The Effect of Wind Speed on Cooling Tower Plume Dispersion

2013 ◽  
Vol 732-733 ◽  
pp. 144-147
Author(s):  
Rui Ping Guo ◽  
Chun Lin Yang ◽  
Chun Ming Zhang

Wind speed was an important impact factor when simulating the cooling tower plume dispersion. The SACTI model was selected in this paper and this model was used to predict the plume dispersion character discharging from cooling tower under normal operation and three different kinds of wind speeds. The three kinds of wind speeds were 2 m/s, 4 m/s and 6 m/s and it was analyzed that the plume character under these three wind speeds. Results showed that the plume length, plume height and plume radius will present different change trend when wind speed changed.

2013 ◽  
Vol 807-809 ◽  
pp. 168-171
Author(s):  
Rui Ping Guo ◽  
Chun Lin Yang ◽  
Chun Ming Zhang ◽  
Bing Lan

The SACTI model (Seasonal Annual Cooling Tower Impact) as the environmental impact assessment of cooling tower was applied in this paper, which was used to simulate the plume characters under different kinds of relative humidity. The three kinds of relative humidity were 70%, 80% and 90% and it was analyzed that the plume character under these three kinds of relative humidity. Results showed that the plume length, plume height and plume radius will present different change trend when relative humidity changed. Additionally, the plume dispersion character in different seasons presented obviously variations and the different wind direction also play important role in prediction of cooling tower plume dispersion.


2019 ◽  
Vol 12 (1) ◽  
pp. 34
Author(s):  
Long Wang ◽  
Cheng Chen ◽  
Tongguang Wang ◽  
Weibin Wang

A new simulation method for the aeroelastic response of wind turbines under typhoons is proposed. The mesoscale Weather Research and Forecasting (WRF) model was used to simulate a typhoon’s average wind speed field. The measured power spectrum and inverse Fourier transform method were coupled to simulate the pulsating wind speed field. Based on the modal method and beam theory, the wind turbine model was constructed, and the GH-BLADED commercial software package was used to calculate the aerodynamic load and aeroelastic response. The proposed method was applied to assess aeroelastic response characteristics of a commercial 6 MW offshore wind turbine under different wind speeds and direction variation patterns for the case study of typhoon Hagupit (2008), with a maximal wind speed of 230 km/h. The simulation results show that the typhoon’s average wind speed field and turbulence characteristics simulated by the proposed method are in good agreement with the measured values: Their difference in the main flow direction is only 1.7%. The scope of the wind turbine blade in the typhoon is significantly larger than under normal wind, while that under normal operation is higher than that under shutdown, even at low wind speeds. In addition, an abrupt change in wind direction has a significant impact on wind turbine response characteristics. Under normal operation, a sharp variation of the wind direction by 90 degrees in 6 s increases the wind turbine (WT) vibration scope by 27.9% in comparison with the case of permanent wind direction. In particular, the maximum deflection of the wind tower tip in the incoming flow direction reaches 28.4 m, which significantly exceeds the design standard safety threshold.


2013 ◽  
Vol 316-317 ◽  
pp. 590-593
Author(s):  
Rui Ping Guo ◽  
Chun Lin Yang ◽  
Chun Ming Zhang

The SACTI model (Seasonal Annual Cooling Tower Impact) as the environmental impact assessment of cooling tower was applied in this paper, which was used to simulate the plume characters under different cooling tower heights. The results showed that the plume length, plume height and plume radius presented noticeable differences with variances of different distances and wind directions under different cooling tower heights. The comparisons of differences of plume characters indicated that the relative change of plume length frequency displayed obvious decreased trend with increased distance when distance was greater than 500m, and that of plume height frequency appeared parabolic curve with increased distance. The relative change of plume radius frequency expressed totally descended trend.


2013 ◽  
Vol 448-453 ◽  
pp. 213-216
Author(s):  
Rui Ping Guo ◽  
Chun Lin Yang ◽  
Bing Lan ◽  
Chun Ming Zhang

This impact of heat rejection on cooling tower plume dispersion was studied in this paper by applied SACTI (Seasonal Annual Cooling Tower Impact) model. In order to analyze the impact of heat rejection (HR), we set five scenarios including observed, HR decrease 5% (HR-5) and 10% (HR-10), and increase 5% (HR+5) and 10% (HR+10). Results showed that plume length frequency, plume height frequency and plume radius frequency will present different variation trend when heat rejection increase and decrease scenarios. On the whole, the plume character parameter will decrease as heat rejection decrease, but will increase as heat rejection increasing.


2012 ◽  
Vol 531 ◽  
pp. 584-588
Author(s):  
Lian Zhong Zhang ◽  
Jing Min Li

Composite generator of solar and wind energy materials the generators, energy-saving environmental protection as a precondition to full use of green renewable energy, making wind power in weak wind conditions and strong winds can maintain normal operation of wind turbines how wind instability Under normal operation, but at higher wind speeds, the blades are not damaged? We start from the pressure-controlled device, the mechanical components and microelectronic technology combine to complete the slurry from the regulator controlled by changing the role of plasma from the body, strengthen the control of wind turbines, wind generators can adapt to changes in wind speed. In the initial wind speed easy to start; in the design of wind speed and wind speed between the initial access to higher wind energy utilization coefficient; In addition, the weak and the solar wind is sufficient,solar power can also get the power to add the function to ensure that the entire power system running smoothly, to achieve full power generation purposes.


