Subsurface Reinterpretation of Ordovician and Devonian Strata in Southwest Wyoming with Implications for Upwarping Across the Transcontinental Arch

2018 ◽  
Vol 55 (3) ◽  
pp. 91-118 ◽  
Author(s):  
Donna Anderson ◽  
Mark Longman

A new interpretation of the subsurface geometries of the Ordovician Bighorn Dolomite and overlying Devonian strata across southwestern Wyoming arises from revising the stratigraphy in a core from the Mountain Fuel Supply UPRR #11–19–104–4 well drilled on the crest of the Rock Springs Uplift in 1962. One of only a few wells to penetrate all or part of the Lower Paleozoic succession in the subsurface of southwestern Wyoming, the well was almost continuously cored through the Devonian–Cambrian succession. From a reinterpretation of the stratigraphy in the core, 22 ft of Bighorn Dolomite is recognized based on the characteristic Thalassinoides bioturbation fabric in skeletal dolowackestone typical of Late Ordovician subtidal carbonate facies ranging from Nevada to Greenland along the western margin of the Great American Carbonate Bank. This lithology is in complete contrast with the alternating dolomitic flat-pebble conglomerate and dolomudstone of the underlying Cambrian Gallatin Limestone and the cyclical units of brecciated anhydritic dolomudstone and quartzose sandstone of the overlying Devonian Lower Member of the Jefferson Formation. Stratigraphic re-interpretation yields insights regarding Ordovician–Devonian stratal geometries across southwestern Wyoming. More widespread than previously portrayed, the Bighorn Dolomite pinches out on the eastern flank of the Rock Springs Uplift. Similar to past interpretations, Devonian strata pinch out east of the Rock Springs Uplift at Table Rock Field. A true-geometry multi-datumed stratigraphic cross section yields insights not obtainable by mapping. Regionally, top truncation of stratigraphic units below the base-Madison Limestone unconformity normally progresses stratigraphically deeper eastward. However, in southwestern Wyoming, the Devonian Lower Member of the Jefferson Formation overlaps the older Bighorn Dolomite by marked onlap across the Rock Springs Uplift and then pinches out by top truncation/onlap near Table Rock Field, forming an “abnormal” overlap relationship along the northern margin of the Transcontinental Arch. The underlying Bighorn Dolomite shows little to no onlap onto the underlying Cambrian section, but is markedly top truncated below the Lower Member of the Jefferson Formation. Comparing proportions of onlap versus top truncation for the two formations constrains the timing of two successive upwarping episodes along the northern margin of the Transcontinental Arch across southwestern Wyoming. The first is arguably Middle Devonian, and the second spans the Devonian–Mississippian boundary. Two subtle and different angular unconformities created by these two episodes imply a persistent fold or tilt axis that sequentially was reactivated along the northern margin of the Transcontinental Arch in southwestern Wyoming.

2018 ◽  
Vol 55 (1) ◽  
pp. 33-51 ◽  
Author(s):  
Dominik Letsch ◽  
Mohamed El Houicha ◽  
Albrecht von Quadt ◽  
Wilfried Winkler

This article provides stratigraphic and geochronological data from a central part of Gondwana’s northern margin — the Moroccan Meseta Domain. This region, located to the north of the Anti-Atlas area with extensive outcrops of Precambrian and lower Paleozoic rocks, has hitherto not received much attention with regard to its Precambrian geology. Detrital and volcanic zircon ages have been used to constrain sedimentary depositional ages and crustal affinities of sedimentary source rocks in stratigraphic key sections. Based on this, a four-step paleotectonic evolution of the Meseta Domain from the Ediacaran until the Early Ordovician is proposed. This evolution documents the transition from a terrestrial volcanic setting during the Ediacaran to a short-lived carbonate platform setting during the early Cambrian. The latter then evolved into a rifted margin with deposition of thick siliciclastic successions in graben structures during the middle to late Cambrian. The detritus in these basins was of local origin, and a contribution from a broader source area (encompassing parts of the West African Craton) can only be demonstrated for postrifting, i.e., laterally extensive sandstone bodies that seal the former graben. In a broader paleotectonic context, it is suggested that this Cambrian rifting is linked to the opening of the Rheic Ocean, and that several peri-Gondwanan terranes (Meguma and Cadomia–Iberia) may have been close to the Meseta Domain before drifting, albeit some of them seem to have been constituted by a distinctly different basement.


