EXPERIMENTAL HYDRODYNAMICS OF INTERACTING GAS BUBBLES AND OIL DROPLETS: ATTACHMENT PHENOMENA

Author(s):  
Joel Karp ◽  
Ernesto Mancilla ◽  
PAULO HENRIQUE DIAS DOS SANTOS ◽  
Rigoberto Morales
2017 ◽  
Vol 2017 (1) ◽  
pp. 2017-194
Author(s):  
Lin Zhao ◽  
Michel C. Boufadel ◽  
Feng Gao ◽  
Thomas King ◽  
Brian Robinson ◽  
...  

Abstract (2017-194) The presence of methane bubbles in the oil and gas blowout could greatly reduce the oil droplet sizes. Bubbles tend to introduce energy into the system and separate oil droplets from each other. The interaction of oil droplets and gas bubbles in the near field of a blowout was investigated numerically using the VDROP-J model, whose droplet size distribution (DSD) was thoroughly calibrated. For this purpose, a new numerical scheme has been developed in VDROP-J to account for the interaction of gas bubbles and oil droplets in the blowout, giving simultaneous simulation of bubble and droplet size distribution along the discharged plume. Validation shows improvement of the model compared with the one without considering the gas bubble and oil droplet interactions. Effects of gas volume fraction on the droplet formation are also investigated. This new development will enhance the knowledge in subsea oil and gas blowouts.


2018 ◽  
Vol 32 (10) ◽  
pp. 10513-10521 ◽  
Author(s):  
Marcin Dudek ◽  
Gisle Øye
Keyword(s):  

Author(s):  
Joel R. Karp ◽  
Ernesto Mancilla ◽  
Paulo H. D. Santos ◽  
Moisés A. Marcelino Neto ◽  
Rigoberto E. M. Morales

Abstract The interactions between dispersed oil droplets and gas bubbles was experimentally studied in this work. An experimental set-up was built in the Multiphase Flow Research Center (NUEM) in the Federal University of Technology – Paraná (UTFPR) to conduct a fundamental evaluation of the interactions between sessile gas bubbles and oil droplets employing side-view flow visualization. Tap water was used as the continuous phase, whereas pure nitrogen and colored vegetable oil were employed as the dispersed phases. The bubble-droplet attachment consisted in the encapsulation of the bubble by the droplet, presenting phenomenological similarities to droplet-droplet coalescence. The contact between the dispersed phases induces the formation of a connecting bridge, which grows rapidly with time, with the height of the bridge being comparable to the size of the droplet after 57.0 ms. The inherent asymmetry of the phenomenon induced a significant horizontal displacement of the bubble towards the droplet, whose position remained unaltered. The evaluation of the bridge meniscus corroborated to this observation, since the contact angle on the droplet side decayed faster with time in comparison to the contact angle on the bubble side. The hydrodynamics of the rising aggregate is also evaluated, by the obtainment of its size, three-dimensional trajectory and terminal velocity. The stable aggregates formed presented an increase factor of 150 to 180%, based on the terminal velocity of the individual droplet. The radius of the bubble was found to be the major influence on the hydrodynamics of the aggregate, allowing the definition of a critical bubble radius based on trajectory instabilities.


2014 ◽  
Vol 2014 (1) ◽  
pp. 266-282 ◽  
Author(s):  
Paul D. Panetta ◽  
Dale McElhone ◽  
Kyle Winfield ◽  
Grace Cartwright

ABSTRACT To help minimize the effects of oil spills on marine environments, chemical dispersants are used to disperse the oil in the water column so the oil can be consumed by naturally occurring bacteria. During the Deepwater Horizon incident, 1.1 million gallons of dispersant were injected directly into the flowing plume of oil and natural gas over 1500 meters deep. Dispersant's main effect is to decrease the surface tension at the oil-water interface causing the oil to form droplets smaller than ~70 microns so they can remain in the water column. Currently the efficacy of aerial applied dispersants on surface slicks is determined by measuring the droplet size decrease using a Laser In-Situ Scattering Transmissometer (LISST) or by detecting the oil in the water column using fluorometers. LISST instruments are limited to dilute mixtures, below ~500 ppm, because the LISST signal saturates for concentrated mixtures, and their windows can become occluded by oil and biofilms. Fluorometers only measure oil concentration; thus they cannot distinguish between naturally dispersed oil droplets, which can float back to the surface, from chemically dispersed oil droplets, which will remain in the water column to be naturally biodegraded. When gas is present as was the case in the Deepwater Horizon incident where it was estimated that the plume consisted of ~22% natural gas, the LISST cannot distinguish between oil droplets and gas bubbles and thus is not able to track the effectiveness of dispersants in the presence of gas. Acoustic measurements overcome the problems associated with the LISST and fluorometers and are ideal for applications subsurface near a blowout and for low ppm levels expected for surface slicks. One of the key features of the sound wave propagating through the water is the scattering at the interface between the water and object. In previous work we showed the proof of concept to measure the average oil droplet size using acoustic. We used the resonance behavior of the gas bubbles to identify them and separate their contribution to the measured acoustic scattering for various oil and dispersant combinations . We developed acoustic scattering and resonance measurements to track the size of oil droplets in the presence of gas during subsurface releases at SINTEF and in Ohmsett's large wave tank.


ChemNanoMat ◽  
2018 ◽  
Vol 5 (2) ◽  
pp. 241-249 ◽  
Author(s):  
Jiale Yong ◽  
Subhash C. Singh ◽  
Zhibing Zhan ◽  
Jinglan Huo ◽  
Feng Chen ◽  
...  

2020 ◽  
Vol 54 (19) ◽  
pp. 11865-11875
Author(s):  
Jonas Gros ◽  
J. Samuel Arey ◽  
Scott A. Socolofsky ◽  
Anusha L. Dissanayake

2010 ◽  
Vol 21 (3) ◽  
pp. 388-393 ◽  
Author(s):  
Ruzairi Abdul Rahim ◽  
Yusri Md. Yunos ◽  
Mohd Hafiz Fazalul Rahiman ◽  
Herlina Abdul Rahim

Author(s):  
O. M. Katz

The swelling of irradiated UO2 has been attributed to the migration and agglomeration of fission gas bubbles in a thermal gradient. High temperatures and thermal gradients obtained by electron beam heating simulate reactor behavior and lead to the postulation of swelling mechanisms. Although electron microscopy studies have been reported on UO2, two experimental procedures have limited application of the results: irradiation was achieved either with a stream of inert gas ions without fission or at depletions less than 2 x 1020 fissions/cm3 (∼3/4 at % burnup). This study was not limited either of these conditions and reports on the bubble characteristics observed by transmission and fractographic electron microscopy in high density (96% theoretical) UO2 irradiated between 3.5 and 31.3 x 1020 fissions/cm3 at temperatures below l600°F. Preliminary results from replicas of the as-polished and etched surfaces of these samples were published.


Sign in / Sign up

Export Citation Format

Share Document