scholarly journals Numerical Investigation of Oil Gas Separation with the Use of VOF CFD

2021 ◽  
Vol 11 (6) ◽  
pp. 7841-7845
Author(s):  
S. Tomescu ◽  
I. O. Bucur
Keyword(s):  
Porous Media ◽  
Numerical Investigation ◽  
Gas Turbines ◽  
Computer Aided Design ◽  
Volume Fraction ◽  
Numerical Study ◽  
Computational Domain ◽  
Two Phase ◽  
Volume Porosity ◽  
Set Up

In this research paper, a numerical study regarding gas-oil separation is presented. Employing the geometry of a classic separator used by the NRDI for Gas Turbines COMOTI and a Computer-Aided Design (CAD) software, the computational domain was defined. To perform the Computational Fluid Dynamics (CFD) investigation, the mesh was created with the ANSYS Meshing tool, and the ANSYS CFX was employed as a solver. The computational domain was split into 5 subdomains, 3 were fluid and 2 were defined as porous media. The volume porosity, loss model, and permeability were set up. In terms of turbulence flow, the standard k–ε model was adopted. The results of the numerical calculations in terms of oil volume fraction and streamline profiles were used to analyze the separator configuration. The results show that the numerical investigation with the VOF (Volume of Fluid Method) - CFD model is capable of analyzing the performance of a two-phase separator equipped with two demisters-porous media.

scholarly journals Numerical Study of the Effect of Magnetic Field on Nanofluid Heat Transfer in Metal Foam Environment

Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-14
Author(s):  
Hamid Shafiee ◽  
Elaheh NikzadehAbbasi ◽  
Majid Soltani
Keyword(s):  
Magnetic Field ◽  
Heat Transfer ◽  
Porous Medium ◽  
Porous Media ◽  
Fluid Flow ◽  
Volume Fraction ◽  
Numerical Study ◽  
Computational Simulation ◽  
Thermodynamic Efficiency ◽  
Two Phase

The magnetic field can act as a suitable control parameter for heat transfer and fluid flow. It can also be used to maximize thermodynamic efficiency in a variety of fields. Nanofluids and porous media are common methods to increase heat transfer. In addition to improving heat transfer, porous media can increase pressure drop. This research is a computational simulation of the impacts of a magnetic field induced into a cylinder in a porous medium for a volume fraction of 0.2 water/Al2O3 nanofluid with a diameter of 10 μm inside the cylinder. For a wide variety of controlling parameters, simulations have been made. The fluid flow in the porous medium is explained using the Darcy-Brinkman-Forchheimer equation, and the nanofluid flow is represented utilizing a two-phase mixed approach as a two-phase flow. In addition, simulations were run in a slow flow state using the finite volume method. The mean Nusselt number and performance evaluation criteria (PEC) were studied for different Darcy and Hartmann numbers. The results show that the amount of heat transfer coefficient increases with increasing the number of Hartmann and Darcy. In addition, the composition of the nanofluid in the base fluid enhanced the PEC in all instances. Furthermore, the PEC has gained its highest value at the conditions relating to the permeable porous medium.

scholarly journals Numerical Study on an Interface Compression Method for the Volume of Fluid Approach

Fluids ◽  
2021 ◽  
Vol 6 (2) ◽  
pp. 80
Author(s):  
Yuria Okagaki ◽  
Taisuke Yonomoto ◽  
Masahiro Ishigaki ◽  
Yoshiyasu Hirose
Keyword(s):  
Linear Theory ◽  
Volume Fraction ◽  
Numerical Study ◽  
Volume Of Fluid ◽  
Interfacial Wave ◽  
Validation Process ◽  
Two Phase ◽  
Numerical Diffusion ◽  
Mesh Resolution ◽  
Water Reactors

Many thermohydraulic issues about the safety of light water reactors are related to complicated two-phase flow phenomena. In these phenomena, computational fluid dynamics (CFD) analysis using the volume of fluid (VOF) method causes numerical diffusion generated by the first-order upwind scheme used in the convection term of the volume fraction equation. Thus, in this study, we focused on an interface compression (IC) method for such a VOF approach; this technique prevents numerical diffusion issues and maintains boundedness and conservation with negative diffusion. First, on a sufficiently high mesh resolution and without the IC method, the validation process was considered by comparing the amplitude growth of the interfacial wave between a two-dimensional gas sheet and a quiescent liquid using the linear theory. The disturbance growth rates were consistent with the linear theory, and the validation process was considered appropriate. Then, this validation process confirmed the effects of the IC method on numerical diffusion, and we derived the optimum value of the IC coefficient, which is the parameter that controls the numerical diffusion.

