Study and Application of EOR on Conventional Heavy Oil Reservoir

2011 ◽  
Vol 236-238 ◽  
pp. 825-828
Author(s):  
Chuan Min Xiao

According to the characters of conventional heavy oil reservoir, liquid and exploitation progress, displacement adjustment method was applied to reduce degression and enhance recovery. The experiment results showed the gel time could be controlled and the strength could be adjusted. The flooding oil rate was more 14.3% than water flooding in the lab. The pilot test showed that the test effect of moveable gel flooding was significantly good, the accumulated incremental oil production of 6 well groups is 54756t, input-output ratio is 1: 4.1, which shows satisfactory effects in improving the water flooding effect in this conventional heavy oil reservoirs.

Geophysics ◽  
2017 ◽  
Vol 82 (1) ◽  
pp. B13-B27 ◽  
Author(s):  
Hemin Yuan ◽  
De-Hua Han ◽  
Weimin Zhang

Heavy oil reservoirs are important alternative energy resources to conventional oil and gas reservoirs. However, due to the high viscosity, most production methods of heavy oil reservoirs involve thermal production. Heavy oil reservoirs’ properties change dramatically during thermal production because the viscosity drops drastically with increasing temperature. Moreover, the velocity and density also decrease after steam injection, leading to a longer traveltime of seismic velocities and low impedance of the steam chamber zone. These changes of properties can act as indicators of the steam chamber and can be detected through the time-lapse inversion method. We first establish the rock-physics relationship between oil sands’ impedance and temperature on the basis of our previous laboratory work. Then, we perform the forward modeling of the heavy oil reservoir with the steam chamber to demonstrate the influence of steam injection on seismic profiles. Then, we develop a modified-Cauchy prior-distribution-based time-lapse inversion method and perform a 2D model test. The inversion method is then applied on the real field data, and the results are analyzed. By combining the inverted impedance and rock-physics relation between impedance and temperature, the temperature distribution map is obtained, which can work as an indicator of steam chamber. Finally, an empirical relation between impedance and velocity is established, and velocity is derived from the impedance.


Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-8
Author(s):  
Xingmin Li ◽  
Changchun Chen ◽  
Zhangcong Liu ◽  
Yongbin Wu ◽  
Xiaoxing Shi

Nowadays, extra heavy oil reservoirs in the Orinoco Heavy-Oil-Belt in Venezuela are exploited via cold production process, which present different production performance in well productivity and primary recovery factor. The purpose of this study is to investigate the causes for such differences with the aspect of foamy oil mechanism. Two typical oil samples were adopted from a shallow reservoir in western Junìn region and a middepth reservoir in eastern Carabobo region in the Belt, respectively. A depletion test was conducted using 1D sand-pack with a visualized microscopic flow observation installation for each of the oil samples under simulated reservoir conditions. The production performance, the foamy oil behaviour, and the oil and gas morphology were recorded in real time during the tests. The results indicated that the shallow heavy oil reservoir in the Belt presents a weaker foamy oil phenomenon when compared with the middepth one; its foamy oil behaviour lasts a shorter duration with a smaller scope, with bigger bubble size and less bubble density. The difference in foamy oil behaviour for those two types of heavy oil reservoir is caused by the difference in reservoir pressure, solution GOR, asphaltene content, etc. Cold production presents obvious features of three stages under the action of strong foamy oil displacement mechanism for the middepth heavy oil reservoir, which could achieve a more favourable production performance. In the contrary, no such obvious production characteristics for the shallow heavy oil reservoir are observed due to weaker foamy oil behaviour, and its primary recovery factor is 9.38 percent point lower than which of the middle heavy oil reservoirs.


2013 ◽  
Vol 316-317 ◽  
pp. 834-837
Author(s):  
Zong Zhan Xue ◽  
Deng Fa He ◽  
Xiao Heng Wang

Now in situ combustion became one of the ways for the developed heavy oil reservoirs to convert development pattern and improve recovery. After long time steam huff and puff development in heavy oil reservoir, it was obvious that there was a big change on the oil zones and reservoir properties and the reservoir heterogeneity. When it was converted to in situ combustion, the injection gas often break through along the high permeability layers in the fire drive wells that make the sweep area smaller and decrease the reservoir recovery. By analysis on the gas channeling of in situ combustion occurred in the heavy oil reservoirs, the methods was put forward to develop heavy oil reservoir using in situ combustion reasonably including well space infilling, controlling the gas injection rate, adding roam surfactant agent and using fire drive with horizontal well assisted etc. to prevent the condition of gas channeling occurring. It will greatly improve the success and adaptability of the in situ combustion used in vertical wells of the heavy oil reservoir by using these methods. It also will build on basis of the heavy oil reservoir converted to in situ combustion development.


