Improving OFDM Carrier Frequency Synchronization Using Cyclic Prefix

2013 ◽  
Vol 411-414 ◽  
pp. 779-783
Author(s):  
Ju Peng Zhang ◽  
Ming Jiang Wang

Orthogonal Frequency Division Multiplexing (OFDM) is the key technology of high speed communication systems which are widely used today. Small carrier frequency offset can make OFDM system performance fell sharply. So it needs very effective carrier frequency synchronization to make sure that the system works perfect. Seen from a large number of simulations, typical algorithm requires strict symbol timing. According to this characteristic, we proposed an improved carrier frequency synchronization algorithm using cyclic prefix. The improved algorithm can achieve better performance than typical algorithm in multipath fading channel. The precision of the improved algorithm under the same Signal Noise Ratio (SNR) is about 3 orders of magnitude higher than typical algorithm. We found that improved algorithm has more excellent performance in burst packet transmission mode.

2015 ◽  
Vol 18 (3) ◽  
pp. 218-224
Author(s):  
Khoa Le Dang ◽  
Phuong Huu Nguyen ◽  
Hiroshi Ochi

Optical wireless systems have attracted attention, because they allow high-speed transmission without electromagnetic interference. Orthogonal frequency division multiplexing (OFDM) can send multiple high speed signals by using orthogonal carrier frequencies. Recently, studies have been focused on the optimal OFDM technique for optical wireless systems. When using OFDM, one important issue is determining the cyclic prefix and removing it from the frame before the receiver detects signals. In this paper, we propose a new auto synchronization technique of unipolar MPAM signals. It can remove the cyclic prefix in any sample of the OFDM frame using unipolar MPAM. It is a candidate for wideband systems and using 2-PAM or 4-PAM. The results of mathematical analysis and simulations show that it can be used for optical wireless systems.


Author(s):  
Pankaj Kumar Singh

Abstract : In recent years, as a result of advancing VLSI technology, Orthogonal Frequency Division Multiplexing (OFDM) has received a great deal of attention and has been adopted in many new generation wideband data communication systems such as IEEE 802.11a, IEEE 802.16e, HiPerLAN/2, Digital Audio/Video Broadcasting (DAB/DVB), and for 4G Radio mobile communications. This is because of its high bandwidth efficiency as the use of orthogonal waveforms with overlapping spectra. The immunity to multipath fading channel and the capability for parallel signal processing make it a promising candidate for the next generation mobile communication systems. The modulation and demodulation of OFDM based communication systems can be efficiently implemented with an FFT and IFFT, which has made the FFT valuable for those communication systems. The complexity of an OFDM system highly depends upon the computation of Fast Fourier Transform (FFT) algorithm. With the advent of new technology in the fields of VLSI and communication, there is also an ever growing demand for high speed processing and low area design. It is also a well-known fact that the multiplier unit forms an integral part of processor design. Due to this regard, high speed multiplier architectures become the need of the day.


Author(s):  
Sajjan Singh

Orthogonal frequency division multiplexing (OFDM) is an efficient method of data transmission for high speed communication systems over multipath fading channels. However, the peak-to-average power ratio (PAPR) is a major drawback of multicarrier transmission systems such as OFDM is the high sensitivity of frequency offset. The bit error rate analysis (BER) of discrete wavelet transform (DWT)-OFDM system is compared with conventional fast Fourier transform (FFT)-OFDMA system in order to ensure that wavelet transform based OFDMA transmission gives better improvement to combat ICI than FFT-based OFDMA transmission and hence improvement in BER. Wavelet transform is applied together with OFDM technology in order to improve performance enhancement. In the proposed system, a Kalman filter has been used in order to improve BER by minimizing the effect of ICI and noise. The obtained results from the proposed system simulation showed acceptable BER performance at standard SNR.


Information ◽  
2020 ◽  
Vol 11 (4) ◽  
pp. 190 ◽  
Author(s):  
Brahim Bakkas ◽  
Reda Benkhouya ◽  
Idriss Chana ◽  
Hussain Ben-Azza

Orthogonal frequency division multiplexing (OFDM) is the key technology used in high-speed communication systems. One of the major drawbacks of OFDM systems is the high peak-to-average power ratio (PAPR) of the transmitted signal. The transmitted signal with a high PAPR requires a very large linear range of the Power Amplifier (PA) on the transmitter side. In this paper, we propose and study a new clipping method named Palm Clipping (Palm date leaf) based on hyperbolic cosine. To evaluate and analyze its performance in terms of the PAPR and Bit Error Rate (BER), we performed some computer simulations by varying the Clipping Ratio (CR) and modulation schemes. The obtained results show that it is possible to achieve a gain of between 7 and 9 dB in terms of PAPR reduction depending on the type of modulation. In addition, comparison with several techniques in terms of PAPR and BER shows that our method is a strong alternative that can be adopted as a PAPR reduction technique for OFDM-based communication systems.


2017 ◽  
Vol 8 (2) ◽  
pp. 113-116 ◽  
Author(s):  
M. Al-Rawi

The main challenge in any high-speed digital communication system is how to maximize the data rate with minimizing the bit error rate. Several techniques have been developed to achieve this point. Some of these techniques are orthogonal frequency division multiplexing (OFDM), single-carrier frequency domain equalization (SC-FDE), orthogonal frequency division multiple access (OFDMA), and single-carrier frequency division multiple access (SC-FDMA). These four techniques are described briefly in this paper. Also, the paper measures the performances of OFDMA and SC-FDMA systems over international telecommunication union (ITU) vehicular-A channel using minimum mean square error (MMSE) equalization. Simulation results show that the performances with interleaved mapping outperform that with localized mapping. Also, the performances with quadrature phase shift keying (QPSK) are better than that with 16-ary quadrature amplitude modulation (16QAM). In addition, the performance of SC-FDMA is better than that of OFDMA, when QPSK is used, but the latter is little bit better than that of SC-FDMA when 16QAM is used.


Sign in / Sign up

Export Citation Format

Share Document