Numerical study on two-phase flow through fractured porous media

2011 ◽  
Vol 54 (9) ◽  
pp. 2412-2420 ◽  
Author(s):  
ZhaoQin Huang ◽  
Jun Yao ◽  
YueYing Wang ◽  
Ke Tao
Keyword(s):  
Porous Media ◽  
Two Phase Flow ◽  
Numerical Study ◽  
Fractured Porous Media ◽  
Phase Flow ◽  
Two Phase ◽  
Flow Through

scholarly journals Simulation of the Effect of Oil Volume Fractions in an Oil-Water Flows Along a Circular Pipe: A Finite Element Approach

2018 ◽  
Vol 10 (5) ◽  
pp. 19
Author(s):  
Ferdusee Akter ◽  
Md. Bhuyan ◽  
Ujjwal Deb
Keyword(s):  
Finite Element ◽  
Volume Fraction ◽  
Fluid Velocity ◽  
Galerkin Approximation ◽  
Computational Domain ◽  
Two Phase Flows ◽  
Two Phase ◽  
Volume Fractions ◽  
Oil In Water ◽  
Element Approach

Two phase flows in pipelines are very common in industries for the oil transportations. The aim of our work is to observe the effect of oil volume fraction in the oil in water two phase flows. The study has been accomplished using a computational model which is based on a Finite Element Method (FEM) named Galerkin approximation. The velocity profiles and volume fractions are performed by numerical simulations and we have considered the COMSOL Multiphysics Software version 4.2a for our simulation. The computational domain is 8m in length and 0.05m in radius. The results show that the velocity of the mixture decreases as the oil volume fraction increases. It should be noted that if we gradually increase the volume fractions of oil, the fluid velocity also changes and the saturated level of the volume fraction is 22.3%.

Numerical Simulation of Black Liquor Spray Characteristics

2002 ◽  
Author(s):  
Thomas D. Foust ◽  
Kurt D. Hamman ◽  
Brent A. Detering
Keyword(s):  
Droplet Size ◽  
Volume Fraction ◽  
Numerical Study ◽  
Black Liquor ◽  
Flow Distribution ◽  
Physical Models ◽  
Spray Characteristics ◽  
Two Phase ◽  
Vof Model ◽  
Sheet Breakup

The performance and capacity of Kraft recovery boilers is sensitive to black liquor velocity, droplet size and flow distribution in the furnace. Studies have shown that controlling droplet size and flow distribution improves boiler efficiency while allowing increased flight drying and devolatilization, and decreased carryover. The purpose of this study is to develop a robust two-phase numerical model to predict black liquor splashplate nozzle spray characteristics. A three-dimensional time dependent numerical study of black liquor sheet formation and sheet breakup is described. The volume of fluid (VOF) model is used to simulate flow through the splashplate nozzle up to initial sheet breakup and droplet formation. The VOF model solves the conservation equations of volume fraction and momentum utilizing the finite volume technique. Black liquor velocity, droplet size and flow distribution over a range of operating parameters are simulated using scaled physical models of splashplate nozzles. The VOF model is compared to results from a flow visualization experiment and experimental data found in the literature. The details of the simulation and experimental results are presented.

scholarly journals Numerical Study of Laminar Forced Convection of Water/Al2o3 Nanofluid in an Annulus with Constant Wall Temperature

2013 ◽  
Vol 14 (1) ◽  
Author(s):  
Amin Kashani ◽  
Davood Jalali-vahid ◽  
Siamak Hossainpour
Keyword(s):  
Heat Transfer ◽  
Forced Convection ◽  
Volume Concentration ◽  
Volume Fraction ◽  
Numerical Study ◽  
Flow Behavior ◽  
Convective Heat Transfer Coefficient ◽  
Two Phase ◽  
Constant Wall Temperature ◽  
Laminar Forced Convection

