Halide (X = I, Br, Cl) Doping to Tune the Electronic Structure for Conversion of Pb0.6Sn0.4Te into a High Performing Thermoelectric Material

Fabrication of thermoelectric (TE) device requires both p and n type legs with comparable performances. Pb0.6Sn0.4Te which belongs to the class of topological crystalline insulator (TCI) has a potential to...

Thermoelectric transport in conductive poly(3,4-ethylenedioxythiophene)

Poly(3,4-ethylenedioxythiophene) (PEDOT) has proved its quite competitive thermoelectric properties in flexible electronics with its excellent electrical and mechanical properties. Since the early discovery of PEDOT, considerable experimental progress has been achieved in optimizing and improving thermoelectric properties as a promising organic thermoelectric material (OTE). Among them, theoretical research has made significant contributions to its development. Here the basic physics of conductive PEDOT are reviewed based on the combination of theory and experiment. Its purpose is to provide a new insight into the development of PEDOT, so as to effectively design and preparation of advanced thermoelectric PEDOT material in the future.

Regularities of Structure Formation in 30 mm Rods of Thermoelectric Material during Hot Extrusion

In this study, Ingots of (Bi, Sb)2Te3 thermoelectric material with p-type conductivity have been obtained by hot extrusion. The main regularities of hot extrusion of 30 mm rods have been analyzed with the aid of a mathematical simulation on the basis of the joint use of elastic-plastic body approximations. The phase composition, texture and microstructure of the (Bi, Sb)2Te3 solid solutions have been studied using X-ray diffraction and scanning electron microscopy. The thermoelectric properties have been studied using the Harman method. We show that extrusion through a 30 mm diameter die produces a homogeneous strain. The extruded specimens exhibit a fine-grained structure and a clear axial texture in which the cleavage planes are parallel to the extrusion axis. The quantity of defects in the grains of the (Bi, Sb)2Te3 thermoelectric material decreases with an increase in the extrusion rate. An increase in the extrusion temperature leads to a decrease in the Seebeck coefficient and an increase in the electrical conductivity. The specimens extruded at 450 °C and a 0.5 mm/min extrusion rate have the highest thermoelectric figure of merit (Z = 3.2 × 10−3 K−1).