scholarly journals Copper Extraction from Oxide Ore of Almalyk Mine by H2SO4 in Simulated Heap Leaching: Effect of Particle Size and Acid Concentration

Minerals ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 1020
Author(s):  
Chan-Ung Kang ◽  
Seung-Eun Ji ◽  
Thomas Pabst ◽  
Kung-Won Choi ◽  
Moonis Ali Khan ◽  
...  
Keyword(s):  
Particle Size ◽  
Acid Concentration ◽  
Cost Effective ◽  
Extraction Rate ◽  
Real Field ◽  
Copper Extraction ◽  
Cost Effective Approach ◽  
Acid Consumption ◽  
Effect Of Particle Size ◽  
Leaching Experiments

In this investigation, a laboratory-scale study to extract copper (Cu) from its oxide ore (0.425–11.2 mm particle size) was conducted using varied sulfuric acid (H2SO4) concentrations (0.05–0.5 M) as a lixiviant. Through a physicochemical and mineralogical analysis of real field ore samples from the Almalyk mine heap site (Tashkent, Uzbekistan), malachite was identified as a Cu-bearing mineral. Extraction rates were analyzed according to the ore particle size and acid concentration. The Cu extraction with the smallest particle size (in 24 h) varied between 76.7% and 94.26% at varied H2SO4 concentrations (0.05–0.5 M). Almost half (50%) of Cu was extracted from the ore within 4 and 72 h of contact time for 0.425–2 mm and 5.6–11.2 mm particle sizes, respectively, using 0.15 M H2SO4. Weeklong leaching experiments with 0.5 M H2SO4 revealed a higher copper extraction rate (≥73%) from coarse ore particles (5.6–11.2 mm). Along with the copper extraction, iron (29.6 wt%), aluminum (70.2 wt%), magnesium (85.4 wt%), and calcium (44.4 wt%) were also leached out considerably through the dissolution of silicate and carbonate gangue minerals. In this study, an 80.0–94.26% copper extraction rate with reduced acid consumption (20%) proved to be a cost-effective approach.

scholarly journals Initial Investigation into the Leaching of Manganese from Nodules at Room Temperature with the Use of Sulfuric Acid and the Addition of Foundry Slag—Part I

Minerals ◽  
2018 ◽  
Vol 8 (12) ◽  
pp. 565 ◽  
Author(s):  
Norman Toro ◽  
Nelson Herrera ◽  
Jonathan Castillo ◽  
Cynthia Torres ◽  
Rossana Sepúlveda
Keyword(s):  
Particle Size ◽  
Sulfuric Acid ◽  
Acid Concentration ◽  
Room Temperature ◽  
Sulfuric Acid Concentration ◽  
Extraction Rate ◽  
Molar Ratio ◽  
Independent Variables ◽  
Initial Investigation ◽  
Optimization Methodology

In this study, the surface optimization methodology was used to assess the effect of three independent variables—time, particle size and sulfuric acid concentration—on Mn extraction from marine nodules during leaching with H2SO4 in the presence of foundry slag. The effect of the MnO2/Fe ratio and particle size (MnO2) was also investigated. The maximum Mn extraction rate was obtained when a MnO2 to Fe molar ratio of 0.5, 1 M of H2SO4, −320 + 400 Tyler mesh (−47 + 38 μm) nodule particle size and a leaching time of 30 min were used.

scholarly journals Copper Extraction from Black Copper Ores through Modification of the Solution Potential in the Irrigation Solution

Metals ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 1339
Author(s):  
Oscar Benavente ◽  
Ma.Cecilia Hernández ◽  
Evelyn Melo ◽  
Luis Ardiles ◽  
Víctor Quezada ◽  
...  
Keyword(s):  
Sulfuric Acid ◽  
Sulfur Dioxide ◽  
Acid Leaching ◽  
Extraction Rate ◽  
Copper Extraction ◽  
Leaching Tests ◽  
Column Leaching ◽  
White Metal ◽  
Acid Consumption ◽  
Irrigation Solution

