scholarly journals Classification, analysis and interaction of solid airborne particles in urban environments

Author(s):  
P. Cariñanos ◽  
C. Galán ◽  
P. Alcázar ◽  
E. Dominguez
2009 ◽  
Vol 131 (4) ◽  
Author(s):  
Ulf Olofsson ◽  
Lars Olander ◽  
Anders Jansson

Recently, much attention has been paid to the influence of airborne particles in the atmosphere on human health. Sliding contacts are a significant source of airborne particles in urban environments. In this study airborne particles generated from a sliding steel-on-steel combination are studied using a pin-on-disk tribometer equipped with airborne-particle counting instrumentation. The instrumentation measured particles in size intervals from 0.01μm to 32μm. The result shows three particle size regimes with distinct number peaks: ultrafine particles with a size distribution peak around 0.08μm, fine particles with a peak around 0.35μm, and coarse particles with a peak around 2 or 4μm. Both the particle generation rate and the wear rate increase with increasing sliding velocity and contact pressure.


2017 ◽  
Vol 51 (24) ◽  
pp. 14107-14113 ◽  
Author(s):  
Chiara Giorio ◽  
Daniele Marton ◽  
Gianni Formenton ◽  
Andrea Tapparo

Author(s):  
M. Shlepr ◽  
C. M. Vicroy

The microelectronics industry is heavily tasked with minimizing contaminates at all steps of the manufacturing process. Particles are generated by physical and/or chemical fragmentation from a mothersource. The tools and macrovolumes of chemicals used for processing, the environment surrounding the process, and the circuits themselves are all potential particle sources. A first step in eliminating these contaminants is to identify their source. Elemental analysis of the particles often proves useful toward this goal, and energy dispersive spectroscopy (EDS) is a commonly used technique. However, the large variety of source materials and process induced changes in the particles often make it difficult to discern if the particles are from a common source.Ordination is commonly used in ecology to understand community relationships. This technique usespair-wise measures of similarity. Separation of the data set is based on discrimination functions. Theend product is a spatial representation of the data with the distance between points equaling the degree of dissimilarity.


2014 ◽  
Author(s):  
Chrono Nu ◽  
Katie Mullin ◽  
Hailey Edwards ◽  
Kailey Kornhauser ◽  
Russell Costa ◽  
...  

TERRITORIO ◽  
2020 ◽  
pp. 148-163
Author(s):  
Luca Fondacci

In the 1970s, the fragile historical centre of the city of Perugia was a key area where the binomial of sustainable mobility and urban regeneration was developed and applied. At the turn of the xxi century, the low carbon automatic people-mover Minimetrò broadened that application from the city's historical centre to the outskirts, promoting the enhancement of several urban environments. This paper is the outcome of an investigation of original sources, field surveys and direct interviews, which addresses the Minimetrò as the backbone of a wide regeneration process which has had a considerable impact on the economic development of a peripheral area of the city which was previously devoid of any clear urban sense. The conclusion proposes some solutions to improve the nature of the Minimetrò as an experimental alternative means of transport.


Sign in / Sign up

Export Citation Format

Share Document