scholarly journals Recent Advances in and New Perspectives on Crystalline Silicon Solar Cells with Carrier-Selective Passivation Contacts

Crystals ◽  
2018 ◽  
Vol 8 (11) ◽  
pp. 430 ◽  
Author(s):  
Cao Yu ◽  
Shengzhi Xu ◽  
Jianxi Yao ◽  
Shuwei Han

Crystalline silicon (c-Si) is the dominating photovoltaic technology today, with a global market share of about 90%. Therefore, it is crucial for further improving the performance of c-Si solar cells and reducing their cost. Since 2014, continuous breakthroughs have been achieved in the conversion efficiencies of c-Si solar cells, with a current record of 26.6%. The great efficiency boosts originate not only from the materials, including Si wafers, emitters, passivation layers, and other functional thin films, but also from novel device structures and an understanding of the physics of solar cells. Among these achievements, the carrier-selective passivation contacts are undoubtedly crucial. Current carrier-selective passivation contacts can be realized either by silicon-based thin films or by elemental and/or compound thin films with extreme work functions. The current research and development status, as well as the future trends of these passivation contact materials, structures, and corresponding high-efficiency c-Si solar cells will be summarized.

2019 ◽  
Vol 2019 ◽  
pp. 1-7
Author(s):  
Abdullah Uzum ◽  
Hiroyuki Kanda ◽  
Takuma Noguchi ◽  
Yuya Nakazawa ◽  
Shota Taniwaki ◽  
...  

Aluminum acetylacetonate-based AlOx thin films were introduced as a low-cost, high-quality passivation layers for crystalline silicon solar cells. Films were formed by a spin coating method on p-type silicon substrates at 450°C in ambient air, O2, or water vapor (H2O/O2) for 15 or 120 min. XPS analysis confirms the AlOx formation and reveals a high intensity of interfacial SiOx at the AlOx/Si interface of processed wafers. Ambient H2O/O2 was found to be more beneficial for the activation of introduced AlOx passivation films which offers high lifetime improvements with a low thermal budget. Carrier lifetime measurements provides that symmetrically coated wafers reach 119.3 μs and 248.3 μs after annealing in ambient H2O/O2 for 15 min and 120 min, respectively.


2017 ◽  
Vol 53 (46) ◽  
pp. 6239-6242 ◽  
Author(s):  
Sheng Yuan ◽  
Yongji Chen ◽  
Zongwei Mei ◽  
Ming-Jian Zhang ◽  
Zhou Gao ◽  
...  

Novel Ag-doped glass frits remarkably improved the interface between bulk Ag and n-Si, which greatly reduced the contact resistance of c-Si solar cells.


2021 ◽  
Author(s):  
Yuanwei Jiang ◽  
Shuangying Cao ◽  
Linfeng Lu ◽  
Guanlin Du ◽  
Yinyue Lin ◽  
...  

Abstract Owing to its large work function, MoOX has been widely used for hole-selective contact in both thin film and crystalline silicon solar cells. In this work, thermally evaporated MoOX films are employed on the rear sides of p-type crystalline silicon (p-Si) solar cells, where the optical and electronic properties of the MoOX films as well as the corresponding device performances are investigated as a function of post-annealing treatment. The MoOX film annealed at 100oC shows the highest work function and proves the best hole selectivity based on the results of energy band simulation and contact resistivity measurements. The full rear p-Si/MoOX/Ag contacted solar cells demonstrate the best performance with an efficiency of 19.19%, which is the result of the combined influence of MoOX’s hole selectivity and passivation ability.


2016 ◽  
Vol 6 (14) ◽  
pp. 1600241 ◽  
Author(s):  
James Bullock ◽  
Peiting Zheng ◽  
Quentin Jeangros ◽  
Mahmut Tosun ◽  
Mark Hettick ◽  
...  

2018 ◽  
Vol 8 (11) ◽  
pp. 2131
Author(s):  
Jun-Kyu Lee ◽  
Jin-Seok Lee ◽  
Young-Soo Ahn ◽  
Gi-Hwan Kang

We present electrowinning of silver (Ag) from crystalline silicon (c-Si) solar cells using a solution of methanesulfonic acid (MSA) as the electrolyte. Ag dissolved effectively in MSA because of its high solubility in MSA; however, the electrochemical recovery of Ag from MSA solutions was found to be inefficient because of the low mobility of Ag ions in MSA, owing to its high viscosity. Therefore, we decreased the viscosity of MSA by adding deionized (DI) water, as a possible method for enhancing the mobility of Ag ions. The concentrations of added DI water were 0, 1.1, 5.0, 9.3, and 20.8 M, respectively. Further, we performed cyclic voltammetry for each solution to calculate the diffusion coefficient using the Randles–Sevcik equation, and analyzed the viscosity of MSA solutions depending on the concentration of added water using a rheometer. The morphologies of the electrochemically recovered Ag particles changed with variations in the amount of the added water, from branch-like structures to dendritic structures with a decreasing size. Moreover, the cathodic current efficiency increased considerably with increasing concentration of the added DI water. Finally, we recovered Ag with >99.9% (3N) purity from c-Si solar cells by electrowinning, as determined by glow discharge mass spectrometry.


2017 ◽  
Vol 7 (12) ◽  
pp. 1602606 ◽  
Author(s):  
Thomas G. Allen ◽  
James Bullock ◽  
Quentin Jeangros ◽  
Christian Samundsett ◽  
Yimao Wan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document