scholarly journals PROPAGATION OF WIND WAVES ON TIDES

1988 ◽  
Vol 1 (21) ◽  
pp. 36 ◽  
Author(s):  
Hendrick L. Tolman

Effects of instationary depths and currents in tides on shelf seas on wind wave propagation are investigated using two numerical models in two academical situations representing shelf sea conditions. It is shown that changes in absolute frequency, which are induced by the instationarity of depth and current, are significant in contrast to what is usually assumed. If these changes are neglected large and unpredictable errors may occur in calculated changes of wavenumber and amplitude.

Author(s):  
Tom P Rippeth

Although continental shelf seas make up a relatively small fraction ( ca 7%) of the world ocean's surface, they are thought to contribute significantly (20–50% of the total) to the open-ocean carbon dioxide storage through processes collectively known as the shelf sea pump. The global significance of these processes is determined by the vertical mixing, which drives the net CO 2 drawdown (which can occur only in stratified water). In this paper, we focus on identifying the processes that are responsible for mixing across the thermocline in seasonally stratified shelf seas. We present evidence that shear instability and internal wave breaking are largely responsible for thermocline mixing, a clear development from the first-order paradigm for the water column structure in continental shelf seas. The levels of dissipation observed are quantitatively consistent with the observed dissipation rates of the internal tide and near-inertial oscillations. It is perhaps because these processes make such a small contribution to the total energy dissipated in shelf seas that they are not well represented in current state-of-the-art numerical models of continental shelf seas. The results thus present a clear challenge to oceanographic models.


Author(s):  
Alex Ayet ◽  
Bertrand Chapron

AbstractWhen wind blows over the ocean, short wind-waves (of wavelength smaller than 10 m) are generated, rapidly reaching an equilibrium with the overlying turbulence (at heights lower than 10 m). Understanding this equilibrium is key to many applications since it determines (i) air–sea fluxes of heat, momentum and gas, essential for numerical models; (ii) energy loss from wind to waves, which regulates how swell is generated and how energy is transferred to the ocean mixed layer and; (iii) the ocean surface roughness, visible from remote sensing measurements. Here we review phenomenological models describing this equilibrium: these models couple a turbulence kinetic energy and wave action budget through several wave-growth processes, including airflow separation events induced by breaking waves. Even though the models aim at reproducing measurements of air–sea fluxes and wave growth, some of the observed variability is still unexplained. Hence, after reviewing several state-of-the-art phenomenological models, we discuss recent numerical experiments in order to provide hints about future improvements. We suggest three main directions, which should be addressed both through dedicated experiments and theory: (i) a better quantification of the variability wind-wave growth and of the role played by the modulation of short and breaking wind-waves by long wind-waves; (ii) an improved understanding of the imprint of wind-waves on turbulent coherent structures and; (iii) a quantification of the interscale interactions for a realistic wind-wave sea, where wind-and-wave coupling processes coexist at multiple time and space scales.


2021 ◽  
Vol 11 (12) ◽  
pp. 5638
Author(s):  
Selahattin Kocaman ◽  
Stefania Evangelista ◽  
Hasan Guzel ◽  
Kaan Dal ◽  
Ada Yilmaz ◽  
...  

Dam-break flood waves represent a severe threat to people and properties located in downstream regions. Although dam failure has been among the main subjects investigated in academia, little effort has been made toward investigating wave propagation under the influence of tailwater depth. This work presents three-dimensional (3D) numerical simulations of laboratory experiments of dam-breaks with tailwater performed at the Laboratory of Hydraulics of Iskenderun Technical University, Turkey. The dam-break wave was generated by the instantaneous removal of a sluice gate positioned at the center of a transversal wall forming the reservoir. Specifically, in order to understand the influence of tailwater level on wave propagation, three tests were conducted under the conditions of dry and wet downstream bottom with two different tailwater depths, respectively. The present research analyzes the propagation of the positive and negative wave originated by the dam-break, as well as the wave reflection against the channel’s downstream closed boundary. Digital image processing was used to track water surface patterns, and ultrasonic sensors were positioned at five different locations along the channel in order to obtain water stage hydrographs. Laboratory measurements were compared against the numerical results obtained through FLOW-3D commercial software, solving the 3D Reynolds-Averaged Navier–Stokes (RANS) with the k-ε turbulence model for closure, and Shallow Water Equations (SWEs). The comparison achieved a reasonable agreement with both numerical models, although the RANS showed in general, as expected, a better performance.


