scholarly journals INNOVATIVE ANAMMOX ELECTRO–BIOREACTOR  TREATING MUNICIPAL WASTEWATER AT LOW  TEMPERATURE

Author(s):  
Abdelmajeed Adam ◽  
Maria Elektorowicz
2021 ◽  
pp. 125786
Author(s):  
Anna Christine Trego ◽  
B. Conall Holohan ◽  
Ciara Keating ◽  
Alison Graham ◽  
Sandra O'Connor ◽  
...  

2014 ◽  
Vol 9 (2) ◽  
pp. 235-242 ◽  
Author(s):  
S. Morling ◽  
A. Franquiz ◽  
J. Måhlgren ◽  
Å. Westlund

A biological wastewater treatment plant, Nynäshamn treating municipal wastewater and septic sludge operated with a combination of sequencing batch reactor (SBR) units and constructed wetland is presented in this paper. The plant has to treat low temperature wastewater in winter time, still with demands for a biological nitrogen removal. Treatment results from a 13 year operation period are presented. Special attention was given to the nutrient removal during low temperature conditions. The combination of a SBR system along with classical chemical precipitation and a polishing step based on ‘natural’ extensive treatment has been a sustainable way to keep the discharge levels low. The combined treatment with SBR and the wetland at the Nynäshamn plant has resulted in improved discharge levels typically as follows (annual mean values); BOD7 3 mg/l, to be compared with the formal consent value of <15 mg/l, total P < 0.1 mg/l, to be compared with the formal consent value of <0.5 mg/l and total N 7 mg/l, to be compared with the formal consent value of <15 mg/l. It is also important to underline that the change of process train has resulted in a substantial saving of the precipitant agent for phosphorus removal. The needed dosage is now 50% of the previous dose, before the implementation of the SBR-units.


2010 ◽  
Vol 113-116 ◽  
pp. 651-654
Author(s):  
Ben Chao Jiang ◽  
Fang Ma ◽  
Li Wei ◽  
Jing Bo Guo ◽  
Ang Li

The minimum temperature in winter is under -30oC in the northern hilly regions. It is harmful for the municipal wastewater treatment in winter. According to previous reports, the effects caused by the low-temperature in municipal wastewater treatment plant are summarized, and improvements are put forward. Improving the efficiencies of municipal wastewater treatment is essential and significant in the northern hilly regions.


1996 ◽  
Vol 34 (3-4) ◽  
pp. 499-505 ◽  
Author(s):  
S. Jeyaseelan ◽  
Gao Qing Lu

The objective of this research work is to investigate the possibility of using sewage sludge as a source to produce adsorbent for odorous gas removal. The basic method of adsorbent preparation is pyrolysis in nitrogen gas. The effects of heating temperature and resident time are investigated. Treatments such as drying in air at low temperature and soaking in chemicals prior to pyrolysis are attempted. The prepared adsorbents are characterized by an automatic surface area porosimeter in terms of BET surface area, pore size distribution. The highest BET surface area achieved is 309 m2/g, where the sludge is soaked in 5M zinc chloride solution and dried at low temperature before heating to 650°C for two hours. Laboratory tests at 17.5 ppm H2S concentration show that the sludge-derived adsorbent has an H2S adsorption capacity 25% that of a commercial activated carbon (Calgon IVP 4×6) over 15 hours of duration.


Sign in / Sign up

Export Citation Format

Share Document