scholarly journals The Role of Management of Stream–Riparian Zones on Subsurface–Surface Flow Components

Water ◽  
2019 ◽  
Vol 11 (9) ◽  
pp. 1905 ◽  
Author(s):  
Steiness ◽  
Jessen ◽  
Spitilli ◽  
van’t Veen ◽  
Højberg ◽  
...  

A managed riparian lowland in a glacial landscape (Holtum catchment, Denmark) was studied to quantify the relative importance of subsurface and surface flow to the recipient stream. The hydrogeological characterization combined geoelectrical methods, lithological logs, and piezometric heads with monthly flow measurements of springs, a ditch, and a drain, to determine seasonality and thereby infer flow paths. In addition, groundwater discharge through the streambed was estimated using temperature and water-stable isotopes as tracers. The lowland received large groundwater inputs with minimal seasonal variations from adjacent upland aquifers. This resulted in significant amounts of groundwater-fed surface flow to the stream, via man-made preferential flow paths comprising ditches, drainage systems, and a pond, and via two natural springs. Roughly, two thirds of the stream gain was due to surface flow to the stream, mainly via anthropogenic alterations. In contrast, direct groundwater discharge through the streambed accounted for only 4% of the stream flow gain, although bank seepage (not measured) to the straightened and deepened stream potentially accounted for an additional 17%. Comparison to analogous natural flow systems in the catchment substantiate the impact of anthropogenic alterations of riparian lowlands for the subsurface and surface flow components to their streams.

2016 ◽  
Author(s):  
Nicolas R. Leroux ◽  
John W. Pomeroy

Abstract. Accurate estimation of the water flux through melting snowpacks is of primary importance for runoff prediction. Lateral flows and preferential flow pathways in porous media flow have proven critical for improving soil and groundwater flow models, but though many physically-based layered snowmelt models have been developed, only 1D matrix flow over level ground is currently accounted for in snow models. Snowmelt models that include these processes may improve snowmelt discharge timing and contributing area calculations in hydrological models. A two-dimensional snow model (SMPP – Snowmelt Model with Preferential flow Paths) is presented that simulates heat and water flows through both snowpack matrix and preferential flow paths, as well as snowmelt and refreezing of meltwater. The model assumes thermodynamic equilibrium between solid and liquid phases and uses the latest improvements made in snow science to estimate snow hydraulic and thermal properties. A finite volume method is applied to solve for the 2D heat and water equations. The use of a water entry pressure for dry snow combined with consideration of the impact of heterogeneities in surface fluxes and internal snow properties – density, grain size and layer thickness – allowed calculation of the formation of preferential flow paths in the snowpack. The simulation of water flow through preferential flow paths resulted in liquid water reaching the base of the snowpack earlier than for a homogeneous wetting front. Moreover, the preferential flow paths in the model increased the exchange of energy between the snow surface and the internal snowpack, resulting in faster warming of the snowpack. A sensitivity analysis, conducted on the snow internal properties showed that initial conditions such as density and temperature, should be carefully measured in the field to accurately estimate liquid water percolating through the snowpack. Furthermore, two empirical coefficients used in the water flow equation were showed to greatly impact model outputs. This heterogeneous flow model is an important tool to help understand snowmelt flow processes in complex and level terrains and to demonstrate how uncertainty in snowmelt-derived runoff calculations might be reduced.


2021 ◽  
Author(s):  
Thom Bogaard

<p>Precipitation is one of the main causes for the initiation or reactivation of deep seated slow moving landslides. Preferential flow paths can have multiple origins, they can be due to changes in soil water content such as desiccation, due to mechanical movement or due to biological activity. The overarching characteristic is that they strongly alter the hydraulic properties of the landslide material. This results in a complex hydrological behaviour of deep-seated slow moving landslides. Research has shown that for instance the porosity of the soil, the fissure distribution and fissure connectivity are very important to predict the behaviour of the hydrological response of precipitation within a landslide body. However, due to large heterogeneity of landslide lithology and spatial and temporal variation of a landslide, it is hard to model water levels in landslides. Cracks and fissures inside the landslide are the cause of preferential flow paths, which can work as infiltration networks to the groundwater, but also as drainage networks lowering the (perched) groundwater levels.</p><p>In the last decades, both methodological progress has been made and several case studies have been published. However, most are still somewhat anecdotic examples and a more overarching conceptualisation has not been made yet. In this overview I want to highlight the progress as well as obstacles and challenges ahead of us when assessing and quantifying the impact of preferential flow paths on the mechanisms of a slow moving deep-seated landslide and to improve our understanding and modelling of complex landslides.</p>


