Biomechanical analysis of two medial buttress plate fixation methods to treat Pauwels type III femoral neck fractures

Background Femoral neck fractures in young people are usually Pauwels Type III fractures. The common treatment method are multiple parallel cannulated screws or dynamic hip screw sliding compression fixation. Due to the huge shear stress, the rate of complications such as femoral head necrosis and nonunion is still high after treatment. The aim of our study was to compare the stabilities of two fixation methods in fixating pauwels type III femoral neck fractures. Methods All biomimetic fracture samples are fixed with three cannulated screws combined with a medial buttress plate. There were two fixation groups for the buttress plate and proximal fracture fragment: Group A, long screw (40 mm); Group B, short screw (6 mm). Samples were subjected to electrical strain measurement under a load of 500 N, axial stiffness was measured, and then the samples were axially loaded until failure. More than 5 mm of displacement or synthetic bone fracture was considered as construct failure. Results There were no significant differences in failure load (P = 0.669), stiffness (P = 0.842), or strain distribution (P > 0.05) between the two groups. Conclusions Unicortical short screws can provide the same stability as long screws for Pauwels Type III Femoral Neck Fractures.

Malunion fracture of supracondylar femur sinistra with post traumatic arthritis and stiffness at genu sinistra: a case report

Post-traumatic osteoarthritis could emerge immediately after an injury or one year after a bone fracture, ligament injury, and meniscal tears. In this case report, we present a 30 years old male who previously suffered from joint injury and thus lost the ability to flexion. This patient has already under went internal bone implantation surgery involving the implantation but was removed due to pain, and there was protruding implant on the left knee. On physical examination, there was varus deformity with flexion ranged between 0-5°. On radiological examination, malunion and narrowing of the joint surface were, as shown, clinically inhibit the flexion of the knee. We diagnose the patient with malunion supracondylar femur sinistra and post traumatic osteoarthritis genu sinistra. Liberation procedure (soft tissues release) and osteotomy of the distal femur were performed on this patient. On post-op radiological examination, the implant successfully widens the joint surface and holds the fracture fragment after it was reduced. The joint was immediately mobilize using the machine. It was shown that in a relatively short period, the range of motion could reach 90°. Three months post-op, evaluation was done, and it was clearly shown that the range of motion had not decreased.

Unstable odontoid fractures: technical appraisal of anterior extrapharyangeal open reduction internal fixation for irreducible unstable odontoid fractures. Patient series

BACKGROUND Displaced odontoid fractures that are irreducible with traction and have cervicomedullary compression by the displaced distal fracture fragment or deformity caused by facetal malalignment require early realignment and stabilization. Realignment with ultimate solid fracture fusion and atlantoaxial joint fusion, in some situations, are the aims of surgery. Fifteen such patients were treated with direct anterior extrapharyngeal open reduction and realignment of displaced fracture fragments with realignment of the atlantoaxial facets, followed by a variable screw placement (VSP) plate in compression mode across the fracture or anterior atlantoaxial fixation (transarticular screws or atlantoaxial plate screw construct) or both. OBSERVATIONS Anatomical realignment with rigid fixation was achieved in all patients. Fracture fusion without implant failure was observed in 100% of the patients at 6 months, with 1 unrelated mortality. Minimum follow-up has been 6 months in 14 patients and a maximum of 3 years in 4 patients, with 1 unrelated mortality. LESSONS Most irreducible unstable odontoid fractures can be anatomically realigned by anterior extrapharyngeal approach by facet joint manipulation. Plate (VSP) and screws permit rigid fixation in compression mode with 100% fusion. Any associated atlantoaxial instability can be treated from the same exposure.

Comparison of Computed Tomography, Traction, and Inverted Grayscale Radiographs for Understanding Pilon Fracture Morphology

Background: There have been no studies evaluating the usefulness of grayscale radiographs in extremity fractures. We aimed to compare the ability and reliability of traction radiographs vs traction grayscale inversion radiographs to detect fracture fragment and comminution zones in comminuted tibia pilon fractures. Methods: Plain radiographs and grayscale inversion images of 60 patients with Orthopaedic Trauma Association/AO Foundation type C3 fracture were evaluated by 20 observers (15 orthopedic surgeons and 5 radiologists) after traction had been applied. The anterolateral, posterolateral, and medial malleolar fragments, as well as the lateral, central, and medial column comminution zones, were identified by all physicians. Computed tomography scan images were used as the “gold standard” against which plain radiographs and grayscale inversion image interpretation were measured. Intra- and interobserver reliability and correct identification of fracture fragments and comminution zones were evaluated. Results: The interobserver reliability for 3 of the fracture fragments and comminution zones on the traction plain radiographs was moderate, whereas it was substantial on traction grayscale inversion radiographs. The lateral comminution zones ( P = .001) and presence or absence of posterolateral fragments ( P < .001) were significantly better identified in grayscale inversion radiographs compared to standard radiographs. Conclusion: After traction was applied, we found grayscale inversion radiographs are superior to plain radiographs in the identification of posterolateral fragment and lateral zone of comminution in comminuted intraarticular pilon fractures. Level of Evidence: III, Retrospective Case Series.

