New type of domain boundaries in multilayer magnetic structures

AbstractThe Hα filtergrams obtained at Tjan-Shan High Altitude Observatory near Alma-Ata (Moscow University Station) were measured in order to specify the bright rims contrast at different points along the line profile (0.0; ± 0.25; ± 0.5; ± 0.75 and ± 1.0 Å). The mean contrast value in the line center is about 25 percent. The bright rims interpretation as the bases of magnetic structures supporting the filaments is suggested.

Download Full-text

Domain Formation in Synthetic Quartz

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100064839 ◽

1971 ◽

Vol 29 ◽

pp. 156-157

Author(s):

Joseph J. Comer

Keyword(s):

Electron Beam ◽

Room Temperature ◽

Domain Formation ◽

Synthetic Quartz ◽

Transmission Electron ◽

Black Spots ◽

Diffraction Mode ◽

Domain Boundaries ◽

Kikuchi Lines ◽

Straight Lines

Domains visible by transmission electron microscopy, believed to be Dauphiné inversion twins, were found in some specimens of synthetic quartz heated to 680°C and cooled to room temperature. With the electron beam close to parallel to the [0001] direction the domain boundaries appeared as straight lines normal to <100> and <410> or <510> directions. In the selected area diffraction mode, a shift of the Kikuchi lines was observed when the electron beam was made to traverse the specimen across a boundary. This shift indicates a change in orientation which accounts for the visibility of the domain by diffraction contrast when the specimen is tilted. Upon exposure to a 100 KV electron beam with a flux of 5x 1018 electrons/cm2sec the boundaries are rapidly decorated by radiation damage centers appearing as black spots. Similar crystallographio boundaries were sometimes found in unannealed (0001) quartz damaged by electrons.

Download Full-text

The Microstructure of Shock-Synthesized Diamond

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010006163x ◽

1967 ◽

Vol 25 ◽

pp. 324-325

Author(s):

Lucien F. Trueb

Keyword(s):

Single Crystals ◽

Preferred Orientation ◽

High Magnification ◽

Texture Pattern ◽

Shock Process ◽

New Type ◽

Diffraction Diagram

A new type of synthetic industrial diamond formed by an explosive shock process has been recently developed by the Du Pont Company. This material consists of a mixture of two basically different forms, as shown in Figure 1: relatively flat and compact aggregates of acicular crystallites, and single crystals in the form of irregular polyhedra with straight edges.Figure 2 is a high magnification micrograph typical for the fibrous aggregates; it shows that they are composed of bundles of crystallites 0.05-0.3 μ long and 0.02 μ. wide. The selected area diffraction diagram (insert in Figure 2) consists of a weak polycrystalline ring pattern and a strong texture pattern with arc reflections. The latter results from crystals having preferred orientation, which shows that in a given particle most fibrils have a similar orientation.

Download Full-text

Nucleation of Disorder in Fe3Al Alloys

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100061574 ◽

1967 ◽

Vol 25 ◽

pp. 312-313

Author(s):

P. R. Swann ◽

W. R. Duff ◽

R. M. Fisher

Keyword(s):

Electron Microscopy ◽

Transmission Electron Microscopy ◽

Annealing Temperature ◽

Antiphase Domain ◽

Effect Of Temperature ◽

Domain Structures ◽

Transmission Electron ◽

Domain Boundaries ◽

Higher Temperature ◽

The One

Recently we have investigated the phase equilibria and antiphase domain structures of Fe-Al alloys containing from 18 to 50 at.% Al by transmission electron microscopy and Mössbauer techniques. This study has revealed that none of the published phase diagrams are correct, although the one proposed by Rimlinger agrees most closely with our results to be published separately. In this paper observations by transmission electron microscopy relating to the nucleation of disorder in Fe-24% Al will be described. Figure 1 shows the structure after heating this alloy to 776.6°C and quenching. The white areas are B2 micro-domains corresponding to regions of disorder which form at the annealing temperature and re-order during the quench. By examining specimens heated in a temperature gradient of 2°C/cm it is possible to determine the effect of temperature on the disordering reaction very precisely. It was found that disorder begins at existing antiphase domain boundaries but that at a slightly higher temperature (1°C) it also occurs by homogeneous nucleation within the domains. A small (∼ .01°C) further increase in temperature caused these micro-domains to completely fill the specimen.