2021 ◽  
Author(s):  
Anne Hartmann ◽  
Markus Weiler ◽  
Konrad Greinwald ◽  
Theresa Blume

Abstract. Hydrologic processes play an important role in the hydro-pedo-geomorphological feedback cycle of landscape evolution. Soil properties and subsurface flow paths change over time, but due to lack of observations important hydrologic processes such as water flow paths are often not properly considered in soil and landscape evolution studies. We investigated the evolution of subsurface flow paths during landscape development in the calcareous glacier forefield at the Griessfirn in the Swiss Alps. While the main focus was on flow path evolution and the formation of preferential flow paths with soil development, we also looked at the impact of irrigation intensity and vegetation complexity (in what way does the vegetation complexity defined by degree of vegetation cover and functional diversity at each age class relate to subsurface structures and flow path initialization?). We chose four glacial moraines of different ages (110, 160, 4 900, and 13 500 years) and conducted dye tracer experiments with Brilliant Blue (4 g l−1) on three plots at each moraine. The three plots at each age class differed by their degree of vegetation complexity (low, medium, and high) and each was further divided into three equal subplots where dyed water was applied with three different irrigation intensities (20, 40, and 60 mm h−1) and an irrigation amount of 40 mm. Dye pattern characteristics in form of volume density and surface area density were derived by digital image analysis and compared via statistical analysis.Volume density was used to classify the observed dye patterns into specific flow type categories. The effect of soil formation and thus changing soil characteristics on flow types were investigated by the analysis of structural and textural parameters in form of grain size distribution, porosity, bulk density, and loss on ignition. A change in flow types with increasing moraine age was observed from a rather homogeneous matrix flow to heterogeneous matrix and finger flow. Along the soil chronosequence, a reduction in particle sizes and an ongoing vegetation development resulted in an accumulation of organic matter in the topsoil and an increase in water storage capacity (decrease in bulk density and increase in porosity). Differences in irrigation intensity only had an effect on flow types at the oldest moraine, where the frequency of finger flow decreased with increasing irrigation intensity. A relation between vegetation complexity and flow types was only observed at the older moraines, which had a dense vegetation cover. With increasing vegetation complexity the proportion of preferential flow paths in form of finger flow also increased.


2002 ◽  
Vol 66 (2) ◽  
pp. 347 ◽  
Author(s):  
Zhi Wang ◽  
Jianhang Lu ◽  
Laosheng Wu ◽  
Thomas Harter ◽  
William A. Jury

2005 ◽  
Vol 69 (2) ◽  
pp. 291-300 ◽  
Author(s):  
Young-Jin Kim ◽  
Christophe J. G. Darnault ◽  
Nathan O. Bailey ◽  
J.-Yves Parlange ◽  
Tammo S. Steenhuis

SPE Journal ◽  
2015 ◽  
Vol 20 (04) ◽  
pp. 689-700 ◽  
Author(s):  
S.. Ameen ◽  
A. Dahi Taleghani

