STUDIES ON THERMAL METHODS OF MEASURING THE HOLDING TIME IN HIGH-TEMPERATURE SHORT-TIME PASTEURIZERS

1953 ◽  
Vol 16 (1) ◽  
pp. 15-25 ◽  
Author(s):  
W. K. Jordan ◽  
R. F. Holland

Data are presented on the properties of thermal waves produced by several means of suddenly increasing or decreasing the temperature of the fluid moving through the holding tube of a high-temperature short-time pasteurizer. Thermal holding-time measurements made with eight instruments or methods are compared with the holding time measured by the 3-A standard salt test. The reasons for variation in the correction factor, the difference beween the holding times measured by the salt test and a thermal test, are discussed.

Foods ◽  
2019 ◽  
Vol 8 (9) ◽  
pp. 367 ◽  
Author(s):  
Laura Sáez ◽  
Eoin Murphy ◽  
Richard J. FitzGerald ◽  
Phil Kelly

Tryptic hydrolysis of whey protein isolate under specific incubation conditions including a relatively high enzyme:substrate (E:S) ratio of 1:10 is known to preferentially hydrolyse β-lactoglobulin (β-LG), while retaining the other major whey protein fraction, i.e., α-lactalbumin (α-LA) mainly intact. An objective of the present work was to explore the effects of reducing E:S (1:10, 1:30, 1:50, 1:100) on the selective hydrolysis of β-LG by trypsin at pH 8.5 and 25 °C in a 5% (w/v) WPI solution during incubation periods ranging from 1 to 7 h. In addition, the use of a pilot-scale continuous high-temperature, short-time (HTST) heat exchanger with an extended holding time (EHT) of 5 min as a means of inactivating trypsin to terminate hydrolysis was compared with laboratory-based acidification to <pH 3 by the addition of HCl, and batch sample heating in a water bath at 85 °C. An E:S of 1:10 resulted in 100% and 30% of β-LG and α-LA hydrolysis, respectively, after 3 h, while an E:S reduction to 1:30 and 1:50 led >90% β-LG hydrolysis after respective incubation periods of 4 and 6 h, with <5% hydrolysis of α-LA in the case of 1:50. Continuous HTST-EHT treatment was shown to be an effective inactivation process allowing for the maintenance of substrate selectivity. However, HTST-EHT heating resulted in protein aggregation, which negatively impacts the downstream recovery of intact α-LA. An optimum E:S was determined to be 1:50, with an incubation time ranging from 3 h to 7 h leading to 90% β-LG hydrolysis and minimal degradation of α-LA. Alternative batch heating by means of a water bath to inactivate trypsin caused considerable digestion of α-LA, while acidification to <pH 3.0 restricted subsequent functional applications of the protein.


1991 ◽  
Vol 54 (1) ◽  
pp. 12-14 ◽  
Author(s):  
JOE G. BRADSHAW ◽  
JAMES T. PEELER ◽  
ROBERT M. TWEDT

The thermal resistance of one strain each of Listeria ivanovii, L. seeligeri, and L. welshimeri and three L. monocytogenes strains was determined in raw and sterile milk. Listeria spp. suspended in milk at concentrations of 1 × 105 cells/ml were heated at temperatures ranging from 52.2 to 71.1°C for various contact times. The heat resistance of L. monocytogenes appeared somewhat greater than that of the other Listeria spp. in both milks, but the difference was not statistically significant (α = 0.05). High-temperature, short-time processing is adequate for pasteurization of raw milk.


2002 ◽  
Vol 68 (2) ◽  
pp. 602-607 ◽  
Author(s):  
Irene R. Grant ◽  
Edward I. Hitchings ◽  
Alan McCartney ◽  
Fiona Ferguson ◽  
Michael T. Rowe

ABSTRACT Raw cows' milk naturally infected with Mycobacterium paratuberculosis was pasteurized with an APV HXP commercial-scale pasteurizer (capacity 2,000 liters/h) on 12 separate occasions. On each processing occasion, milk was subjected to four different pasteurization treatments, viz., 73�C for 15 s or 25 s with and without prior homogenization (2,500 lb/in2 in two stages), in an APV Manton Gaulin KF6 homogenizer. Raw and pasteurized milk samples were tested for M. paratuberculosis by immunomagnetic separation (IMS)-PCR (to detect the presence of bacteria) and culture after decontamination with 0.75% (wt/vol) cetylpyridinium chloride for 5 h (to confirm bacterial viability). On 10 of the 12 processing occasions, M. paratuberculosis was detectable by IMS-PCR, culture, or both in either raw or pasteurized milk. Overall, viable M. paratuberculosis was cultured from 4 (6.7%) of 60 raw and 10 (6.9%) of 144 pasteurized milk samples. On one processing day, in particular, M. paratuberculosis appeared to have been present in greater abundance in the source raw milk (evidenced by more culture positives and stronger PCR signals), and on this occasion, surviving M. paratuberculosis bacteria were isolated from milk processed by all four heat treatments, i.e., 73�C for 15 and 25 s with and without prior homogenization. On one other occasion, surviving M. paratuberculosis bacteria were isolated from an unhomogenized milk sample that had been heat treated at 73�C for 25 s. Results suggested that homogenization increases the lethality of subsequent heat treatment to some extent with respect to M. paratuberculosis, but the extended 25-s holding time at 73�C was found to be no more effective at killing M. paratuberculosis than the standard 15-s holding time. This study provides clear evidence that M. paratuberculosis bacteria in naturally infected milk are capable of surviving commercial high-temperature, short-time pasteurization if they are present in raw milk in sufficient numbers.


