Positive Magnetoresistance and Chiral Anomaly in Exfoliated Type-II Weyl Semimetal Td-WTe2

Layered van der Waals semimetallic Td-WTe2, exhibiting intriguing properties which include non-saturating extreme positive magnetoresistance (MR) and tunable chiral anomaly, has emerged as a model topological type-II Weyl semimetal system. Here, ∼45 nm thick mechanically exfoliated flakes of Td-WTe2 are studied via atomic force microscopy, Raman spectroscopy, low-T/high-μ0H magnetotransport measurements and optical reflectivity. The contribution of anisotropy of the Fermi liquid state to the origin of the large positive transverse MR⊥ and the signature of chiral anomaly of the type-II Weyl Fermions are reported. The samples are found to be stable in air and no oxidation or degradation of the electronic properties is observed. A transverse MR⊥∼1200 % and an average carrier mobility of 5000 cm2V−1s−1 at T=5K for an applied perpendicular field μ0H⊥=7T are established. The system follows a Fermi liquid model for T≤50K and the anisotropy of the Fermi surface is concluded to be at the origin of the observed positive MR. Optical reflectivity measurements confirm the anisotropy of the electronic behaviour. The relative orientation of the crystal axes and of the applied electric and magnetic fields is proven to determine the observed chiral anomaly in the in-plane magnetotransport. The observed chiral anomaly in the WTe2 flakes is found to persist up to T=120K, a temperature at least four times higher than the ones reported to date.

Photonic response and temperature evolution of SiO2/TiO2 multilayers

The microstructural and optical reflectivity response of photonic SiO2/TiO2 nanomultilayers have been investigated as a function of temperature and up to the material system’s melting point. The nanomultilayers exhibit high, broadband reflectivities up to 1350 °C with values that exceed 75% for a 1 μm broad wavelength range (600–1600 nm). The optimized nanometer sized, dielectric multilayers undergo phase transformations from anatase TiO2 and amorphous SiO2 to the thermodynamically stable phases, rutile and cristobalite, respectively, that alter their structural morphology from the initial multilayers to that of a scatterer. Nonetheless, they retain their photonic characteristics, when characterized on top of selected substrate foils. The thermal behavior of the nanometer sized multilayers has been investigated by differential thermal analysis (DTA) and compared to that of commercially available, mm-sized, annealed powders. The same melting reactions were observed, but the temperatures were lower for the nm-sized samples. The samples were characterized using X-ray powder diffraction before DTA and after annealing at temperatures of 1350 and 1700 °C. The microstructural evolution and phase compositions were investigated by scanning electron microscopy and energy-dispersive X-ray spectroscopy measurements. The limited mutual solubility of one material to another, in combination with the preservation of their optical reflectivity response even after annealing, makes them an interesting material system for high-temperature, photonic coatings, such as photovoltaics, aerospace re-entry and gas turbines, where ultra-high temperatures and intense thermal radiation are present.

Particle Deposition to Silica Surfaces Functionalized with Cationic Polyelectrolytes

Positively charged water-solid interfaces are prepared by adsorption of a cationic polyelectrolyte poly(diallyldimethylammonium chloride) (PDADMAC) from aqueous solutions to planar silica substrates. These substrates are characterized by atomic force microscopy (AFM), optical reflectivity, and streaming current measurements. By tuning the amount of adsorbed polyelectrolyte, the surface charge of the substrate can be systematically varied. These substrates are further used to study deposition of sulfate latex nanoparticles, which is also accomplished by optical reflectivity. This deposition process is found to be consistent with an extension of the random sequential adsorption (RSA) model in a semi-quantitative fashion. Such deposition studies were further used to ascertain that the substrates obtained by in situ and ex situ functionalization behave in an identical fashion.