Rare Presentation of Ulnar Nerve Palsy in Closed Both Bone Forearm Fracture in Pediatric Population

Introduction:Ulnar nerve injury in closed both bone forearm fracture is rare. Most nerve injuries are neuropraxia and rarely the nerve is trapped or is transected. Most of the time recovery is spontaneous but sometimes requires surgical exploration. We are reporting a case of a 14-year-old boy with closed both bone forearm fracture with ulnar nerve palsy due to entrapment and laceration between ulnar bone fracture fragment. Case Report:A 14-year-old boy presented in emergency department elsewhere with a left forearm closed injury due to fall while playing where he was diagnosed with both bone forearm shaft fracture with ulnar nerve palsy and was given an above elbow slab. After 3 days, the patient presented to our outpatient department (OPD) with completely absent sensation over little finger, ulnar aspect of ring finger, and ulnar clawing. No signs of compartment syndrome in the form of tense swelling or stretch pain were seen. There was a suspected ulnar nerve injury for which patient was admitted and posted for fracture fixation and exploration of the nerve in emergency which showed lacerated ulnar nerve trapped in fracture fragment. Open reduction and internal fixation with ulnar plating and radius titanium elastic nailing was done by orthopedic surgeon while ulnar nerve neurolysis and micro repair was subsequently done by plastic surgeon. There was no neurological recovery immediately post-operatively. Patient was discharged after 48 h and called for regular follow-up in OPD to assess fracture union and neurological recovery. There was gradual neurological recovery over the period of time. Complete motor and sensory recovery took place in 4 months. Conclusion:Ulnar nerve injury associated with close both bone forearm fracture is uncommon. They are usually associated with a contusion for which the treatment is basically conservative. Immediate nerve exploration and fracture fixation should be reserved for suspicious nerve laceration or entrapment within displa

Extension Block Pinning versus percutaneous Fragment Reduction with a Towel Clip and extension Block Pinning with direct Pin Fixation for Treatment of Mallet Fracture

Purpose This study compared the clinical and radiographic results between extension block pinning (Group A) and percutaneous reduction of the dorsal fragment with a towel clip followed by extension block pinning with direct pin fixation (Group B) for the treatment of mallet fractures. Patients and Methods A total of 69 patients (group A = 34 patients, group B = 35 patients) who underwent operative treatment for mallet fractures from June 2008 to November 2017 with ≥ 6 months post-surgical follow-up were analysed retrospectively. The extent of subluxation of the distal interphalangeal joint, articular involvement of fracture fragment, fracture gap, and articular step-off were examined on plain radiographs before and after surgery. The functional outcomes were evaluated with the Crawford rating system. Results The postoperative step-offs were 0.16 mm in group A and 0.01 mm in group B. Group B had a significantly better anatomical outcome than group A. Five patients in group A had a loss of reduction. Among them, two had malunion and post-traumatic arthritis. Meanwhile, no patients in group B presented with loss of reduction and nonunion. The mean extension lags were 4.2° in group A and 1.6° in group B. However, functional outcome did not differ between the two groups at the final follow-up. Conclusion Fracture reduction using a towel clip and extension block pinning with direct pin insertion for mallet fracture facilitated the anatomical reduction of fragments, and allowed for stable fixation of fragments. Compared with extension block pinning technique, this technique has shown better anatomical results and stability, but not better clinical results.

Mini-Open Reduction and Extension Block Pinning for Irreducible Mallet Fractures: A Minimally Invasive Technique for Anatomical Reduction

Background: Dorsal rotation or persistent displacement of the fracture fragment is frequently encountered in extension block pinning for mallet fractures. We reviewed nine irreducible mallet fracture patients treated with mini-open reduction and extension block pinning. Methods: A small V-shaped incision was made on the fracture gap when there was persistent displacement of fracture fragment despite closed maneuvers and percutaneous procedures while performing extension block pinning. Soft tissue or granulation tissue hampering reduction was removed through the incision. Anatomical reduction was guided with a freer elevator. The incision was closed by distal interphalangeal joint transfixation in extension without any suture. Pin tips were buried under the skin. The incision and pin entry sites were covered with skin adhesive, and the patients were allowed to wash their hands 1–2 days after the surgery. No splint was applied postoperatively. Mean follow-up period was 13 months. Results: Anatomical reduction was achieved in 7 out of 9 patients. In the rest 2 patients, postoperative step-off of the articular surface at the fracture site was less than 0.5 mm. Solid union was achieved in all cases. The mean extension lag at final follow-up was 0°. No patient developed postoperative external bleeding or other complications in the incision site or the pin site. Conclusions: Mini-open reduction and extension block pinning appears to be a good option for irreducible mallet fractures, which improves reduction quality and patients’ convenience.