2017 ◽  
Vol 34 (10) ◽  
pp. 2129-2139 ◽  
Author(s):  
Naohisa Takagaki ◽  
Satoru Komori ◽  
Mizuki Ishida ◽  
Koji Iwano ◽  
Ryoichi Kurose ◽  
...  

AbstractIt is important to develop a wave-generation method for extending the fetch in laboratory experiments, because previous laboratory studies were limited to the fetch shorter than several dozen meters. A new wave-generation method is proposed for generating wind waves under long-fetch conditions in a wind-wave tank, using a programmable irregular-wave generator. This new method is named a loop-type wave-generation method (LTWGM), because the waves with wave characteristics close to the wind waves measured at the end of the tank are reproduced at the entrance of the tank by the programmable irregular-wave generator and the mechanical wave generation is repeated at the entrance in order to increase the fetch. Water-level fluctuation is measured at both normal and extremely high wind speeds using resistance-type wave gauges. The results show that, at both wind speeds, LTWGM can produce wind waves with long fetches exceeding the length of the wind-wave tank. It is observed that the spectrum of wind waves with a long fetch reproduced by a wave generator is consistent with that of pure wind-driven waves without a wave generator. The fetch laws between the significant wave height and the peak frequency are also confirmed for the wind waves under long-fetch conditions. This implies that the ideal wind waves under long-fetch conditions can be reproduced using LTWGM with the programmable irregular-wave generator.


1988 ◽  
Vol 1 (21) ◽  
pp. 30 ◽  
Author(s):  
J.A. Vogel ◽  
A.C. Radder ◽  
J.H. De Reus

The performance of two numerical wave propagation models has been investigated by comparison with field data. The first model is a refractiondiffraction model based on the parabolic equation method. The second is a refraction model based on the wave action equation, using a regular grid. Two field situations, viz. a tidal inlet and a river estuary along the Dutch coast, were used to determine the influence of the local wind on waves behind an island and a breaker zone. It may be concluded from the results of the computations and measurements that a much better agreement is obtained when wave growth due to wind is properly accounted for in the numerical models. In complicated coastal areas the models perform well for both engineering and research purposes.


2021 ◽  
Vol 14 (10) ◽  
pp. 6177-6195
Author(s):  
Paul R. Halloran ◽  
Jennifer K. McWhorter ◽  
Beatriz Arellano Nava ◽  
Robert Marsh ◽  
William Skirving

Abstract. The marine impacts of climate change on our societies will be largely felt through coastal waters and shelf seas. These impacts involve sectors as diverse as tourism, fisheries and energy production. Projections of future marine climate change come from global models. Modelling at the global scale is required to capture the feedbacks and large-scale transport of physical properties such as heat, which occur within the climate system, but global models currently cannot provide detail in the shelf seas. Version 2 of the regional implementation of the Shelf Sea Physics and Primary Production (S2P3-R v2.0) model bridges the gap between global projections and local shelf-sea impacts. S2P3-R v2.0 is a highly simplified coastal shelf model, computationally efficient enough to be run across the shelf seas of the whole globe. Despite the simplified nature of the model, it can display regional skill comparable to state-of-the-art models, and at the scale of the global (excluding high latitudes) shelf seas it can explain >50 % of the interannual sea surface temperature (SST) variability in ∼60 % of grid cells and >80 % of interannual variability in ∼20 % of grid cells. The model can be run at any resolution for which the input data can be supplied, without expert technical knowledge, and using a modest off-the-shelf computer. The accessibility of S2P3-R v2.0 places it within reach of an array of coastal managers and policy makers, allowing it to be run routinely once set up and evaluated for a region under expert guidance. The computational efficiency and relative scientific simplicity of the tool make it ideally suited to educational applications. S2P3-R v2.0 is set up to be driven directly with output from reanalysis products or daily atmospheric output from climate models such as those which contribute to the sixth phase of the Climate Model Intercomparison Project, making it a valuable tool for semi-dynamical downscaling of climate projections. The updates introduced into version 2.0 of this model are primarily focused around the ability to geographical relocate the model, model usability and speed but also scientific improvements. The value of this model comes from its computational efficiency, which necessitates simplicity. This simplicity leads to several limitations, which are discussed in the context of evaluation at regional and global scales.