Laminar forced convection of a nanofluid consisting of water and Al2O3 in a horizontal annulus has been studied numerically. Two-phase mixture model has been used to investigate thermal behaviors of the nanofluid over constant temperature thermal boundary condition and with different volume concentration of nanoparticles. Comparisons with previously published experimental and analytical works on flow behavior in horizontal annulus show good agreements between the results as volume fraction is zero. In general convective heat transfer coefficient increases with nanoparticle concentration. ABSTRAK: Kertaskerja ini mengkaji secara numerik olakan paksa bendalir lamina yang menganduangi air dan Al2O3 didalam anulus mendatar. Model campuran dua fasa digunakan bagi mengkaji tingkah laku haba bendalir nano pada keadaan suhu malar dengan kepekatan nanopartikel berbeza. Perbandingan dengan karya eksperimen dan analitikal yang telah diterbitkan menunjukkan bahawa kelakuan aliran didalm anulus mendatar adalah baik apabila pecahan isipadu adalah sifar. Pada amnya, pekali pemindahan haba olakan meningkat dengan kepekatan nanopartikel. KEYWORDS: nanofluid; volume concentration; heat transfer enhancement; laminar flow convection; annulus

Numerical Study on the Mechanism of Heat Transfer Enhancement in Fe3O4 Nanoferrofluids With Magnetic Field

2019 ◽  
Author(s):  
Chenfei Wang ◽  
Dongdong Gao ◽  
Minli Bai ◽  
Peng Wang ◽  
Yubai Li
Keyword(s):  
Magnetic Field ◽  
Heat Transfer ◽  
Convective Heat Transfer ◽  
Convective Heat ◽  
Fe3o4 Nanoparticles ◽  
Volume Fraction ◽  
Numerical Study ◽  
Transfer Coefficients ◽  
Two Phase ◽  
Enhancement Of Heat Transfer

Abstract Nanofluids is reported to significantly enhance heat transfer but with little cost of pressure loss. To further the enhancement of heat transfer using Fe3O4 nanofluids, a magnetic field is employed to control the trajectory of Fe3O4 nanoparticles. A numerical study is conducted with commercial soft ANSYS FLUENT and the simulations are done with a two-phase flow approach named Euler-Lagrange. By comparing heat transfer of laminar flow in a horizontal tube with magnetic field or not, various volume fraction (0.5%/2%) and Reynolds numbers (Re = 200–1000) are considered. Results show that magnetic field contributes an average 4% promotion in convective heat transfer coefficients compared with the condition of no magnet. The mechanism of the enhancement of heat transfer with magnetic field is explored based on the analysis of velocity field. Fe3O4 Nanoparticles move up and down under the magnetic force, and convective heat transfer is enhanced because of the disturbance of the Fe3O4 nanoparticles. Slip flow between the base fluid and nanoparticles also contributes to the enhancement of heat transfer.

Numerical Study of Laminar Mixed Convection of a Nanofluid in a Horizontal Curved Tube with Constant Heat Flux and Mass Flow Rate

2011 ◽  
Vol 110-116 ◽  
pp. 3657-3662
Author(s):  
S. Alikhani ◽  
A. Behzadmehr ◽  
S. Mirmasoumi
Keyword(s):  
Heat Flux ◽  
Mixed Convection ◽  
Mass Flow Rate ◽  
Mass Flow ◽  
Flow Rate ◽  
Volume Fraction ◽  
Numerical Study ◽  
Two Phase ◽  
Curved Tube ◽  
Laminar Mixed Convection

Fully developed laminar mixed convection of a nanofluid (water/Al2O3) in a horizontal curved tube is numerically investigated. Three-dimensional elliptic governing equations have been solved to show how nanoparticle concentration affects on thermal and hydrodynamic parameters while these parameters are impressed by centrifugal and buoyancy forces under constant mass flow rate and heat flux. Comparisons with previously published experimental works on horizontal curved tubes show good agreements between the results. Results which are obtained using the two – phase mixture model indicate that adding the nanoparticles causes changes in the properties of nanofluid and finally increases the temperature of the flow. Furthermore, increasing nanoparticles volume fraction at first augments the heat transfer coefficient of nanofluid and then, for higher concentration of particles, decreases this thermal parameter of nanofluid.

Experimental and Numerical Study of Compositional Two-Phase Displacements in Layered Porous Media

2011 ◽  
Author(s):  
Mohammed AlHamdan ◽  
Yildiray Cinar ◽  
Vural Sander Suicmez ◽  
Birol Dindoruk
Keyword(s):  
Porous Media ◽  
Numerical Study ◽  
Two Phase ◽  
Layered Porous Media
Sign in / Sign up

Export Citation Format

Share Document