High Submandibular Anteroparotid Approach for Open Reduction and Internal Fixation of Condylar Fracture

Aim. There are several techniques for the treatment of mandibular condylar fractures. This is the first report of the high submandibular anteroparotid approach for open reduction and internal fixation of condylar fracture. Materials and Methods. A 41-year-old woman fell indoors and injured her face. She was referred to our department for detailed examination and treatment of a suspected mandibular fracture. X-ray and computed tomography showed a right mandibular condylar base fracture and lateral dislocation of the fracture fragment. Open reduction and internal fixation procedures were performed for a right mandibular condylar fracture under general anesthesia. The mandibular ramus was reached by approaching from the inferior margin of the mandible, delaminating the masseter fascia posteriorly, and bypassing the anterior margin of the parotid gland. Once the fractured bone was reached, reduction and fixation were performed. Results. We have achieved good results by the high submandibular anteroparotid approach, which is minimally invasive and simple, to reduce and fix condylar fractures. With this approach, no facial artery or retromandibular vein was encountered, and the mental stress for the surgeon was minimal. Postoperative wound infection, parotid gland complications such as parotitis and salivary fistula, facial nerve dysfunction such as facial paralysis, and esthetic disorders such as scarring were not observed. Conclusions. Although it is necessary to examine more cases in the future, the high submandibular anteroparotid approach may be useful as a new approach for open reduction and internal fixation of condylar fractures.

OSTEOSÍNTESIS DE FRACTURA DE ESPINA TIBIAL ASISTIDA CON ARTROSCOPÍA Y TORNILLO DE COMPRESIÓN TIPO HERBERT, REPORTE DE UN CASO Y REVISIÓN DE LITERATURA.

Introduction Tibial spine fractures have a prevalence of 3 per 100,000 people annually. High-energy trauma is the leading cause, followed by low-energy trauma and 40% by multiple trauma. Imaging studies play a crucial role in establishing the diagnosis. It is important to understand that radiography alone does not allow a correct identification of the fracture, so it is necessary to complement it with a CT or MRI scan. The Meyers-McKeever classification divides fractures by their degree of displacement and comminution into 4 types and guides us in the therapeutic decision. The management of these fractures depends on the morphology, soft tissue involvement and the general condition of the patient. Surgical treatment is primarily considered for displaced fractures. Within this approach, the arthroscopy-assisted technique has reported excellent results. with a low complication rate, compared to open techniques, despite the few studies to define the standard Gold treatment. Case description A clinical case of a 32-year-old patient with a posterior tibial spine fracture is reported, who underwent surgery with arthroscopic-assisted osteosynthesis and a 4.5 x 4.0 Herbert-type compression screw with intraoperative arthroscopic images that demonstrated the restoration of joint congruence, without menisci or ligament injury, assessing intraoperative arches of motion from 0 to 90 degrees. In his mediate postsurgical has been started isometric physiotherapy with flexion and extension of the knee from 0 to 90 degrees plus strengthening of the iliac psoas and quadriceps and resume his activities in 2 months after his surgery. Conclusion At present, there is no consensus on the optimal surgical technique due to the lack of clinical trials. More studies of higher quality and sample size are necessary to establish the Gold Standard in the treatment of tibial spine fractures. However, we found that by using Herbert-type compression screws, timely compression of the fracture fragment is achieved in the anatomical reduction. An updated review of the subject and its therapeutic management is carried out.

Biomechanical Comparison of a Novel Implant and Commercial Fixation Devices for AO/OTA 43-C1 Type Distal Tibial Fracture

This study compares the novel Asia Distal Lateral Tibial Locking Plate mechanical stability to that of the current anterolateral and medial tibial plates based on finite element analysis. Four-part fracture fragment model of the distal tibia was reconstructed using CAD software. A load was applied to simulate the swing phase of gait. The implant stress and the construct stiffness were compared. The results of the anterolateral plate and the medial plate were similar and the displacement values were determined lower than those in the medial plate. In the simulated distal tibia fracture, the Aplus Asia Distal Lateral Tibial Locking Plate and medial distal tibial plate tibia fixations will lead to a stiffer bone-implant construct compared to the anterolateral distal tibial plate. Moreover, the stress in the Aplus Asia Distal Lateral Tibial Locking Plate was lower than those for the medial distal tibial plate and anterolateral bone plates. The Aplus Asia Distal Lateral Tibial Locking Plate has better stabilization and is an anterolateral plate that avoids more soft tissue damage than other bone plates. The Aplus Asia Distal Lateral Tibial Locking Plate could be one of a suitable design in tibia distal fracture fixation.