Author(s):  
S. G. Ignatiev ◽  
S. V. Kiseleva

Optimization of the autonomous wind-diesel plants composition and of their power for guaranteed energy supply, despite the long history of research, the diversity of approaches and methods, is an urgent problem. In this paper, a detailed analysis of the wind energy characteristics is proposed to shape an autonomous power system for a guaranteed power supply with predominance wind energy. The analysis was carried out on the basis of wind speed measurements in the south of the European part of Russia during 8 months at different heights with a discreteness of 10 minutes. As a result, we have obtained a sequence of average daily wind speeds and the sequences constructed by arbitrary variations in the distribution of average daily wind speeds in this interval. These sequences have been used to calculate energy balances in systems (wind turbines + diesel generator + consumer with constant and limited daily energy demand) and (wind turbines + diesel generator + consumer with constant and limited daily energy demand + energy storage). In order to maximize the use of wind energy, the wind turbine integrally for the period in question is assumed to produce the required amount of energy. For the generality of consideration, we have introduced the relative values of the required energy, relative energy produced by the wind turbine and the diesel generator and relative storage capacity by normalizing them to the swept area of the wind wheel. The paper shows the effect of the average wind speed over the period on the energy characteristics of the system (wind turbine + diesel generator + consumer). It was found that the wind turbine energy produced, wind turbine energy used by the consumer, fuel consumption, and fuel economy depend (close to cubic dependence) upon the specified average wind speed. It was found that, for the same system with a limited amount of required energy and high average wind speed over the period, the wind turbines with lower generator power and smaller wind wheel radius use wind energy more efficiently than the wind turbines with higher generator power and larger wind wheel radius at less average wind speed. For the system (wind turbine + diesel generator + energy storage + consumer) with increasing average speed for a given amount of energy required, which in general is covered by the energy production of wind turbines for the period, the maximum size capacity of the storage device decreases. With decreasing the energy storage capacity, the influence of the random nature of the change in wind speed decreases, and at some values of the relative capacity, it can be neglected.


Energies ◽  
2021 ◽  
Vol 14 (10) ◽  
pp. 2796
Author(s):  
Andrzej Osuch ◽  
Ewa Osuch ◽  
Stanisław Podsiadłowski ◽  
Piotr Rybacki

In the introduction to this paper, the characteristics of Góreckie lake and the construction and operation of the wind-driven pulverizing aerator are presented. The purpose of this manuscript is to determine the efficiency of the pulverizing aerator unit in the windy conditions of Góreckie Lake. The efficiency of the pulverization aerator depends on the wind conditions at the lake. It was necessary to conduct thorough research to determine the efficiency of water flow through the pulverization segment (water pump). It was necessary to determine the rotational speed of the paddle wheel, which depended on the average wind speed. Throughout the research period, measurements of hourly average wind speed were carried out. It was possible to determine the efficiency of the machine by developing a dedicated mathematical model. The latest method was used in the research, consisting of determining the theoretical volumetric flow rates of water in the pulverizing aerator unit, based on average hourly wind speeds. Pulverization efficiency under the conditions of Góreckie Lake was determined based on 6600 average wind speeds for spring, summer and autumn, 2018. Based on the model, the theoretical efficiency of the machine was calculated, which, under the conditions of Góreckie Lake, amounted to 75,000 m3 per year.


Energies ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1587
Author(s):  
Krzysztof Wrobel ◽  
Krzysztof Tomczewski ◽  
Artur Sliwinski ◽  
Andrzej Tomczewski

This article presents a method to adjust the elements of a small wind power plant to the wind speed characterized by the highest annual level of energy. Tests were carried out on the basis of annual wind distributions at three locations. The standard range of wind speeds was reduced to that resulting from the annual wind speed distributions in these locations. The construction of the generators and the method of their excitation were adapted to the characteristics of the turbines. The results obtained for the designed power plants were compared with those obtained for a power plant with a commercial turbine adapted to a wind speed of 10 mps. The generator structure and control method were optimized using a genetic algorithm in the MATLAB program (Mathworks, Natick, MA, USA); magnetostatic calculations were carried out using the FEMM program; the simulations were conducted using a proprietary simulation program. The simulation results were verified by measurement for a switched reluctance machine of the same voltage, power, and design. Finally, the yields of the designed generators in various locations were determined.


2021 ◽  
Vol 9 (3) ◽  
pp. 246
Author(s):  
Difu Sun ◽  
Junqiang Song ◽  
Xiaoyong Li ◽  
Kaijun Ren ◽  
Hongze Leng

A wave state related sea surface roughness parameterization scheme that takes into account the impact of sea foam is proposed in this study. Using eight observational datasets, the performances of two most widely used wave state related parameterizations are examined under various wave conditions. Based on the different performances of two wave state related parameterizations under different wave state, and by introducing the effect of sea foam, a new sea surface roughness parameterization suitable for low to extreme wind conditions is proposed. The behaviors of drag coefficient predicted by the proposed parameterization match the field and laboratory measurements well. It is shown that the drag coefficient increases with the increasing wind speed under low and moderate wind speed conditions, and then decreases with increasing wind speed, due to the effect of sea foam under high wind speed conditions. The maximum values of the drag coefficient are reached when the 10 m wind speeds are in the range of 30–35 m/s.


Author(s):  
B E A Fisher

An assessment of the effects of visible cooling tower plumes on the local environment can be a necessary part of any proposal for a new large industrial process. Predictions of the dispersion of plumes from cooling towers are based on methods developed for chimney emissions. However, the kinds of criteria used to judge the acceptability of cooling tower plumes are different from those used for stack plumes. The frequency of long elevated plumes and the frequency of ground fogging are the two main issues. It is shown that events associated with significant plume visibility are dependent both on the operating characteristics of the tower and on the occurrence of certain meteorological conditions. The dependence on atmospheric conditions is shown to be fairly complex and simple performance criteria based on the exit conditions from the tower are not sufficient for assessments.


Sign in / Sign up

Export Citation Format

Share Document