scholarly journals Static Network Code Dgps Positioning vs. Carrier Phase Single Baseline Solutions for Short Observation time and Medium-Long Distances

2007 ◽  
Vol 42 (3) ◽  
pp. 167-183 ◽  
Author(s):  
M. Bakuła
Keyword(s):  
Carrier Phase ◽  
Network Code ◽  
Observation Time ◽  
Reference Station ◽  
Accuracy Estimation ◽  
Gps Positioning ◽  
Gis Applications ◽  
Code Network ◽  
Single Baseline ◽  
Short Observation Time

Static Network Code Dgps Positioning vs. Carrier Phase Single Baseline Solutions for Short Observation time and Medium-Long DistancesGPS land surveys are usually based on the results of processing GPS carrier phase data. Code or pseudorange observations due to considerations of accuracy requirements and robustness are preferred in navigation and some GIS applications. Generally, the accuracy of that positioning is in the range of about 1-2 meters or so, on average. But the main problem in code GPS positioning is to know how to estimate the real accuracy of DGPS positions. It is not such an easy process in code positioning when one reference station is used. In most commercial software, there are no values of accuracy but only positions are presented. DGPS positions without estimated errors cannot be used for surveying tasks and for most GIS applications due to the fact that every point has to be have accuracy determined. However, when we used static GPS positioning, it is well known that the accuracy is determined, both during baseline processing and next by the adjustment of a GPS network. These steps of validation with redundancy in classical static phase baseline solutions allow wide use of static or rapid static methods in the main land surveying tasks. Although these control steps are commonly used in many major surveying and engineering tasks, they are not always effective in terms of short-observation-time sessions. This paper presents a new network DGPS approach of positioning with the use of at least three reference stations. The approach concerns also valid accuracy estimation based on variance-covariance (VC) matrix in the least-squares (LS) calculations. The presented network DGPS approach has the ability of reliable accuracy estimation. Finally, network DGPS positioning is compared with static baselines solutions where five-min sessions were taken into consideration for two different rover stations. It was shown that in a short observation time of GPS positioning, code network DGPS results can give even centimetre accuracy and can be more reliable than static relative phase positioning where gross errors often happen.

scholarly journals Sensitivity of Adop to Changes in the Single-Baseline GNSS Model

2007 ◽  
Vol 42 (2) ◽  
pp. 71-96 ◽  
Author(s):  
D. Odijk ◽  
P. Teunissen
Keyword(s):  
Carrier Phase ◽  
Observation Time ◽  
Time Span ◽  
Linear Combinations ◽  
Gnss Positioning ◽  
Single Baseline ◽  
Gnss Data ◽  
The Impact ◽  
Dependent Observation ◽  
Ambiguity Dilution Of Precision

Sensitivity of Adop to Changes in the Single-Baseline GNSS Model The ADOP (Ambiguity Dilution Of Precision) is a measure for the precision of the carrier phase ambiguities involved in precise relative GNSS positioning. By computing the ADOP one may get knowledge in whether ambiguity resolution can be expected successful or not, already in a stage before the GNSS data are collected. In Odijk and Teunissen (2008) compact closed-form expressions have been derived for the ADOP of single-baseline GNSS models. In this paper these expressions are used to study the impact of certain changes in these models, as there are the observation time span, the weighting of the ionospheric delays, the number of frequencies, the weights of the phase and code data, the number of satellites, elevation-dependent observation weights and taking linear combinations of data.

scholarly journals Characterization of Carrier Phase-Based Positioning in Real-World Jamming Conditions

2021 ◽  
Vol 13 (14) ◽  
pp. 2680
Author(s):  
Søren Skaarup Larsen ◽  
Anna B. O. Jensen ◽  
Daniel H. Olesen
Keyword(s):  
Real World ◽  
Carrier Phase ◽  
Reference Station ◽  
Baseline Length ◽  
Dual Frequency ◽  
Positioning Accuracy ◽  
The Impact ◽  
Single Versus ◽  
Selection Of

GNSS signals arriving at receivers at the surface of the Earth are weak and easily susceptible to interference and jamming. In this paper, the impact of jamming on the reference station in carrier phase-based relative baseline solutions is examined. Several scenarios are investigated in order to assess the robustness of carrier phase-based positioning towards jamming. Among others, these scenarios include a varying baseline length, the use of single- versus dual-frequency observations, and the inclusion of the Galileo and GLONASS constellations to a GPS only solution. The investigations are based on observations recorded at physical reference stations in the Danish TAPAS network during actual jamming incidents, in order to realistically evaluate the impact of real-world jamming on carrier phase-based positioning accuracy. The analyses performed show that, while there are benefits of using observations from several frequencies and constellations in positioning solutions, special care must be taken in solution processing. The selection of which GNSS constellations and observations to include, as well as when they are included, is essential, as blindly adding more jamming-affected observations may lead to worse positioning accuracy.

scholarly journals A Fast Detection Algorithm for the X-Ray Pulsar Signal

2017 ◽  
Vol 2017 ◽  
pp. 1-5 ◽  
Author(s):  
Hao Liang ◽  
Yafeng Zhan
Keyword(s):  
False Alarm ◽  
Navigation System ◽  
Detection Probability ◽  
Autonomous Navigation ◽  
Detection Algorithm ◽  
Observation Time ◽  
X Ray ◽  
Fast Detection ◽  
Simulation Results ◽  
Short Observation Time

