scholarly journals Validation of 7 Years in-Flight HY-2A Calibration Microwave Radiometer Products Using Numerical Weather Model and Radiosondes

2019 ◽  
Vol 11 (13) ◽  
pp. 1616 ◽  
Author(s):  
Zhilu Wu ◽  
Jungang Wang ◽  
Yanxiong Liu ◽  
Xiufeng He ◽  
Yang Liu ◽  
...  
Keyword(s):  
Microwave Radiometer ◽  
The Arctic ◽  
Radiosonde Data ◽  
Polar Regions ◽  
Systematic Bias ◽  
Tropical Regions ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model ◽  
Interim Products

Haiyang-2A (HY-2A) has been working in-flight for over seven years, and the accuracy of HY-2A calibration microwave radiometer (CMR) data is extremely important for the wet troposphere delay correction (WTC) in sea surface height (SSH) determination. We present a comprehensive evaluation of the HY-2A CMR observation using the numerical weather model (NWM) for all the data available period from October 2011 to February 2018, including the WTC and the precipitable water vapor (PWV). The ERA(ECMWF Re-Analysis)-Interim products from European Centre for Medium-Range Weather Forecasts (ECMWF) are used for the validation of HY-2A WTC and PWV products. In general, a global agreement of root-mean-square (RMS) of 2.3 cm in WTC and 3.6 mm in PWV are demonstrated between HY-2A observation and ERA-Interim products. Systematic biases are revealed where before 2014 there was a positive WTC/PWV bias and after that, a negative one. Spatially, HY-2A CMR products show a larger bias in polar regions compared with mid-latitude regions and tropical regions and agree better in the Antarctic than in the Arctic with NWM. Moreover, HY-2A CMR products have larger biases in the coastal area, which are all caused by the brightness temperature (TB) contamination from land or sea ice. Temporally, the WTC/PWV biases increase from October 2011 to March 2014 with a systematic bias over 1 cm in WTC and 2 mm in PWV, and the maximum RMS values of 4.62 cm in WTC and 7.61 mm in PWV occur in August 2013, which is because of the unsuitable retrieval coefficients and systematic TB measurements biases from 37 GHz band. After April 2014, the TB bias is corrected, HY-2A CMR products agree very well with NWM from April 2014 to May 2017 with the average RMS of 1.68 cm in WTC and 2.65 mm in PWV. However, since June 2017, TB measurements from the 18.7 GHz band become unstable, which led to the huge differences between HY-2A CMR products and the NWM with an average RMS of 2.62 cm in WTC and 4.33 mm in PWV. HY-2A CMR shows high accuracy when three bands work normally and further calibration for HY-2A CMR is in urgent need. Furtherly, 137 global coastal radiosonde stations were used to validate HY-2A CMR. The validation based on radiosonde data shows the same variation trend in time of HY-2A CMR compared to the results from ECMWF, which verifies the results from ECMWF.

TOMOREF operator as a tool to improve weather forecasts

2021 ◽  
Author(s):  
Natalia Hanna ◽  
Estera Trzcina ◽  
Maciej Kryza ◽  
Witold Rohm
Keyword(s):  
Data Assimilation ◽  
Weather Forecasting ◽  
Positive Impact ◽  
Precipitation Event ◽  
Initial State ◽  
Total Delay ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model ◽  
Tomography Data

<p>The numerical weather model starts from the initial state of the Earth's atmosphere in a given place and time. The initial state is created by blending the previous forecast runs (first-guess), together with observations from different platforms. The better the initial state, the better the forecast; hence, it is worthy to combine new observation types. The GNSS tomography technique, developed in recent years, provides a 3-D field of humidity in the troposphere. This technique shows positive results in the monitoring of severe weather events. However, to assimilate the tomographic outputs to the numerical weather model, the proper observation operator needs to be built.</p><p>This study demonstrates the TOMOREF operator dedicated to the assimilation of the GNSS tomography‐derived 3‐D fields of wet refractivity in a Weather Research and Forecasting (WRF) Data Assimilation (DA) system. The new tool has been tested based on wet refractivity fields derived during a very intense precipitation event. The results were validated using radiosonde observations, synoptic data, ERA5 reanalysis, and radar data. In the presented experiment, a positive impact of the GNSS tomography data assimilation on the forecast of relative humidity (RH) was noticed (an improvement of root‐mean‐square error up to 0.5%). Moreover, within 1 hour after assimilation, the GNSS data reduced the bias of precipitation up to 0.1 mm. Additionally, the assimilation of GNSS tomography data had more influence on the WRF model than the Zenith Total Delay (ZTD) observations, which confirms the potential of the GNSS tomography data for weather forecasting.</p>

scholarly journals Implementation of a simple thermodynamic sea ice scheme, SICE version 1.0-38h1, within the ALADIN–HIRLAM numerical weather prediction system version 38h1

2018 ◽  
Vol 11 (8) ◽  
pp. 3347-3368 ◽  
Author(s):  
Yurii Batrak ◽  
Ekaterina Kourzeneva ◽  
Mariken Homleid
Keyword(s):  
Sea Ice ◽  
Numerical Weather Prediction ◽  
Mean Absolute Error ◽  
Weather Prediction ◽  
Absolute Error ◽  
The Arctic ◽  
Polar Regions ◽  
Form Drag ◽  
Numerical Weather ◽  
Ice Surface Temperature