Download Full-text

Dislocations, Ordering and Antiferromagnetic Domains in MnO

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100069600 ◽

1970 ◽

Vol 28 ◽

pp. 522-523

Author(s):

D. J. Barber ◽

R. G. Evans

Keyword(s):

Electron Diffraction ◽

Single Crystal ◽

Optical Microscopy ◽

Defect Chemistry ◽

Magnetic Structures ◽

Optically Transparent ◽

Magnetic Features ◽

Antiferromagnetic Domains

Manganese (II) oxide, MnO, in common with CoO, NiO and FeO, possesses the NaCl structure and shows antiferromagnetism below its Neel point, Tn∼ 122 K. However, the defect chemistry of the four oxides is different and the magnetic structures are not identical. The non-stoichiometry in MnO2 small (∼2%) and below the Tn the spins lie in (111) planes. Previous work reported observations of magnetic features in CoO and NiO. The aim of our work was to find explanations for certain resonance results on antiferromagnetic MnO.Foils of single crystal MnO were prepared from shaped discs by dissolution in a mixture of HCl and HNO3. Optical microscopy revealed that the etch-pitted foils contained cruciform-shaped precipitates, often thick and proud of the surface but red-colored when optically transparent (MnO is green). Electron diffraction and probe microanalysis indicated that the precipitates were Mn2O3, in contrast with recent findings of Co3O4 in CoO.

Download Full-text

Antiphase Boundaries in Ordered Ni3FE Crystals

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010006221x ◽

1969 ◽

Vol 27 ◽

pp. 62-63

Author(s):

Y. H. Liu

Keyword(s):

Domain Size ◽

Antiphase Domain ◽

X Ray Diffraction ◽

X Ray ◽

Hardening Mechanism ◽

Superlattice Structure ◽

Disordered Phase ◽

Domain Boundaries ◽

Atomic Scattering ◽

The Difference

Ordered Ni3Fe crystals possess a LI2 type superlattice similar to the Cu3Au structure. The difference in slip behavior of the superlattice as compared with that of a disordered phase has been well established. Cottrell first postulated that the increase in resistance for slip in the superlattice structure is attributed to the presence of antiphase domain boundaries. Following Cottrell's domain hardening mechanism, numerous workers have proposed other refined models also involving the presence of domain boundaries. Using the anomalous X-ray diffraction technique, Davies and Stoloff have shown that the hardness of the Ni3Fe superlattice varies with the domain size. So far, no direct observation of antiphase domain boundaries in Ni3Fe has been reported. Because the atomic scattering factors of the elements in NijFe are so close, the superlattice reflections are not easily detected. Furthermore, the domain configurations in NioFe are thought to be independent of the crystallographic orientations.

Download Full-text

New type electron gun with electrostatic and electromagnetic lenses

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100107459 ◽

1978 ◽

Vol 36 (1) ◽

pp. 62-63

Author(s):

T. Ichinokawa ◽

H. Maeda

Keyword(s):

Electron Microscopy ◽

Electron Beam ◽

Optimum Condition ◽

Bias Voltage ◽

Electron Gun ◽

Charge Effect ◽

Micro Fabrication ◽

Maximum Brightness ◽

New Type ◽

The Ideal

I. IntroductionThermionic electron gun with the Wehnelt grid is popularly used in the electron microscopy and electron beam micro-fabrication. It is well known that this gun could get the ideal brightness caluculated from the Lengumier and Richardson equations under the optimum condition. However, the design and ajustment to the optimum condition is not so easy. The gun has following properties with respect to the Wehnelt bias; (1) The maximum brightness is got only in the optimum bias. (2) In the larger bias than the optimum, the brightness decreases with increasing the bias voltage on account of the space charge effect. (3) In the smaller bias than the optimum, the brightness decreases with bias voltage on account of spreading of the cross over spot due to the aberrations of the electrostatic immersion lens.In the present experiment, a new type electron gun with the electrostatic and electromagnetic lens is designed, and its properties are examined experimentally.

Download Full-text

The observation of solutions in Ni3Nb

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100104765 ◽

1988 ◽

Vol 46 ◽

pp. 540-541

Author(s):

Z.M. Wang ◽

J.P. Zhang

Keyword(s):

Electron Microscopy ◽

High Resolution ◽

Phase Modulation ◽

High Resolution Electron Microscopy ◽

Antiphase Domain ◽

Boundary Area ◽

Matrix Type ◽

Resolution Electron ◽

Domain Boundaries ◽

Kontorova Model

High resolution electron microscopy reveals that antiphase domain boundaries in β-Ni3Nb have a hexagonal unit cell with lattice parameters ah=aβ and ch=bβ, where aβ and bβ are of the orthogonal β matrix. (See Figure 1.) Some of these boundaries can creep “upstairs” leaving an incoherent area, as shown in region P. When the stepped boundaries meet each other, they do not lose their own character. Our consideration in this work is to estimate the influnce of the natural misfit δ{(ab-aβ)/aβ≠0}. Defining the displacement field at the boundary as a phase modulation Φ(x), following the Frenkel-Kontorova model [2], we consider the boundary area to be made up of a two unit chain, the upper portion of which can move and the lower portion of the β matrix type, assumed to be fixed. (See the schematic pattern in Figure 2(a)).

Download Full-text