Summary Injectivity loss is a common problem in unconsolidated-sand formations. Injection of water into a poorly cemented granular medium may lead to internal erosion, and consequently formation of preferential flow paths within the medium because of channelization. Channelization in the porous medium might occur when fluid-induced stresses become locally larger than a critical threshold and small grains are dislodged and carried away; hence, porosity and permeability of the medium will evolve along the induced flow paths. Vice versa, flowback during shut-in might carry particles back to the well and cause sand accumulation inside the well, and subsequently loss of injectivity. In most cases, to maintain the injection rate, operators will increase injection pressure and pumping power. The increased injection pressure results in stress changes and possibly further changes in channel patterns around the wellbore. Experimental laboratory studies have confirmed the presence of the transition from uniform Darcy flow to a fingered-pattern flow. To predict these phenomena, a model is needed to fill this gap by predicting the formation of preferential flow paths and their evolution. A model based on the multiphase-volume-fraction concept is used to decompose porosity into mobile and immobile porosities where phases may change spatially, evolve over time, and lead to development of erosional channels depending on injection rates, viscosity, and rock properties. This model will account for both particle release and suspension deposition. By use of this model, a methodology is proposed to derive model parameters from routine injection tests by inverse analysis. The proposed model presents the characteristic behavior of unconsolidated formation during fluid injection and the possible effect of injection parameters on downhole-permeability evolution.


Biofouling ◽  
2013 ◽  
Vol 29 (9) ◽  
pp. 1069-1086 ◽  
Author(s):  
Simona Bottero ◽  
Tomas Storck ◽  
Timo J. Heimovaara ◽  
Mark C.M. van Loosdrecht ◽  
Michael V. Enzien ◽  
...  

2017 ◽  
Vol 21 (11) ◽  
pp. 5503-5515 ◽  
Author(s):  
Hiroyuki Hirashima ◽  
Francesco Avanzi ◽  
Satoru Yamaguchi

Abstract. The heterogeneous movement of liquid water through the snowpack during precipitation and snowmelt leads to complex liquid water distributions that are important for avalanche and runoff forecasting. We reproduced the formation of capillary barriers and the development of preferential flow through snow using a three-dimensional water transport model, which was then validated using laboratory experiments of liquid water infiltration into layered, initially dry snow. Three-dimensional simulations assumed the same column shape and size, grain size, snow density, and water input rate as the laboratory experiments. Model evaluation focused on the timing of water movement, thickness of the upper layer affected by ponding, water content profiles and wet snow fraction. Simulation results showed that the model reconstructs relevant features of capillary barriers, including ponding in the upper layer, preferential infiltration far from the interface, and the timing of liquid water arrival at the snow base. In contrast, the area of preferential flow paths was usually underestimated and consequently the averaged water content in areas characterized by preferential flow paths was also underestimated. Improving the representation of preferential infiltration into initially dry snow is necessary to reproduce the transition from a dry-snow-dominant condition to a wet-snow-dominant one, especially in long-period simulations.


2013 ◽  
Vol 17 (3) ◽  
pp. 947-959 ◽  
Author(s):  
D. M. Krzeminska ◽  
T. A. Bogaard ◽  
J.-P. Malet ◽  
L. P. H. van Beek

Abstract. The importance of hydrological processes for landslide activity is generally accepted. However, the relationship between precipitation, hydrological responses and movement is not straightforward. Groundwater recharge is mostly controlled by the hydrological material properties and the structure (e.g., layering, preferential flow paths such as fissures) of the unsaturated zone. In slow-moving landslides, differential displacements caused by the bedrock structure complicate the hydrological regime due to continuous opening and closing of the fissures, creating temporary preferential flow paths systems for infiltration and groundwater drainage. The consecutive opening and closing of fissure aperture control the formation of a critical pore water pressure by creating dynamic preferential flow paths for infiltration and groundwater drainage. This interaction may explain the seasonal nature of the slow-moving landslide activity, including the often observed shifts and delays in hydrological responses when compared to timing, intensity and duration of precipitation. The main objective of this study is to model the influence of fissures on the hydrological dynamics of slow-moving landslide and the dynamic feedbacks between fissures, hydrology and slope stability. For this we adapt the spatially distributed hydrological and slope stability model (STARWARS) to account for geotechnical and hydrological feedbacks, linking between hydrological response of the landside and the dynamics of the fissure network and applied the model to the hydrologically controlled Super-Sauze landslide (South French Alps).


Sign in / Sign up

Export Citation Format

Share Document