Abstract. Sea ice is an important factor affecting weather regimes, especially in polar regions. A lack of its representation in numerical weather prediction (NWP) systems leads to large errors. For example, in the HARMONIE–AROME model configuration of the ALADIN–HIRLAM NWP system, the mean absolute error in 2 m temperature reaches 1.5 ∘C after 15 forecast hours for Svalbard. A possible reason for this is that the sea ice properties are not reproduced correctly (there is no prognostic sea ice temperature in the model). Here, we develop a new simple sea ice scheme (SICE) and implement it in the ALADIN–HIRLAM NWP system in order to improve the forecast quality in areas influenced by sea ice. The new parameterization is evaluated using HARMONIE–AROME experiments covering the Svalbard and Gulf of Bothnia areas for a selected period in March–April 2013. It is found that using the SICE scheme improves the forecast, decreasing the value of the 2 m temperature mean absolute error on average by 0.5 ∘C in areas that are influenced by sea ice. The new scheme is sensitive to the representation of the form drag. The 10 m wind speed bias increases on average by 0.4 m s−1 when the form drag is not taken into account. Also, the performance of SICE in March–April 2013 and December 2015–December 2016 was studied by comparing modelling results with the sea ice surface temperature products from MODIS and VIIRS. The warm bias (of approximately 5 ∘C) of the new scheme is indicated for areas of thick ice in the Arctic. Impacts of the SICE scheme on the modelling results and possibilities for future improvement of sea ice representation in the ALADIN–HIRLAM NWP system are discussed.

scholarly journals Ice Concentration Retrieval from the Analysis of Microwaves: A New Methodology Designed for the Copernicus Imaging Microwave Radiometer

2020 ◽  
Vol 12 (7) ◽  
pp. 1060 ◽  
Author(s):  
Lise Kilic ◽  
Catherine Prigent ◽  
Filipe Aires ◽  
Georg Heygster ◽  
Victor Pellet ◽  
...  
Keyword(s):  
Sea Ice ◽  
Spatial Resolution ◽  
Microwave Radiometer ◽  
Optimal Estimation ◽  
Arctic Sea Ice ◽  
The Arctic ◽  
Special Focus ◽  
Polar Regions ◽  
Sea Ice Concentration ◽  
Ice Concentration

Over the last 25 years, the Arctic sea ice has seen its extent decline dramatically. Passive microwave observations, with their ability to penetrate clouds and their independency to sunlight, have been used to provide sea ice concentration (SIC) measurements since the 1970s. The Copernicus Imaging Microwave Radiometer (CIMR) is a high priority candidate mission within the European Copernicus Expansion program, with a special focus on the observation of the polar regions. It will observe at 6.9 and 10.65 GHz with 15 km spatial resolution, and at 18.7 and 36.5 GHz with 5 km spatial resolution. SIC algorithms are based on empirical methods, using the difference in radiometric signatures between the ocean and sea ice. Up to now, the existing algorithms have been limited in the number of channels they use. In this study, we proposed a new SIC algorithm called Ice Concentration REtrieval from the Analysis of Microwaves (IceCREAM). It can accommodate a large range of channels, and it is based on the optimal estimation. Linear relationships between the satellite measurements and the SIC are derived from the Round Robin Data Package of the sea ice Climate Change Initiative. The 6 and 10 GHz channels are very sensitive to the sea ice presence, whereas the 18 and 36 GHz channels have a better spatial resolution. A data fusion method is proposed to combine these two estimations. Therefore, IceCREAM will provide SIC estimates with the good accuracy of the 6+10GHz combination, and the high spatial resolution of the 18+36GHz combination.

Synergistic Use of Satellite Observations and Numerical Weather Model to Study Atmospheric Occluded Fronts

2015 ◽  
Vol 53 (9) ◽  
pp. 5269-5279 ◽  
Author(s):  
Xiaofeng Li ◽  
Xiaofeng Yang ◽  
Weizhong Zheng ◽  
Jun A. Zhang ◽  
Leonard J. Pietrafesa ◽  
...  
Keyword(s):  
Satellite Observations ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model

scholarly journals PREDIKSI DEBIT SUNGAI BENGAWAN SOLO MENGGUNAKAN NUMERICAL WEATHER MODEL GLOBAL FORECAST SYSTEM DAN INTEGRATED FLOOD ANALYSIS SYSTEM (Prediction of discharge in Bengawan Solo River using Numerical Weather Model Global Forecast System and Integrated Flood Analysis System)

2021 ◽  
Vol 5 (1) ◽  
pp. 41-50
Author(s):  
Deffi Munadiyat Putri ◽  
◽  
Aries Kristianto ◽  
Keyword(s):  
Weather Research And Forecasting ◽  
Global Forecast System ◽  
Forecast System ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model ◽  
Simulation Based ◽  
Discharge Simulation ◽  
Flood Analysis ◽  
Analysis System

Flood is one of the most common hydro-meteorological disasters. Bengawan Solo is one of the watersheds in Indonesia that also hit by this disaster. This study discusses the flood disaster in the Bengawan Solo area in early March 2019. The purpose of this study is to conduct a discharge simulation using numerical weather model Global Forecast System (GFS) data through Integrated Flood Analysis System (IFAS) so it is possible to predict discharge in the future. There are three types of numerical weather model GFS data that have been downscale using weather research and forecasting model which differentiated based on spin-up time. The numerical weather model product is then used as rainfall data input for IFAS simulation. Based on the analysis, the flood discharge simulation using an 84-hour spin-up time has a satisfactory performance in describing the change in discharge with respect to time. This happens because numerical weather models will be better at quantifying processes that occur on a meso scale with spatial scale of 10 to 1000 km. The result of this research shows that it is possible to predict river discharge up to 84 hours before the disaster so this is can support the mitigation process for hydrometeorological disasters.

Sign in / Sign up

Export Citation Format

Share Document