2010 ◽  
Vol 132 (2) ◽  
Author(s):  
C. G. Giannopapa ◽  
J. M. B. Kroot ◽  
A. S. Tijsseling ◽  
M. C. M. Rutten ◽  
F. N. van de Vosse

Research on wave propagation in liquid filled vessels is often motivated by the need to understand arterial blood flows. Theoretical and experimental investigation of the propagation of waves in flexible tubes has been studied by many researchers. The analytical one-dimensional frequency domain wave theory has a great advantage of providing accurate results without the additional computational cost related to the modern time domain simulation models. For assessing the validity of analytical and numerical models, well defined in vitro experiments are of great importance. The objective of this paper is to present a frequency domain analytical model based on the one-dimensional wave propagation theory and validate it against experimental data obtained for aortic analogs. The elastic and viscoelastic properties of the wall are included in the analytical model. The pressure, volumetric flow rate, and wall distention obtained from the analytical model are compared with experimental data in two straight tubes with aortic relevance. The analytical results and the experimental measurements were found to be in good agreement when the viscoelastic properties of the wall are taken into account.


2020 ◽  
Vol 89 (sp1) ◽  
pp. 77
Author(s):  
Thondithala Ramachandran Anoop ◽  
Leela Sheela Nair ◽  
Ravindran Prasad ◽  
Srinivas Reji ◽  
Kizhur Kandathil Ramachandran ◽  
...  
Keyword(s):  

2008 ◽  
Vol 26 (11) ◽  
pp. 3557-3570 ◽  
Author(s):  
A. Belova ◽  
S. Kirkwood ◽  
D. Murtagh ◽  
N. Mitchell ◽  
W. Singer ◽  
...  

Abstract. A number of studies have shown that 5-day planetary waves modulate noctilucent clouds and the closely related Polar Mesosphere Summer Echoes (PMSE) at the summer mesopause. Summer stratospheric winds should inhibit wave propagation through the stratosphere and, although some numerical models (Geisler and Dickinson, 1976) do show a possibility for upward wave propagation, it has also been suggested that the upward propagation may in practice be confined to the winter hemisphere with horizontal propagation of the wave from the winter to the summer hemisphere at mesosphere heights causing the effects observed at the summer mesopause. It has further been proposed (Garcia et al., 2005) that 5-day planetary waves observed in the summer mesosphere could be excited in-situ by baroclinic instability in the upper mesosphere. In this study, we first extract and analyze 5-day planetary wave characteristics on a global scale in the middle atmosphere (up to 54 km in temperature, and up to 68 km in ozone concentration) using measurements by the Odin satellite for selected days during northern hemisphere summer from 2003, 2004, 2005 and 2007. Second, we show that 5-day temperature fluctuations consistent with westward-traveling 5-day waves are present at the summer mesopause, using local ground-based meteor-radar observations. Finally we examine whether any of three possible sources of the detected temperature fluctuations at the summer mesopause can be excluded: upward propagation from the stratosphere in the summer-hemisphere, horizontal propagation from the winter-hemisphere or in-situ excitation as a result of the baroclinic instability. We find that in one case, far from solstice, the baroclinic instability is unlikely to be involved. In one further case, close to solstice, upward propagation in the same hemisphere seems to be ruled out. In all other cases, all or any of the three proposed mechanisms are consistent with the observations.


Sign in / Sign up

Export Citation Format

Share Document