2021 ◽  
Author(s):  
Hongyuan Zhang ◽  
Zhibin Lei ◽  
Bo Yang ◽  
Qing Liu ◽  
Haijun Zhang ◽  
...  

<p>A 1:50000 regional survey, covering an area of about 2000 km<sup>2</sup>, was carried out in the Shangrimuce area of Qilian Mountain in Northwest China. The results show that during Caledonian, the northern margin of the Central Qilian block experienced collision with mature island arcs and subsequently northward expansion. In the Shangrimuce study area, five geological units have been identified; they are, form south to north, back-arc basin, early Ordovician island arc, inter arc basin, middle Late Ordovician island arc, and fore-arc and oceanic lithosphere amalgamation zone. </p><p>(1) back-arc basin. In the Yangyuchi- Shule River- Cuorigang- Wawusi area, there may be a back-arc spreading basin, and there should be spreading basins in this area. It is speculated that there was a northward reverse subduction in the late Ordovician, accompanied by a syenite body, a broad spectrum dyke swarms and an accretionary wedge zone in the whole area.</p><p>(2) early Ordovician island arc. In the Shangrimuce-Dander area, the Proterozoic basement granitic gneiss, the early Ordovician island arc block and the high-pressure geological body all occur in the form of thrust horses, forming a double metamorphic belt, which reveals the existence of ocean subduction to south in the early Ordovician. </p><p>(3) inter arc basin. On both banks of Tuolai River to the east of Yanglong Township, there are early Middle Ordovician inter-arc basins with oceanic crust. </p><p>(4) middle Late Ordovician island arc. To the north of Tuolai River, there is a middle Late Ordovician island arc belt. Both sides of the island arc zone experienced strong ductile shear deformation, which recorded a complex arc-continent collision. </p><p>(5) fore-arc and oceanic lithosphere amalgamation zone (Fig.1). The Yushigou area has developed a fore-arc and oceanic lithospheric amalgamation zone, with weakly deformed fore-arc flysch basin, strongly deformed siliceous rocks, pillow Basalt, diabase, gabbro, peridotite and other rock assemblages.</p><p>Combined with the characteristics of arc-continent collision zone in the Western Pacific, there are two stages of shear zone series (Fig.2). One is ductile shear zones formed by the South dipping gneissic belt, revealing the existence of oceanic subduction accretion wedge and emplacement of high-pressure rocks. Another superimposed one is north dipping. This indicates that the arc-continent collision caused by back-arc reverse subduction, which ultimately controls the overall geometric and kinematic characteristics of the shear zones in the region.</p><p><img src="https://contentmanager.copernicus.org/fileStorageProxy.php?f=gepj.8219836ca50067454890161/sdaolpUECMynit/12UGE&app=m&a=0&c=40b3389c641f2d0ca723e1527c32927e&ct=x&pn=gepj.elif&d=1" alt=""></p><p>Figure 1 United sections showing a Caledonian trench-arc system in the Qilian Mountain, NW China.</p><p><img src="https://contentmanager.copernicus.org/fileStorageProxy.php?f=gepj.8def566da50066084890161/sdaolpUECMynit/12UGE&app=m&a=0&c=e82258ecc235c4e618abd6c035b58232&ct=x&pn=gepj.elif&d=1" alt=""></p><p>Figure 2 Structural analysis at Hongyahuo, indicating two stages of deformation.</p><p>The research has been supported by projects from the Ministry of Land and Resources (No.201211024-04; 1212011121188) and the 2020 undergraduate class construction project from China University of Geosciences (Beijing) (No. HHSKE202003).</p><p> </p>


Author(s):  
Hugo Rajão

Abstract: Capability Approach theorists have placed the recognition of capabilities and functionings at the core of their theories. However, they disagree about the selection of relevant capabilities. In this article, I argue that contrary to what the author claims, it is not philosophically possible to derive a list of central capabilities in this way, from the concept of human dignity underlying Martha Nussbaum’s theory. From that concept it is only possible to derive a process of democratic decision, in which everybody is represented fairly and equally. It should be noted that the proposal presented in this article is not in opposition to Nussbaum’s theory, but rather an attempt to offer a new interpretation of it, based on the normative groundings of theory, in order to address some of its theoretical problems. This thesis occupies forth section. In the second and third sections, I summarize the debate around the problem of selecting capabilities.


Sign in / Sign up

Export Citation Format

Share Document