Rapid rates of development in production of powder coatings are, in comparison to liquid paint-and-lacquer materials, evidence of their importance, high effectiveness and prospectivity. The increase in popularity of powder coatings can be explained by their environmental adequacy and attractiveness from the perspective of the environmental protection as well as high effectiveness related to the possibility of obtaining high quality protective and decorative coatings during the one-layer application. At the same time, it is obvious that during modern powder coating-and-lacquer materials have not exhausted all possibilities of improving pharmaceutical compositions and expanding the assortment as well as modernizing their production technology the relatively short period of their development. The composition of the thermosetting powder coating contains five key components: polymer resin, hardener, pigments, fillers and functional additives. In general, the polymer resin and hardener play a key role in ensuring necessary mechanical characteristics and lifespan of the powder coating. In this case, the role of functional (modifying) additives is extremely important to obtain characteristics that are often fundamentally required to meet predetermined technical specifications of the products and needs of end users. Additives play an important role in forming properties of powder coatings and coatings based on them as they have become their integral part for several main reasons: because of control of rheological properties, surface defects as well as light and temperature stabilization of coatings. The study deals influence of modifying additives on properties of the powder coating. The authors using rheological and degassing modifying additives with different nature of the main active substance. It was found that the additives based on the acrylate polymer adsorbed on the silicon dioxide in the form of Byk-3900P and on the polyoxyethylene derivative of the castor oil in the form of Luvotix R400 decreasing the surface tension in the coating film, which, in its turn, contributes to the increase in the wettability of base during the melting of the powder coating, decrease the ‘orange peel’ effect during the cross-linking, reduction in pinholes on the obtained surface and improvement of mechanical characteristics of the coating. At the same time, rheological additives based on the bentonite in the form of Luvogel 4B and on the hydrophilic silicon dioxide in the form of Cab-o-sil M5 cause the increase in the surface tension in the coating film, which, in its turn, leads to the worsening of flow, appearance and mechanical characteristics of the powder coating.
Determination of Correlation Between Composition, Rolling Parameters and Mechanical Characteristics of the Hot Rolled Steels