2016 ◽  
Vol 37 (5Supl2) ◽  
pp. 3727
Author(s):  
Leandro Ribeiro ◽  
Maurício Roberto Tosti Narciso ◽  
Tatiane Hoshida Felipe ◽  
Karina Ramirez Starikoff ◽  
Gisele Oliveira de Souza ◽  
...  

Parameters for milk pasteurization were established a long time ago, considering the thermal resistance of Mycobacterium bovis, and the systematic adoption of this process has drastically reduced the incidence of human tuberculosis caused by this pathogen. However, more recently, molecular methods have allowed the identification of genetic variations in this bacterium that may lead to greater thermal resistance. The aim of this study was to investigate whether genetic variation leads to variation in the death pattern of this bacterium during the milk pasteurization process. Samples of UHT (ultra-high temperature)-treated whole milk were artificially contaminated with four different Mycobacterium bovis spoligotypes and were subjected to pasteurization by low-temperature long-time (LTLT) and high-temperature short-time (HTST) treatments. The M. bovis spoligotypes were quantified (Colony Forming Unit per milliliter of milk) before and during the thermal process. The decay of the pathogen was quantified by calculating the difference between the measurements at the beginning and at the end of the thermal treatment. The data demonstrated that the LTLT and HTST pasteurization processes considerably reduced the M. bovis load in the milk; however, the bacterium was not eliminated. There was no difference in the thermal resistance of the spoligotypes tested or in the efficiency of pasteurization processes (LTLT versus HTST). However, heating phase was more effective in reducing the M. bovis load than the target temperature maintenance phase.


2020 ◽  
Vol 328 ◽  
pp. 127126 ◽  
Author(s):  
Stefano Nebbia ◽  
Marzia Giribaldi ◽  
Laura Cavallarin ◽  
Enrico Bertino ◽  
Alessandra Coscia ◽  
...  

Life ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 114
Author(s):  
Diana Escuder-Vieco ◽  
Juan M. Rodríguez ◽  
Irene Espinosa-Martos ◽  
Nieves Corzo ◽  
Antonia Montilla ◽  
...  

Holder pasteurization (HoP; 62.5 °C, 30 min) is commonly used to ensure the microbiological safety of donor human milk (DHM) but diminishes its nutritional properties. A high-temperature short-time (HTST) system was designed as an alternative for human milk banks. The objective of this study was to evaluate the effect of this HTST system on different nutrients and the bile salt stimulated lipase (BSSL) activity of DHM. DHM was processed in the HTST system and by standard HoP. Macronutrients were measured with a mid-infrared analyzer. Lactose, glucose, myo-inositol, vitamins and lipids were assayed using chromatographic techniques. BSSL activity was determined using a kit. The duration of HTST treatment had a greater influence on the nutrient composition of DHM than did the tested temperature. The lactose concentration and the percentage of phospholipids and PUFAs were higher in HTST-treated than in raw DHM, while the fat concentration and the percentage of monoacylglycerides and SFAs were lower. Other nutrients did not change after HTST processing. The retained BSSL activity was higher after short HTST treatment than that following HoP. Overall, HTST treatment resulted in better preservation of the nutritional quality of DHM than HoP because relevant thermosensitive components (phospholipids, PUFAs, and BSSL) were less affected.


1999 ◽  
Vol 62 (8) ◽  
pp. 861-866 ◽  
Author(s):  
PUNIDADAS PIYASENA ◽  
ROBIN C. McKELLAR

Mathematical models describing the thermal inactivation of γ-glutamyl transpeptidase (TP) and Listeria innocua in milk during high-temperature short-time (HTST) pasteurization were validated with data from TP, L. innocua, and L. monocytogenes trials in guar gum–milk. Holding tube times were determined for turbulent flow using water, and for laminar flow using a guar gum (0.27% wt/wt)–sucrose (5.3% wt/wt)–water mixture. Inactivation of TP and L. innocua was lower in a solution of guar gum (0.25% wt/wt) in whole milk than was predicted by models derived from studies with whole milk alone. Use of laminar flow timings improved model fit but did not completely account for the observed protective effect. L. monocytogenes survival was close to that predicted by the L. innocua model, although some protection was afforded this pathogen under laminar flow. Considerable intertrial variability was noted for L. monocytogenes. Risk analysis simulations using @RISK, a Lotus 1-2–3W add-in, were used to account for intertrial variability. Simulated log10 %reductions consistently underpredicted experimental L. monocytogenes survival (fail-safe), thus the L. innocua model derived in milk is suitable for estimating L. monocytogenes survival in viscous products. Increased thermal tolerance during laminar flow may be attributed to the protective effect of stabilizer.


Sign in / Sign up

Export Citation Format

Share Document