Lithosphere ◽  
2021 ◽  
Vol 2021 (Special 4) ◽  
Author(s):  
Yaguang Qu ◽  
YiPing Ye ◽  
Shichang Ju ◽  
Jiawen Liu ◽  
Meng Lei

Abstract Steam flooding is proven to be an effective method to improve the development effect of heavy oil reservoirs. And steam flooding is the most common oil recovery technology for heavy oil reservoirs in China. However, because of the various reservoir physical properties, bring great challenges to successful steam flooding development. According to the previous research and development practice, we know that reservoir heterogeneity has a great influence on the development effect of water flooding. Due to the heterogeneity of reservoirs, the development of different injection-production well patterns will be affected. However, it is uncertain whether reservoir heterogeneity has an impact on steam flooding development effect. In order to clarify the above scientific issues, we take Xinjiang steam flooding oilfield as the research object to carry out relevant research. According to the reservoir distribution characteristics of Xinjiang Oilfield, three conceptual heterogeneity models representing permeability, thickness, and geometric plane heterogeneity are firstly proposed. Then, mathematic models with different plane heterogeneity of reservoir sand were built. Based on the mathematic model, initial conditions, boundary condition, and geological parameters of conceptual models, different steam flooding patterns were studied by applying numerical calculation. It is found that heterogeneity is an important geological factor affecting the development of steam flooding of heavy oil reservoir. And the results showed that cumulative oil production was different of different flood pattern at the same production condition. It can be concluded that the development effect of steam flooding of heavy reservoirs is strongly influenced by flood pattern. In order to improve development effectiveness of steam flooding of heavy oil reservoirs, flood pattern should be optimized. For each type of plane heterogeneity reservoir, a reasonable flood pattern was proposed. For plane heterogeneity of permeability, thickness, and geometry form, under the conditions of that as the producer was deployed in high permeability, thick, wide sand body and injector was deployed in low permeability, thin, narrow sand body, the recovery of steam flooding in heavy oil reservoir was better. Finally, how the three types of plane heterogeneity influence steam flooding of heavy reservoirs was discussed by adopting a sensitivity analysis method. The results show that the influence of permeability heterogeneity is the largest, thickness heterogeneity is the second, and geometric heterogeneity is the least. This conclusion can help us improve the development of this reservoir. And also, the findings of this study can help for better understanding of properly deployed well pattern and how to effective develop the heavy oil reservoirs of strong plane heterogeneity for other heavy oil reservoirs.


2020 ◽  
Vol 213 ◽  
pp. 02020
Author(s):  
Fachao Shan ◽  
Lun Zhao ◽  
Anzhu Xu ◽  
Bing Bo ◽  
Gang Ma ◽  
...  

Generally the dynamic methods are used to calculate the oil increase after flooding control in the oilfield, but the evaluation results of different methods are quite different, and the evaluation results are uncertain. Therefore, for flooding control well groups in heavy oil reservoirs, the water flooding characteristic curve method, decline method and net oil increase method are used to calculate the oil increase, and the influence of the method parameter values on the results are analyzed, and the parameter value limits and calculation errors of each method are determined. Based on this, the adaptability of each method is proposed. The results show that the effect evaluation of the whole region flooding control is suitable to use the water flooding characteristic curve method or the decline method, the effect evaluation of the single well group flooding control is more suitable to use the decline method, the net oil increase method is not recommended. The application range and parameter value limit of the effect evaluation method of flooding control are put forward, which can guide the actual production effect evaluation in the oilfield.


2021 ◽  
Vol 888 ◽  
pp. 111-117
Author(s):  
Yi Zhao ◽  
De Yin Zhao ◽  
Rong Qiang Zhong ◽  
Li Rong Yao ◽  
Ke Ke Li

With the continuous exploitation of most reservoirs in China, the proportion of heavy oil reservoirs increases, and the development difficulty is greater than that of conventional reservoirs. In view of the important subject of how to improve the recovery factor of heavy oil reservoir, the thermal recovery technology (hot water flooding, steam flooding, steam assisted gravity drainage SAGD and steam huff and puff) and cold recovery technology (chemical flooding, electromagnetic wave physical flooding and microbial flooding) used in the development of heavy oil reservoir are summarized. The principle of action is analyzed, and the main problems restricting heavy oil recovery are analyzed The main technologies of heavy oil recovery are introduced from the aspects of cold recovery and hot recovery. Based on the study of a large number of literatures, and according to the development trend of heavy oil development, suggestions and prospects for the future development direction are put forward.


Fuel ◽  
2015 ◽  
Vol 153 ◽  
pp. 559-568 ◽  
Author(s):  
David W. Zhao ◽  
Ian D. Gates

2012 ◽  
Author(s):  
Chao Liu ◽  
Xinwu Liao ◽  
Yunlai Zhang ◽  
Ming-Ming Chang ◽  
Chunrong Mu ◽  
...  

2018 ◽  
Vol 38 ◽  
pp. 01054
Author(s):  
Guan Wang ◽  
Rui Wang ◽  
Yaxiu Fu ◽  
Lisha Duan ◽  
Xizhi Yuan ◽  
...  

Mengulin sandstone reservoir in Huabei oilfield is low- temperature heavy oil reservoir. Recently, it is at later stage of waterflooding development. The producing degree of water flooding is poor, and it is difficult to keep yield stable. To improve oilfield development effect, according to the characteristics of reservoir geology, microbial enhanced oil recovery to improve oil displacement efficiency is researched. 2 microbial strains suitable for the reservoir conditions were screened indoor. The growth characteristics of strains, compatibility and function mechanism with crude oil were studied. Results show that the screened strains have very strong ability to utilize petroleum hydrocarbon to grow and metabolize, can achieve the purpose of reducing oil viscosity, and can also produce biological molecules with high surface activity to reduce the oil-water interfacial tension. 9 oil wells had been chosen to carry on the pilot test of microbial stimulation, of which 7 wells became effective with better experiment results. The measures effective rate is 77.8%, the increased oil is 1,093.5 tons and the valid is up to 190 days.


Sign in / Sign up

Export Citation Format

Share Document