword(s):  
Cyclic Loading ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Clayey Soils ◽  
Loading History ◽  
Cyclic Shear ◽  
Wide Range ◽  
Primary Consolidation ◽  
Time Required

In order to observe the end of primary consolidation (EOP) of cohesive soils with and without subjecting to cyclic loading, reconstituted specimens of clayey soils at various Atterberg’s limits were used for oedometer test at different loading increments and undrained cyclic shear test followed by drainage with various cyclic shear directions and a wide range of shear strain amplitudes. The pore water pressure and settlement of the soils were measured with time and the time to EOP was then determined by different methods. It is shown from observed results that the time to EOP determined by 3-t method agrees well with the time required for full dissipation of the pore water pressure and being considerably larger than those determined by Log Time method. These observations were then further evaluated in connection with effects of the Atterberg’s limit and the cyclic loading history.

Total mercury, methylmercury, methylmercury production potential, and ancillary streambed-sediment and pore-water data for selected streams in Oregon, Wisconsin, and Florida, 2003-04

Data Series ◽  
10.3133/ds375 ◽  
2008 ◽  
Author(s):  
Mark C. Marvin-DiPasquale ◽  
Michelle A. Lutz ◽  
David P. Krabbenhoft ◽  
George R. Aiken ◽  
William H. Orem ◽  
...  
Keyword(s):  
Pore Water ◽  
Total Mercury ◽  
Production Potential ◽  
Streambed Sediment ◽  
Methylmercury Production

Conjectures, Hypotheses, and Theories of Drumlin Formation (In memory of Stanislaw Baranowski)

1981 ◽  
Vol 27 (97) ◽  
pp. 503-505 ◽  
Author(s):  
Ian J. Smalley
Keyword(s):  
Shear Strength ◽  
Pore Water ◽  
Stress Level ◽  
Critical Stress ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Glacial Till ◽  
Forming Process ◽  
Stress Levels

AbstractRecent investigations have shown that various factors may affect the shear strength of glacial till and that these factors may be involved in the drumlin-forming process. The presence of frozen till in the deforming zone, variation in pore-water pressure in the till, and the occurrence of random patches of dense stony-till texture have been considered. The occurrence of dense stony till may relate to the dilatancy hypothesis and can be considered a likely drumlin-forming factor within the region of critical stress levels. The up-glacier stress level now appears to be the more important, and to provide a sharper division between drumlin-forming and non-drumlin-forming conditions.

The temperature and pore water pressure in soil subjected to dynamic load

2018 ◽  
Vol 35 (2) ◽  
pp. 111
Author(s):  
Kun ZHANG ◽  
Ze ZHANG ◽  
Xiangyang SHI ◽  
Sihai LI ◽  
Donghui XIAO
Keyword(s):  
Pore Water ◽  
Dynamic Load ◽  
Pore Water Pressure ◽  
Water Pressure

Measurement and Modeling of Energetic-Material Mass Transfer to Soil-Pore Water

2006 ◽  
Author(s):  
Stephen W. Webb ◽  
James M. Phelan ◽  
Teklu Hadgu ◽  
Joshua S. Stein ◽  
Cedric M. Sallaberry
Keyword(s):  
Mass Transfer ◽  
Pore Water ◽  
Energetic Material ◽  
Soil Pore Water

Spatial Variation of Aquifer Parameters from Coastal Aquifers of Sindhudurg District, Maharashtra Using Pore-water Resistivity and Bulk Resistivity

2018 ◽  
Vol 1 (1) ◽  
pp. 28-40
Author(s):  
Suneetha Naidu ◽  
Gautam Gupta
Keyword(s):  
Hydraulic Conductivity ◽  
Pore Water ◽  
Coastal Aquifers ◽  
Hydraulic Parameters ◽  
Formation Factor ◽  
Bulk Resistivity ◽  
Good Correspondence ◽  
Aquifer System ◽  
Transverse Resistance ◽  
Water Resistivity

Estimation of hydraulic parameters in coastal aquifers is an important task in groundwater resource assessment and development. An attempt is made to estimate these parameters using geoelectrical data in combination with pore-water resistivity of existing wells. In the present study, 29 resistivity soundings were analysed along with 29 water samples, collected from the respective dug wells and boreholes, in order to compute hydraulic parameters like formation factor, porosity, hydraulic conductivity and transmissivity from coastal region of north Sindhudurg district, Maharashtra, India. The result shows some parts of the study area reveal relatively high value of hydraulic conductivity, porosity and transmissivity. Further, a negative correlation is seen between hydraulic conductivity and bulk resistivity. The hydraulic conductivity is found to vary between 0.014 and 293 m/day, and the transmissivity varied between 0.14 and 11,722 m2/day. The transmissivity values observed here are in good correspondence with those obtained from pumping test data of Central Ground Water Board. These zones also have high aquifer thickness and therefore characterize high potential within the water-bearing formation. A linear, positive relationship between transverse resistance and transmissivity is observed, suggesting increase in transverse resistance values indicate high transmissivity of aquifers. These relations will be extremely vital in characterization of aquifer system, especially from crystalline hard rock area.

Sign in / Sign up

Export Citation Format

Share Document