Study of the Aerodynamic Drag Coefficient of a Conical Thin-Walled Target Body at Low Reynolds Numbers

2021 ◽  
Vol 64 (2) ◽  
pp. 256-261
Author(s):  
A. V. Sochnev ◽  
Yu. B. Aleksandrov ◽  
B. R. Ziganshin
1971 ◽  
Vol 48 (2) ◽  
pp. 229-239 ◽  
Author(s):  
Cornelius C. Shih ◽  
Harry J. Buchanan

An experimental investigation was conducted to describe the fluid flow about oscillating flat plates and to determine the magnitude and nature of forces acting on the plates at low Reynolds numbers. In the experiment, the Reynolds number was varied from 1·01 to 1057·0; three period parameters, 1·57, 2·07 and 4·71, were applied; two fluids, water and SAE 30 motor oil, and three flat plates of various sizes with or without end plates were used. The analysis of data resulted in graphical presentation of the relationships among the drag coefficient, the Reynolds number and period parameter. The drag coefficient becomes less dependent on the Reynolds number for values greater than 250. The relationship between the drag coefficient and period parameter is pronounced throughout the entire range of the Reynolds number tested.


1985 ◽  
Vol 154 ◽  
pp. 215-230 ◽  
Author(s):  
D. L. R. Oliver ◽  
J. N. Chung

The effects of internal circulation in bubbles and droplets have been analysed by means of a semi-analytical series-truncation method. The equations of motion are transformed into a series of coupled, ordinary, nonlinear differential equations by use of orthogonal sets. These infinite-series equations are then truncated adequately and solved numerically. Using this series-truncation method, we have evaluated the effects of different ratios (between the continuous and dispersed phases) of both density and viscosity for the flows of low Reynolds numbers. For all the density ratios investigated, the density difference has almost no effect on the drag coefficient at low Reynolds numbers. The shear stress and the drag coefficient increase with increasing viscosity ratio of droplet to ambience and decrease with increasing Reynolds number.


2020 ◽  
Author(s):  
Lars Spannan ◽  
Elmar Woschke

With the OpenFOAM CFD Software the drag coefficient in automatic ball balancers utilizing the outer ring of radial ball bearings is calculated.


2020 ◽  
Vol 21 (6) ◽  
pp. 621
Author(s):  
Veerapathiran Thangaraj Gopinathan ◽  
John Bruce Ralphin Rose ◽  
Mohanram Surya

Aerodynamic efficiency of an airplane wing can be improved either by increasing its lift generation tendency or by reducing the drag. Recently, Bio-inspired designs have been received greater attention for the geometric modifications of airplane wings. One of the bio-inspired designs contains sinusoidal Humpback Whale (HW) tubercles, i.e., protuberances exist at the wing leading edge (LE). The tubercles have excellent flow control characteristics at low Reynolds numbers. The present work describes about the effect of tubercles on swept back wing performance at various Angle of Attack (AoA). NACA 0015 and NACA 4415 airfoils are used for swept back wing design with sweep angle about 30°. The modified wings (HUMP 0015 A, HUMP 0015 B, HUMP 4415 A, HUMP 4415 B) are designed with two amplitude to wavelength ratios (η) of 0.1 & 0.24 for the performance analysis. It is a novel effort to analyze the tubercle vortices along the span that induce additional flow energy especially, behind the tubercles peak and trough region. Subsequently, Co-efficient of Lift (CL), Co-efficient of Drag (CD) and boundary layer pressure gradients also predicted for modified and baseline (smooth LE) models in the pre & post-stall regimes. It was observed that the tubercles increase the performance of swept back wings by the enhanced CL/CD ratio in the pre-stall AoA region. Interestingly, the flow separation region behind the centerline of tubercles and formation of Laminar Separation Bubbles (LSB) were asymmetric because of the sweep.


2010 ◽  
Vol 1 (1-2) ◽  
pp. 15-20 ◽  
Author(s):  
B. Bolló

Abstract The two-dimensional flow around a stationary heated circular cylinder at low Reynolds numbers of 50 < Re < 210 is investigated numerically using the FLUENT commercial software package. The dimensionless vortex shedding frequency (St) reduces with increasing temperature at a given Reynolds number. The effective temperature concept was used and St-Re data were successfully transformed to the St-Reeff curve. Comparisons include root-mean-square values of the lift coefficient and Nusselt number. The results agree well with available data in the literature.


2004 ◽  
Author(s):  
Andrew D. Ketsdever ◽  
Michael T. Clabough ◽  
Sergey F. Gimelshein ◽  
Alina Alexeenko

Sign in / Sign up

Export Citation Format

Share Document