Abstract
An effective cooling mechanism is the backbone of a good automotive battery thermal management system (BTMS). In addition to prevention of extreme events such as thermal runaway, an automotive BTMS must be able to efficiently tackle aggressive environmental temperatures, and/or discharge and charge conditions during electric vehicle operation. Moreover, electrical performance and cycle life of the battery modules and packs are closely tied to the battery temperatures and thermal gradients, which increase with increase in C-Rates. In order to keep the battery temperatures to be under the operational temperature limit, it is crucial that the selected cooling mechanism provides efficient transport of the heat generated by the battery modules and packs to the cooling media under all discharge and charge conditions. Owing to its efficient thermal performance, liquid cooling is preferred by most electric vehicle manufacturers for battery thermal management. This usually incorporates battery modules exchanging heat with a flowing coolant via cold plate or cooling channels during operation. The current work aims to investigate different liquid cooling configurations and compare their relative thermal performance during operation of a high energy density Pouch Cell. The four configurations selected for this comparison are (1) Face cooling, (2) Single-Sided cooling, (3) Double-Sided cooling, and (4) a Hybrid cooling configuration. Test setups comprising of a commercially available 9 A-h NMC Pouch cell, cold plates, pump, heat exchanger, refrigeration cooling unit, and thermal sensors are built for the above four cooling configurations. During the tests, the selected cell is discharged at different discharge rates (C-Rates), i.e., 3C, 4C, and 5C. The overall cell temperatures and thermal gradient across the cell are measured using T-type thermocouples for the four cooling configurations. In order to capture the thermal gradient across the Pouch cell accurately, several thermocouples on the face of the cell are installed using a thermal interface material. Results show the superiority of Face cooling configuration in terms of overall thermal performance under all considered test conditions. Lowest cell temperatures and thermal gradients across the cell are observed for the Face cooling configuration, while highest temperatures and thermal gradients are observed for the Single-Sided cooling configuration. Much improved thermal performance is also observed in the case of the Hybrid cooling configuration as compared to the Single and Double-Sided cooling configurations. As implementation of the Face cooling configuration at the battery pack level may result in higher weight and cost of the battery pack, owing to its good thermal performance and straightforward scaling to battery pack level, the proposed hybrid liquid cooling mechanism provides a viable alternative to Face cooling for battery thermal management.
Thermal Analysis and Improvements of the Power Battery Pack with Liquid Cooling for Electric Vehicles
