Development and Application of Internal Circulating Water-cooled Electromagnetic Separator

For dusty and explosive use environment, especially in coal mines, mostly self-cooled and water-cooled electromagnetic iron separators are used. This article introduces the application of water cooling internal circulation technology to electromagnetic separator equipment for the first time, the advantages and disadvantages of the three cooling methods as well as the development process and application prospects of the internal circulating water-cooled electromagnetic separator are introduced and analyzed respectively.

Study on the Mercury Migration in Clinker-Producing

Mercury is one most important global pollutants in the environment. The article studied the mercury migration according to the mercury migration in the cement process, in which a model for the relationship between the mercury input, internal circulation and output is built. In the model, mercury concentration in each stage of the process was calculated and characterized with different input, which were Consistent with actual verification, and then the reasonable method was advised to prevent the mercury pollution. The simulation showed that the mercury input is below 0.1g/t.cli, and the mercury gas emission concentration is below 0.05 mg/Nm3 whenever the mode of raw mill is on or off. But once the mercury input is over 0.23 g/t.cli, the mercury gas emission concentration is over 0.05mg/Nm3 although the mode of raw mill is on. The mercury content in ERM and KA is almost ten times higher than raw material, and the mercury content in KA is almost ten times higher than raw meal extraction, and multiples increase with higher mercury input as well. Even if mercury is continuously enriched internal, there is no limit of mercury concentration saturation.

Opportunities, Challenges and Countermeasures of SMEs Based on "Inner Cycle"

Over a long time, the development of China’s economy has always relied heavily on investment, export and consumption, or is export-oriented to promote economic growth; however, in the new world economic situation, the export has been curbed and the economic focus needs to be shifted. And China has gradually formed the awareness and strategy of attaching importance to stimulating domestic demand and expanding the domestic consumption market. Therefore, internal circulation will bring unlimited opportunities and challenges to SMEs. It is necessary for SMEs to pay attention to internal circulation and formulate corresponding countermeasures according to internal circulation policies to promote the stable and sustainable development of SMEs.

Energy and Exergy Analyses of Rice Drying in a Novel Electric Stationary Bed Grain-Drying System with Internal Circulation of the Drying Medium

In our study, we developed a system to reduce both energy consumption and pollutant discharge during the drying process. We present a new technology, a stationary bed grain-drying test device based on the internal circulation of the drying medium (ICODM). A rice-drying experiment was carried out inside of it, and the influences of air temperature (AT) and air velocity (AV) on the energy and exergy efficiencies (EEE) as well as the improvement potential rate (IPR) and the sustainability index (SI) of the rice-drying process were studied. The following conclusions were obtained: when the rice was dried at a temperature of below 55 °C and an AV across the grain layer of 0.5 m/s, the average EEE during the drying process was 48.27–72.17% and 40.27–71.07%, respectively, demonstrating an increasing trend as the drying medium temperature increased. When the rice was dried using an AV across the grain layer in the range of 0.33–0.5 m/s and a temperature of 40 °C, the two values were 39.79–73.9% and 49.66–71.04%, respectively, demonstrating a decreasing trend as the drying medium flow velocity increased. IPR and SI were 4.1–8.5 J/s and 1.9–2.7, respectively, at a drying temperature of 30–55 °C and an AV of 0.33–0.5 m/s. These conclusions can provide helpful guidance for the optimization and control of the rice-drying process in terms of saving energy.