This article presented the behavior of ores containing black copper under acid leaching. The solution potential was modified by adding agents, and five leaching conditions were evaluated, one as a control based on sulfuric acid leaching (conventional), and the others by changing the solution potential with: ferrous sulfate (FeSO4), white metal (Cu2S), sulfur dioxide (SO2), and ozone (O3). Leaching behavior was evaluated with laboratory bottle (ISO-pH) and column leaching tests. Two ores samples from the Lomas Bayas mine were used. The samples, identified as low (LG) and high grade (HG), were characterized as 0.13–0.25% Cu and 0.15–0.38% Mn, respectively. The mineralogical analysis indicated that black copper represented around 20% of total Cu (0.05% Cu). The results of the bottle tests indicated that the solution potential decreased with the addition of reducing agents, while the copper extraction rate with the HG sample increased to 83.7%, which exceeded the extraction rate obtained by conventional acid leaching by 25%. Ozone did not favor the extraction of Mn and Cu extraction when the solution potential increased. Cu and Mn extraction were directly related. The results of the column leaching tests showed that it was possible to maintain the solution potential at values below 600 mV (SHE) with the addition of white metal and sulfur dioxide while obtaining the highest copper extraction rate of approximately 60%, which was 18% higher than the rate obtained with conventional leaching. Sulfuric acid consumption was 11 kg/t over 45 days of leaching.

scholarly journals Leaching Chalcopyrite Concentrate with Oxygen and Sulfuric Acid Using a Low-Pressure Reactor

Metals ◽  
2019 ◽  
Vol 9 (2) ◽  
pp. 189 ◽  
Author(s):  
Josué Cháidez ◽  
José Parga ◽  
Jesús Valenzuela ◽  
Raúl Carrillo ◽  
Isaías Almaguer
Keyword(s):  
Particle Size ◽  
Sulfuric Acid ◽  
Acid Concentration ◽  
Oxygen Pressure ◽  
Batch Reactor ◽  
Sulfuric Acid Concentration ◽  
Low Pressure ◽  
Copper Extraction ◽  
Solid Concentration ◽  
Chalcopyrite Concentrate

This article presents a copper leaching process from chalcopyrite concentrates using a low-pressure reactor. The experiments were carried out in a 30 L batch reactor at an oxygen pressure of 1 kg/cm2 and solid concentration of 100 g/L. The temperature, particle size and initial acid concentration were varied based on a Taguchi L9 experimental design. The initial and final samples of the study were characterized by chemical analysis, X-ray diffraction and particle size distribution. The mass balance showed that 98% of copper was extracted from the chalcopyrite concentrate in 3 h under the following experimental conditions: 130 g/L of initial sulfuric acid concentration, temperature of 100 °C, oxygen pressure of 1 kg/cm2, solid concentration of 100 g/L and particle size of −105 + 75 μm. The ANOVA demonstrated that temperature had the greatest influence on copper extraction. The activation energy was 61.93 kJ/mol. The best fit to a linear correlation was the chemical reaction equation that controls the kinetics for the leaching copper from chalcopyrite. The images obtained by SEM showed evidence of shrinking in the core model with the formation of a porous elemental sulfur product layer.

Effect of particle size on erosion measurements and predictions in annular flow for an elbow

Wear ◽  
2020 ◽  
pp. 203579
Author(s):  
G. Haider ◽  
M. Othayq ◽  
J. Zhang ◽  
R.E. Vieira ◽  
S.A. Shirazi
Keyword(s):  
Particle Size ◽  
Annular Flow ◽  
Effect Of Particle Size

The Effect of Particle Size and Phospholipid on Growth and Fat Utilization of the Baby Pig

1951 ◽  
Vol 10 (4) ◽  
pp. 867-874 ◽  
Author(s):  
B. E. Sheffy ◽  
Carlos Acevedo Gallegos ◽  
R. H. Grummer ◽  
P. H. Phillips ◽  
G. Bohstedt
Keyword(s):  
Particle Size ◽  
Fat Utilization ◽  
Effect Of Particle Size

E-Insurance :A Platform For Insurance Penetration In India

2019 ◽  
Vol 118 (6) ◽  
pp. 90-93
Author(s):  
L. Terina Grazy ◽  
Dr.G. Parimalarani
Keyword(s):  
Insurance Industry ◽  
Cost Effective ◽  
Online Marketing ◽  
Insurance Companies ◽  
The Internet ◽  
Insurance Sector ◽  
The People ◽  
Cost Effective Approach ◽  
Time And Energy ◽  
Work Done

E-commerce is a part of Internet Marketing. The arrival of Internet made the world very simple and dynamic in all the areas. Internet is the growing business as a result most of the people are using it in their day to day life. E-commerce is attractive and efficient way for both buyers and sellesr as it reduce cost, time and energy for the buyer. No surprise the insurance sector has become quite active within the internet sphere. Most insurance companies are offering policies to be brought online and also the portals for paying premiums. It actually saves from hassles involved in going to an insurance office and spend hours to get the insurance work done. Insurance has become an important and crucial aspect of life. Online insurance is the best and most cost effective approach of taking the insurance deal. This paper focused on influence of online marketing on the insurance industry in India, usage of internet in India , the internet penetration in India and the online sale of insurance product by the insurance sector.

Sign in / Sign up

Export Citation Format

Share Document