scholarly journals Water Pumping Systems With Wind Turbines in Sinop,Turkey

Author(s):  
Bekir YELMEN ◽  
Mutlu Tarık ÇAKIR ◽  
Cengiz KURT
Keyword(s):  
1985 ◽  
Vol 107 (1) ◽  
pp. 97-101
Author(s):  
R. N. Clark ◽  
F. C. Vosper

Most modern wind turbines are designed to generate utility compatible AC electric power. The easiest way to use these wind turbines for irrigation pumping is by intertying with the electric utility grid. However, because irrigation pumping requires large amounts of power during critical crop growth stages and minimum power during the nongrowing season, utilities have to supply power during peak load times and purchase power during off peak times. Five wind turbines having induction generators have been operated in water pumping experiments at Bushland, Texas. These turbines ranged in rated capacity from 25 to 100 kW and have included both horizontal and vertical-axis types. All units have operated at least 5000 hr, with one unit having been operated for over 20,000 hr. Performance curves, monthly energy production, percentage of run-time, and availability are given for each turbine.


1996 ◽  
Vol 118 (4) ◽  
pp. 246-252 ◽  
Author(s):  
E. Muljadi ◽  
L. Flowers ◽  
J. Green ◽  
M. Bergey

Wind turbine technology has been used to pump water since ancient history. Direct mechanically coupled wind turbines are the most common method for pumping water to croplands and livestock. Many more recent wind turbines are electrically coupled, with the water pump connected to the wind turbine via a motor-generator connection. With electrical coupling, the distance and location of the water pump is independent of the location of the wind turbine. Therefore, the wind turbine can be located at an optimal wind energy site while the water pump is close to the water well or water tank. This paper analyzes a water-pumping system consisting of a wind turbine, a permanent magnet synchronous generator, an induction motor, and a centrifugal-type water pump.


Author(s):  
Waleed Obaid ◽  
Abdul-Kadir Hamid ◽  
Chaouki Ghenai

This paper demonstrates a water pumping hybrid power system design. The proposed system was designed for water related applications in Sharjah (Latitude 25.29 °N and Longitude 55 °E), United Arab Emirates. The proposed water hybrid system has two primary renewable power systems: solar PV panels and wind turbines. The proposed hybrid system considers the changes in weather conditions (humidity, wind speed, and temperature) since wind speed affects the performance of the wind turbines and solar panels are affected by solar irradiance. The following components are involved in the proposed design: battery (to store the power from solar panels), voltage regulator circuit (for getting stable DC voltage), three-phase rectifier (to convert the reduced AC voltage to DC), three-phase transformer (for reducing the obtained AC voltage), and DC electric motor (the main output of the proposed water pumping system). The proposed water pumping system relies on neural network blocks to achieve weather forecasting by obtaining solar irradiance values from the input temperature, wind speed, and humidity in a span of five years. Both MATLAB and Simulink are used simulate the performance of the proposed system under different weather conditions by changing the values according to the measured weather conditions values over five years.


2019 ◽  
Vol 2 (1) ◽  
pp. 8-16 ◽  
Author(s):  
P. A. Khlyupin ◽  
G. N. Ispulaeva

Introduction: The co-authors provide an overview of the main types of wind turbines and power generators installed into wind energy devices, as well as advanced technological solutions. The co-authors have identified the principal strengths and weaknesses of existing wind power generators, if applied as alternative energy sources. The co-authors have proven the need to develop an algorithm for the selection of a wind generator-based autonomous power supply system in the course of designing windmill farms in Russia. Methods: The co-authors have analyzed several types of wind turbines and power generators. Results and discussions: The algorithm for the selection of a wind generator-based autonomous power supply system is presented as a first approximation. Conclusion: The emerging algorithm enables designers to develop an effective wind generator-based autonomous power supply system.


2014 ◽  
Vol 134 (8) ◽  
pp. 1096-1103 ◽  
Author(s):  
Sho Tsujimoto ◽  
Ségolène Dessort ◽  
Naoyuki Hara ◽  
Keiji Konishi

Sign in / Sign up

Export Citation Format

Share Document