The detection of the X-ray pulsar signal is important for the autonomous navigation system using X-ray pulsars. In the condition of short observation time and limited number of photons for detection, the noise does not obey the Gaussian distribution. This fact has been little considered extant. In this paper, the model of the X-ray pulsar signal is rebuilt as the nonhomogeneous Poisson distribution and, in the condition of a fixed false alarm rate, a fast detection algorithm based on maximizing the detection probability is proposed. Simulation results show the effectiveness of the proposed detection algorithm.

scholarly journals ISAR Signal Tracking and High-Resolution Imaging by Kalman Filtering

2021 ◽  
Vol 13 (17) ◽  
pp. 3389
Author(s):  
Pei Ye ◽  
Meng-Dao Xing ◽  
Xiang-Gen Xia ◽  
Guang-Cai Sun ◽  
Yachao Li ◽  
...  
Keyword(s):  
High Resolution ◽  
Kalman Filtering ◽  
State Vector ◽  
Observation Time ◽  
The State ◽  
Range Resolution ◽  
Resolution Image ◽  
High Resolution Image ◽  
Reconstruction Performance ◽  
Short Observation Time

In a short observation time, after the range alignment and phase adjustment, the motion of a target can be approximated as a uniform rotation. The radar observing process can be simply described as multiplying an observation matrix on the ISAR image, which can be thought of as a linear system. It is known that the longer observation time is, the higher cross-range resolution is. In order to deal with the conflict between short observation time and high cross-range resolution, we introduce Kalman filtering (KF) into the ISAR imaging and propose a novel method to reconstruct a high-resolution image with short time observed data. As KF has excellent reconstruction performance, it leads to a good application in ISAR image reconstruction. At each observation aperture, the reconstructed image denotes the state vector in KF at the aperture time. It is corrected by a two-step KF process: prediction and update. As iteration continues, the state vector is gradually corrected to a well-focused high-resolution image. Thus, the proposed method can obtain a high-resolution image in a short observation time. Both simulated and real data are applied to demonstrate the performance of the proposed method.

scholarly journals Variability and Performance of Short to Long-Range Single Baseline RTK GNSS Positioning in Indonesia

2019 ◽  
Vol 94 ◽  
pp. 01012 ◽  
Author(s):  
Irwan Gumilar ◽  
Brian Bramanto ◽  
Fuad F. Rahman ◽  
I Made D. A. Hermawan
Keyword(s):  
Long Range ◽  
High Frequency ◽  
Carrier Phase ◽  
Satellite System ◽  
High Accuracy ◽  
Gnss Positioning ◽  
And Performance ◽  
Gnss Network ◽  
Single Baseline ◽  
Global Navigation Satellite

As the modernized Global Navigation Satellite System (GNSS) method, Real Time Kinematic (RTK) ensures high accuracy of position (within several centimeters). This method uses Ultra High Frequency (UHF) radio to transmit the correction data, however, due to gain and power issues, Networked Transport of RTCM via Internet Protocol (RTCM) is used to transmit the correction data for a longer baseline. This Research aims to investigate the performance of short to long-range single baseline RTK GNSS (Up to 80 KM) by applying modified LAMBDA method to resolve the ambiguity in carrier phase. The RTK solution then compared with the differential GNSS network solution. The results indicate that the differences are within RTK accuracy up to 80 km are several centimeter for horizontal solution and three times higher for vertical solution.

scholarly journals Code and carrier phase based short baseline GPS positioning: computational aspects

GPS Solutions ◽  
2004 ◽  
Vol 7 (4) ◽  
pp. 230-240 ◽  
Author(s):  
Xiao-Wen Chang ◽  
Christopher C. Paige ◽  
Lan Yin
Keyword(s):  
Carrier Phase ◽  
Short Baseline ◽  
Gps Positioning ◽  
Computational Aspects

Carrier Phase GPS Navigation to the North Pole

1999 ◽  
Vol 52 (1) ◽  
pp. 80-89 ◽  
Author(s):  
T. Moore ◽  
G. W. Roberts
Keyword(s):  
Ambiguity Resolution ◽  
Carrier Phase ◽  
Integer Ambiguity Resolution ◽  
North Pole ◽  
Integer Ambiguity ◽  
Reference Station ◽  
Baseline Length ◽  
Cycle Slips ◽  
The North ◽  
Long Baseline

Over the last few years, on-the-fly integer ambiguity resolution for GPS has proven to be successful over short baselines (<20 km). However, the remaining challenge has been to extend the length of the baseline between the reference station and the mobile receiver, whilst still maintaining the capability of on-the-fly resolution and true carrier-based kinematic positioning. The goal has been to achieve centimetric level positioning at ranges of over 500 km. New techniques have been developed at the University of Nottingham to allow very long baseline integer ambiguity resolution, on-the-fly. A major problem with the use of carrier phase data is that posed by cycle slips. A technique for detecting and correcting cycle slips has been developed, and its use is discussed in this paper. The new technique has been proven through a series of trials, one of which included two flights to the North Pole, performing centimetric level positioning all the way to the pole. For many years, the GD Aero-Systems Course of the Air Warfare Centre based at RAF Cranwell executed a series of equipment flight trials to the North Pole, called the ARIES Flights. In May 1996, the authors were fortunate to take part in both flights, via Iceland and Greenland, to the North Pole. Based on reference stations at Thule Air Base, integer ambiguity resolution was accomplished, on-the-fly, and centimetric level navigation maintained throughout the flights. Earlier trials detailed in the paper demonstrate that the technique can resolve integer ambiguities on-the-fly within a few seconds over a baseline length of approximately 134 km, resulting in an accuracy of 12 cm. The majority of the residual error source for this being the ionosphere.

Sign in / Sign up

Export Citation Format

Share Document