Convective Condensation of Oxy-Coal Combustion Flue Gas of Laminar Fow in a Vertical Pipe

2013 ◽  
Vol 325-326 ◽  
pp. 389-397
Author(s):  
Jing Lan Dong ◽  
Wei Ping Yan ◽  
Chao Hui Zhang

The problem of the oxy-fuel combustion flue gas condensation is the condensation of vapor in the presence of high concentration non-condensable gas. The vapor condensing at dew point temperature releases heat and diffuses on to the surface of the pipe through a non-condensable gas film. Thus it is treated as combined heat and mass transfer problem governed by mass, momentum and energy balance equations for the vaporgas mixture and diffusion equation for the vapor species. The flow of the falling condensate film is governed by the momentum and energy balance equations. The temperature at the gas-to-liquid interface, at which the condensation takes place, is estimated with the help of the heat balance and mass balance equations at the interface. The local values of the condensation Nusselt number, condensate Reynolds number, gasliquid interface temperature and pressure drop are estimated from the numerical results for different values of the system parameters at inlet, such as vapor component, temperature of vaporgas mixture, gas phase Reynolds number and total pressure. The thermodynamic calculations were made and analyzed using numerical calculation method under different conditions.

2007 ◽  
Vol 129 (12) ◽  
pp. 1627-1637 ◽  
Author(s):  
V. Dharma Rao ◽  
V. Murali Krishna ◽  
K. V. Sharma ◽  
P. K. Sarma

The problem of condensation of water vapor from humid air flowing in a duct in turbulent flow is formulated theoretically. Vapor condensing at the dew-point temperature of the vapor-air mixture diffuses to the wall of the duct through an air film. The flow of the condensate is laminar. The condensing vapor releases both convection and latent heats to the wall of the duct. Thus, it is treated as a combined heat and mass transfer problem. The mass, momentum, and energy balance equations for the vapor-air mixture flowing in the duct and the diffusion equation for the vapor species are considered. Ti, the temperature at gas-to-liquid interface, at which condensation takes place, is estimated with the help of the heat balance and mass balance equations at interface. The local and average values of the condensation Nusselt number, condensate Reynolds number, gas-liquid interface temperature, and pressure drop are estimated from the numerical results for different values of the system parameters, such as relative humidity and temperature of air at inlet, gas phase Reynolds number, and total pressure at inlet. The gas phase convection Nusselt and Sherwood numbers are also computed. A comparison of the present work with experimental data, for the case of in-tube condensation of vapor from humid air, shows satisfactory agreement.


2019 ◽  
Vol 20 (5) ◽  
pp. 285-299 ◽  
Author(s):  
El-Sayed Zanoun ◽  
Christoph Egbers ◽  
Ramis Örlü ◽  
Tommaso Fiorini ◽  
Gabriele Bellani ◽  
...  

1994 ◽  
Vol 144 ◽  
pp. 315-321 ◽  
Author(s):  
M. G. Rovira ◽  
J. M. Fontenla ◽  
J.-C. Vial ◽  
P. Gouttebroze

AbstractWe have improved previous model calculations of the prominence-corona transition region including the effect of the ambipolar diffusion in the statistical equilibrium and energy balance equations. We show its influence on the different parameters that characterize the resulting prominence theoretical structure. We take into account the effect of the partial frequency redistribution (PRD) in the line profiles and total intensities calculations.


2020 ◽  
Vol 2 (1) ◽  
pp. 19-24
Author(s):  
Sakhr Mohammed Sultan ◽  
Chih Ping Tso ◽  
Ervina Efzan Mohd Noor ◽  
Fadhel Mustafa Ibrahim ◽  
Saqaff Ahmed Alkaff

Photovoltaic Thermal Solar Collector (PVT) is a hybrid technology used to produce electricity and heat simultaneously. Current enhancements in PVT are to increase the electrical and thermal efficiencies. Many PVT factors such as type of absorber, thermal conductivity, type of PV module and operating conditions are important parameters that can control the PVT performance. In this paper, an analytical model, using energy balance equations, is studied for PVT with an improved parallel flow absorber. The performance is calculated for a typical sunny weather in Malaysia. It was found that the maximum electrical and thermal efficiencies are 12.9 % and 62.6 %, respectively. The maximum outlet water temperature is 59 oC.


1996 ◽  
Vol 61 (9) ◽  
pp. 1267-1284
Author(s):  
Ondřej Wein

Response of an electrodiffusion friction sensor to a finite step of the wall shear rate is studied by numerically solving the relevant mass-transfer problem. The resulting numerical data on transient currents are treated further to provide reasonably accurate analytical representations. Existing approximations to the general response operator are checked by using the obtained exact solution.


2017 ◽  
Vol 53 (6) ◽  
pp. 1-4
Author(s):  
Georgios G. Pyrialakos ◽  
Nikolaos V. Kantartzis ◽  
Tadao Ohtani ◽  
Yasushi Kanai ◽  
Theodoros D. Tsiboukis

Author(s):  
Takafumi Nishino ◽  
Richard H. J. Willden

Recent discoveries on the limiting efficiency of tidal fences are reviewed, followed by a new theoretical investigation into the effect of wake mixing on the efficiency of ‘full’ tidal fences (i.e. turbines arrayed regularly across an entire channel span). The new model is based on the momentum and energy balance equations but includes several unclosed terms, which depend on the actual (three-dimensional) characteristics of turbine near-wake mixing and therefore need to be modelled empirically. The new model agrees well with three-dimensional actuator disk simulations when those unclosed terms are assessed based on the simulations themselves, suggesting that this low-order model could serve as a basis to analyse how various physical factors (such as the design of turbines) affect the limiting efficiency of tidal fences via changes in those terms describing the characteristics of turbine near-wake mixing. Also discussed is the effect of wake mixing on the efficiency of ‘partial’ tidal fences.


2011 ◽  
Vol 130-134 ◽  
pp. 3812-3816
Author(s):  
Gang Xu ◽  
Yao Tian ◽  
Xing Yuan ◽  
Yong Ping Yang

Theoretical model for calculating the outlet flue gas temperature of limestone-gypsum wet flue gas desulfurization (FGD) absorption tower is important for water consumption calculation. In this paper, the energy balance in the spray zone is analyzed and a model for calculating the outlet flue gas temperature of FGD absorption tower is proposed. An example computation of the outlet flue gas temperature of a typical 600MW class unit’s operation data is introduced, the result has verified the model. A further study of significance analysis has then been made to analyze and simplify the model.


Sign in / Sign up

Export Citation Format

Share Document